Effect of flat cable to MPPC signal S. Uozumi (Kobe) Jun-6 2008 ScECAL meeting.

Slides:

Advertisements

Similar presentations

Sci-Fi tracker for IT replacement 1 Lausanne 9. December 2010.

Advertisements

1 Copyright Pericom Semiconductor 2007 Last Slide PERICOM CONFIDENTIAL INFORMATION SATA&SAS ReDriver Application Guide FAE Training Lingsan Quan Application.

CMS GEM Workshop III, April 20, 2012

Digital Power Measurements Demystified Presented by Sunrise Telecom Broadband … a step ahead.

Tagger Microscope:  Performance Features Under Test Detector Alignment  Simulations show that when fiber axis is aligned to < 3 o of the e - trajectory.

CMS WeekDec 2002E. Hazen HF Electronics Status Report E. Hazen, J. Rohlf, E. Machado Boston University.

Signal Quality Study with Triple Jumper Board and EC board to PP Cable December 2, 2004 Mitch Newcomer.

Performance of new strip scintillator Jungeun Lee, Jaeyun Choi, Kyungpook National University Minseok Park.

The following schematic displays the general setup of the Dunk Probe test. The Aluminum sample tested during this run (DSAT3) had a thickness of 200nm.

HIGH DENSITY DESIGN COMPONENT SOLUTIONS. Technology Challenges Market Drivers:  Make it smaller  Make it operate faster  Make it more efficient  Make.

Performance of the DZero Layer 0 Detector Marvin Johnson For the DZero Silicon Group.

WP7&8 Progress Report ITS Plenary meeting, 23 April 2014 LG, PK, VM, JR Objectives 2014 and current status.

6mm 【 Development of Readout Electronics for MPPC 】 We report the read out electronics of MPPC( Multi-Pixel Photon Counter ). MPPC is a new photodetector.

1 CISCO NETWORKING ACADEMY PROGRAM (CNAP) SEMESTER 1/ MODULE 4 Cable Testing.

4 Amp Load.500 Hard Line Cable SPSM 2 P/S Setup Configuration RF Signal Supplied by RG-6 RF Signal To TV via RG-6 Remove Central Fuse Move 20A fuse from.

Noise studies: hardware tests and preliminary results Anna, Anton, Giovanni, Pigi, Silvia, A. Boiano, A. Vanzanella.

MPPC R&D status Kobe Univ. CALICE collaboration meeting Yuji SUDO Univ. of Tsukuba ~ contents ~ Introduction Linearity curve Recovery time.

Setup of Gain Monitoring System with Mr. Uozumi Kobe Univ. Hiroko Ikeda 18,May 2007.

GLD Calorimeter Status Oct 学術創成会議 S. Uozumi Shinshu University FJPPL meeting held at the end of September. Preparation underway toward the ECAL.

Reports from DESY Satoru Uozumi (Staying at DESY during Nov 11 – 25) Nov-21 GLDCAL Japan-Korea meeting.

HF Cabling Upgrade Options T. Shaw 30-OCT HF 2012 Upgrade Meeting 30-OCT-10 T. Shaw.

TDS8000 and TDR Considerations to Help Solve Signal Integrity Issues.

1 Instrumentation Development Laboratory KLM Calibration Board overview Schematics layout Parts Cost.

MPPC Radiation Hardness (gamma-ray & neutron) Satoru Uozumi, Kobe University for Toshinori Ikuno, Hideki Yamazaki, and all the ScECAL group Knowing radiation.

Aras Papadelis, OTR meeting NIKHEF, June 17 th LHCb Outer Tracker Cross-talk measurements with Fe-55.

Bits (0s and 1s) need to be transmitted from one host to another. Each bit is placed on the cable as an electrical signal or pulse. On copper cable the.

The MPPC Study for the GLD Calorimeter Readout Introduction Measurement of basic characteristics –Gain, Noise Rate, Cross-talk Measurement of uniformity.

The Scintillator ECAL Beam Test at FNAL Adil Khan International Linear Collider Workshop 2010 LCWS10 & ILC10, Beijing, China CALICE Scintillator ECAL group.

HBD FEM the block diagram preamp – FEM cable Status Stuffs need to be decided….

Developing fast clock source with deterministic jitter Final review – Part A Yulia Okunev Supervisor -Yossi Hipsh HS-DSL Laboratory, Dept. of Electrical.

Future Beam Test Plans of the GLD Calorimeter Aug 学術創成会議 Satoru Uozumi (Shinshu) for the GLD calorimeter group We are planning to have two beam.

Toward the FNAL Beam Test S. Uozumi (Kobe) May Japan-Korea meeting.

Testbeam Studies of the LHCb Vertex Locator Modules Lisa Dwyer.

Design of a readout system for RPCs Olu Amoda2 The LODEN Group The group is an association of Fermilab scientists who teamed up to build a cosmic ray.

ACS STATUS Linda Smith (thanks to David Golimowski for providing the slides)

Study of the MPPC for the GLD Calorimeter readout Satoru Uozumi (Shinshu University) for the GLD Calorimeter Group May 29 – Jun 4 DESY Introduction.

1 4 PCB: LEFT TOP 115 channels, LEFT BOTTOM (115), RIGHT TOP (106), RIGHT BOTTOM (106). For LEFT TOP board 115 channels we have: 115 smd connectors (AMP.

Dual PD Amp Circuit Board Test Results By Alexa Staley LIGO G v1 1.

An Idea of Next Sci-ECAL Prototype for FNAL Beamtest Feb Sci-ECAL meeting S. Uozumi (Kobe)

CEA DSM Dapnia Sédi Streamer theory Streamer theory Protection schemes Protection schemes Some ideas Some ideas Input Protection for Gas Detector Electronic.

12 September 2006Silicon Strip Detector Readout Module J. Hoffmann SIDEREM SIlicon Strip DEtector REadout Module.

Systematics on ScECAL 1 st prototype DESY Apr , CALICE Satoru Uozumi for the CALICE collaboration NIM A, 763 (2014) 278.

ScECAL Beam FNAL Short summary & Introduction to analysis S. Uozumi Nov ScECAL meeting.

Short report on MPPC gain monitoring system S. Uozumi Jun ScECAL meeting At the FNAL BT, having the gain monitoring system for all the channel.

The 2 nd SCECAL module for the Fermilab beam test - tentative idea - S. Uozumi (Shinshu) Jun GLDCAL meeting Next beam test will be held likely.

Idea for next data taking at FNAL Dec-14 th 2008 ScECAL S. Uozumi (Kobe)

MPPC Test Setup Alam Toro S. 1. Objective Characterize main variables in ideal conditions To provide a setup to characterize multiple devices To provide.

Performance of Scintillator-Strip Electromagnetic Calorimeter for the ILC experiment Satoru Uozumi (Kobe University) for the CALICE collaboration Mar 12.

Short Summary of the Japan- Korea KNU Oct GLDCAL meeting S. Uozumi (Shinshu) 3 rd Japan-Korea joint meeting is held on Oct at Kyunpook.

MPPC mass check with relays 21/11/2006 Hidetoshi Otono(ICEPP,Tokyo)

Amperes, Volts and Ohms. We use different units to measure different things: We use different units to measure different things: Time – minutes Time –

The Scintillator-ECAL 2 nd Prototype S. Uozumi (Kobe) Jun

Upgrade of the MEG liquid xenon calorimeter with VUV-light sensitive large area SiPMs Kei Ieki for the MEG-II collaboration 1 II.

How does the type of metal affect how much current a circuit has?

SeaPerch Electrical System. Electrical System Overview Assemble the control box. Make the Cat5 connector. Wire the motors to the tether. Wire the control.

Study of the MPPC for the GLD Calorimeter Readout Satoru Uozumi (Shinshu University) for the GLD Calorimeter Group Kobe Introduction Performance.

PHOTOTUBE SCANNING SETUP AT THE UNIVERSITY OF MARYLAND Doug Roberts U of Maryland, College Park.

Basics of Bypass Capacitor, Its Functions and Applications.

Future Beam Test Plans of the Calorimeter Group Aug 学術創成会議 Satoru Uozumi (Shinshu) for the GLD calorimeter group We are planning to have two beam.

DESY BT analysis - updates - S. Uozumi Dec-12 th 2011 ScECAL meeting.

Performance of 1600-pixel MPPC for the GLD Calorimeter Readout Jan. 30(Tue.) Korea-Japan Joint Shinshu Univ. Takashi Maeda （ Univ. of Tsukuba)

Scintillator-ECAL Beam Test Scintillator-strip ECAL Beam DESY My task and achievement at DESY Contents Satoru Uozumi Shinshu University, Japan Nov-23.

SeaPerch Electrical System

ScECAL+AHCAL+TCMT Combined Beam FNAL

Open book, open notes, bring a calculator

Receiver Circuit Testing

Receiver Circuit Testing

Vereinfachung der CBM TRD Elektronik

Test of Link and Control Boards with LHC like beam, CERN, May 2003

SeaPerch Electrical System

Presentation transcript:

Effect of flat cable to MPPC signal S. Uozumi (Kobe) Jun ScECAL meeting

Readout cable Idea 1: Idea 2: Idea 3: Just adopt long flat cable with MPPC (as done in DESY BT).

Objective How the MPPC signal skewed by passing through industrial-standard FPC cables and connectors? Any reflection clearly seen? This will determine (or give a feeling) specs of our readout flat cable (inpedance, length…). Electrocal cross-talk between adjacent lines on the flat cables?

Setup 20-lines FPC cables with 15cm length 1.25mm pitch and FPC connectors are used. FPC (15 cm) Relay board MPPC Readout circuit Signal connected to Oscilloscope Through x63 amp FPC cableFPC connector

Dark noise signal with different cable length With two cables And relay board (30 cm) With one cable (15 cm)

Electrical cross-talk Signal channel Adjacent channel Amount of electrocal cross-talk on the flat cable is at least below noise level.

Conclusion Of course those checks are not perfect, but we can somehow learn : – Better to set the cable inpedance to 50ohm, even if it makes production cost ~20% higher. (it was NOT considered at the DESY BT.) – Electrical cross-talk on flat cable is not significant level. – I suppose to go ahead with idea-I, but with 50ohm flat cable, not industrial standard FPC cable. – But, if the cable length can be short enough, taking idea-3 is also possible(but with 50ohm cable).