Getting to Know Emergency Equipment Chapter 7. Objectives List the three things all newly hired lab personnel should know related to lab safety. Describe.

Slides:



Advertisements
Similar presentations
Safety Promotion Basic Health Care; HCE100.
Advertisements

Microbial Growth Kinetics
UMES Presented by Environmental Health and Safety Preston Cottman (410) Hazardous Material Spill Response Training.
Hazardous Chemical Spill Response and Containment Program
Emergency Response in Labs. Topics Addressed in this Module Overview to Emergency Response Response to Medical Emergencies Response to Fire Emergencies.
Annual Refresher Training Emergency Response. Fire Fire is the most potentially devastating emergency in the modern laboratory Use the smallest quantities.
Using Protective Equipment Chapter 4. Objectives What type of PPE is available? When and where to use PPE? The limitations of PPE.
Patterns of Inheritance
Unit 1. Lab Safety video I TO PREVENT: __________________________________________ __________________________________________ exposure to __________________________________________.
Promotion of Safety.
Review Topic: Laboratory Safety Answer the question then go to the next slide for the answer.
2.01 Understand safety procedures
The importance of energy changes and electron transfer in metabolism
SOP Standard Operating Procedure This workforce solution was funded by a grant awarded under the President’s Community-Based Job Training Grants as implemented.
Spectrophotometers and Concentration Assays
Material Safety Data Sheets
The Science of Biology Chapter 1. 2 Disclaimer This workforce solution was funded by a grant awarded under the President’s Community-Based Job Training.
BLR’s Safety Training Presentations
Green Fluorescent Protein (GFP) Purification by Chromatography
C ALCULATING M L/ HR FROM DOSAGE PER KG. 1 ST STEP First, calculate dose per minute. 3 mcg/kg/min x 95.9 kg = mcg/min.
The Behavior of Proteins: Enzymes
Transformation of bacteria with pGLO Lab 4. pGLO gene Bioluminescent jelly fish – Aequorea victoria – GFP causes fish to glow in dark Transformed E.coli.
Modes of culture for high cell densities Chapter 10 ‘The Basics’
Bringing Biotech Product to Market Chapter 9. Objectives Purifying product Define chromatography and distinguish between planar and Column chromatography.
Chemical Safety BT 202 Biotechnology Techniques II.
Brush up on Math BCTC Nursing Student Resource Center Renee Felts, RN.
BT 201 Biotechnology Techniques I
Animals Basic reference: Chapters Taxonomy: Kingdom Animalia contains well over 30 phyla basic categories: invertebrates - animals without a.
Safe handling, Storage, and Disposal of Chemicals
Initiation of Translation in Bacteria
The Science of Biology Chapter 1. 2 What are the Properties of Life? Living organisms: Cellular organization- composed of cells Ordered complexity- complex.
Control of Gene Expression Chapter Control of Gene Expression Initiation of Transcription is controlled by controlling gene expression. Regulatory.
Introduction Chapter 1.
Community ecology Chapter 56. What is a biological community? Community includes all its species living together. Community includes all its species living.
Chapter 59 Conservation Biology. Overview of Biological Crisis Extinctions of species are high – done by humans by overexploitation and habitat destruction.
The Nature of Molecules Chapter 2. 2 Why should we study atoms? Substances with mass and space – Matter All matter is composed of atoms. Understanding.
MATERIAL SAFETY DATA SHEETS (MSDS) Heather Wipijewski, CVT This workforce solution was funded by a grant awarded under the President’s Community-Based.
Spectrophotometry Lecture. Interaction of Radiation and Matter.
2 pt 3 pt 4 pt 5pt 1 pt 2 pt 3 pt 4 pt 5 pt 1 pt 2pt 3 pt 4pt 5 pt 1pt 2pt 3 pt 4 pt 5 pt 1 pt 2 pt 3 pt 4pt 5 pt 1pt DNA Biotechnolo“G ”This &That.
Safety Training Presentations
CHEMISTRY SAFETY NOTES
Work Readiness Program Willingness To Learn. Objectives Describe why an employer values an employee who expresses a willingness to learn. Describe why.
Western Blot Lab. Western Blot reagents and equipment Mini Trans-Blot Apparatus : Passes electric current horizontally through gel – forcing negatively.
Serum-Free Media Chapter 10. Change from serum to serum free media  Serum can be reduced or omitted without apparent cell selection -if appropriate nutritional.
Matter And Measurement Chapter 1 Introduction: Matter and Measurement John D. Bookstaver St. Charles Community College St. Peters, MO  2006, Prentice.
Work Readiness Program Problem Solving & Decision Making.
1. Purpose  It is the policy of the company to provide equipment necessary to prevent injury in the event of a chemical exposure. Types of hazards 
Lab Safety Mrs. Reese. Safety First  The laboratory is a place for making inquiries, the process of finding answers to questions, as safely as possible.
PART A Location of Safety Equipment in your Biology Lab.
Copyright © Business & Legal Reports, Inc. BLR’s Safety Training Presentations Hazard Communication 29 CFR
Energy What are potential and kinetic energy?. First some review… Write down the definition of energy. Write down the four of the seven types of energy.
Chapter 58 The Biosphere. Ecosystem effects on sun, wind and water Life on earth is influenced by the amount and variation of solar radiation and patterns.
Healthcare Safety and Standard Precautions Competencies 3-4.
Work Readiness Program Introduction. Objectives List reasons a person is considered a “Good Employee” List reasons a person is considered a “Good Employee”
What’s wrong with this picture? Identify the safety rules that are being followed and those being broken.
Southern Hybridization Lab. SH SH – done to know whether a specific DNA sequence is present in a DNA sample and where it is located with respect to restriction.
Cell Communication Chapter 9. 2 Cell Communication Communication between cells requires: ligand: the signaling molecule receptor protein: the molecule.
Fig Origins of Life. Page 504 Panspermia hypothesis.
Opener Chapter 24 – Genome Evolution. Comparative Genomes Powerful tool for exploring evolutionary divergence among organisms Footprints on the evolutionary.
Patterns of Inheritance Chapter Early Ideas of Heredity Before the 20 th century, 2 concepts were the basis for ideas about heredity: -heredity.
Welcome to... A Game of X’s and O’s This workforce solution was funded by a grant awarded under the President’s Community-Based Job Training Grants as.
An Introduction to Composites Technology Explore the exciting new technology and opportunities in the world of composites.
GOAL Target PLANNING –---Aim to hit the Target Preparer and Presenter: Margaret Ward “This workforce solution was funded by a grant awarded under.
The Behavior of Proteins: Enzymes, Mechanisms and Control Chapter 7.
Chapter 50 Temperature, osmotic regulation and the urinary system.
CGMPs BT 202 Biotechnology Techniques II. Food and Drug Administration Established under 1906 Pure Food and Drugs Act to prevent sale of unacceptable.
Chapter 1.  Define safety, risk, and risk assessment.  List all entities that are responsible for developing and carrying out regulations and standards.
SAFETY IN THE LABORATORY
PLACEHOLDER FOR YOUR LOGO
PLACEHOLDER FOR YOUR LOGO
Presentation transcript:

Getting to Know Emergency Equipment Chapter 7

Objectives List the three things all newly hired lab personnel should know related to lab safety. Describe the procedures that should be followed in instances of a fire, chemical splash or spill to body, and chemical spill.

Getting to Know Emergency Equipment All emergency procedures should be outlined by a Chemical Hygiene Plan -Required by OSHA -Many labs adopt additional recommendations from ANSI

Getting to Know Emergency Equipment Prior to starting work in a lab you should know the following: – how to report a fire, chemical spill, or other emergency – location of emergency equipment – location of all exits from lab

Getting to Know Emergency Equipment Types of Emergency Equipment – fire extinguishers – deluge showers and eye washes – spill kits – first aid kits

Getting to Know Emergency Equipment What to do when an emergency occurs: – notify the appropriate individuals many companies require that you contact your immediate supervisor if not explicitly stated contact emergency personnel first – tend to the injured individual may require moving them away from the hazard – confine the spill or fire if limited risk to you

Responding to fires – Fires have an ignition source, fuel, and oxidizer to start – Critical that prior to using any chemicals in the lab you refer to sections 3-6 of the MSDS for that chemical. section 5 outlines how to specifically deal with a fire

Responding to fires – First action should be to contact fire department and to sound the alarm. if you are able to put the fire out call the fire department back – Actions to put fire out Suffocating – if small enough cover with a small vessel or use a fire blanket If an individual is on fire you should have them stop, drop, and roll. – if close enough to a deluge shower can put them under it » must know what material caused the fire – no longer recommended use a fire blanket

Responding to fires – Actions to put fire out by fire extinguisher – key questions to answer prior to using a fire extinguisher » Do you have any hands-on experience? » Do you know what started the fire? » Is the fire extinguisher the proper size and type? » Is the fire extinguisher in good working order? » Do you have an exit close enough in case the fire increases? » Is the fire small enough to control with an extinguisher?

Responding to fires – Actions to put fire out by fire extinguisher – make sure it is necessary to use the extinguisher or if fire will burn out on own let it – Classes of fires » A - routine combustibles » B - flammable liquids and flammable gases » C - electrical equipment » D - flammable metals » multipurpose extinguishers exist, but remember cannot be used on metal fires

Types of Fire extinguishers – Water extinguishers » only effective on class A fires – Carbon dioxide extinguishers » effective on class B & C fires » care must be used in closed quarters – Monoammonium phosphate (MAP) » dry chemical powder extinguishers » effective class A, B, & C fires » “sticky” residue smothers fire

Questions for 30 points Why should Class A extinguishers not be used on Class B, C and D types of fires? Why Class B extinguishers cannot be used on class A and D fires? Why Class C extinguishers cannot be used on D fires? Why are K2CO3 and Na2CO3 extinguishers effective? Why can they be used on class B & C and not on class A or D fires?

Questions What are the questions you are supposed to have an answer to prior to using a fire extinguisher? What are the steps you are supposed to take if a chemical splashes on your skin and clothes? What are the steps you are supposed to take if a chemical spill happens?

Types of Fire extinguishers – Potassium carbonate or sodium carbonate extinguishers » another type of dry chemical extinguisher » only effective on class B & C fires – class D extinguishers » sand, powdered sodium chloride, graphite, and soda ash

Fire extinguishers All extinguishers are only effective at certain ranges and for certain periods of time PASS procedure generally used in operation of fire extinguisher » P – pull » A – aim » S – squeeze » S – sweep

Eye Wash Stations & Deluge Showers – In instances where a chemical spill or splash event occurs it may be necessary to flush eyes or skin with water. – Generally agreed that instances where the eyes are involved you have a 10 second window to limit the amount of damage done.

Eye Wash Stations & Deluge Showers – Treatment procedure Always refer to the MSDS prior to using a chemical to know what steps should be taken in case of exposure. Splashes or spills where small areas of skin are affected. – Immediately flush the area with water for no less than 15 mins. – If no burns visible wash affected area with tepid water and soap. – Seek medical attention. – File out accident report.

Eye Wash Stations & Deluge Showers – Treatment procedure Splashes or spills to clothes. – Carefully remove any contaminated clothing and other personal effects. – Wash head prior to removing goggles. – Wash entire body for no less than 15 mins. – Seek medical attention. – Discard clothing – Fill out accident report

Eye Wash Stations & Deluge Showers – Treatment procedure Splash to eyes – flush with water for minimum of 15 mins. – keep eyelids open – Maintenance OSHA Laboratory Std. (29 CFR ) – eyewash stations should be inspected at regular intervals not less than 3 months – other safety equipment should be inspected regularly, i.e. every 3-6 months ANSI recommends weekly inspections

Responding to Spills – First correctly identify the material spilled. – Second eliminate any additional hazards. i.e. ignition source if material is flammable – Third notify others that a spill has occurred. – Fourth clean up according to appropriate protocol.

Responding to Spills – Spill kits Spill control pillows for absorbing solvents, caustic alkalis, and acids. Inert absorbents such as vermiculite, clay, and cat litter. Absorbents to control vapors. Neutralizing agents for acid and alkali spills. Plastic scoop and dust pan or pail. Appropriate PPE, warning signs, and barricade tape

Responding to Spills – OSHA (29 CFR , Hazardous Waste Operation Emergency Response) requires all personnel be trained in how to properly clean up hazardous waste. – In any instance where you are unsure of how to clean a spill up evacuate and contact the appropriate individuals. – Check MSDS along with state and federal regulations of how to dispose of the spill clean up waste

This project is funded by a grant awarded under the President’s Community Based Job Training Grant as implemented by the U.S. Department of Labor’s Employment and Training Administration (CB ). NCC is an equal opportunity employer and does not discriminate on the following basis: against any individual in the United States, on the basis of race, color, religion, sex, national origin, age disability, political affiliation or belief; and against any beneficiary of programs financially assisted under Title I of the Workforce Investment Act of 1998 (WIA), on the basis of the beneficiary’s citizenship/status as a lawfully admitted immigrant authorized to work in the United States, or his or her participation in any WIA Title I-financially assisted program or activity.

Disclaimer This workforce solution was funded by a grant awarded under the President’s Community-Based Job Training Grants as implemented by the U.S. Department of Labor’s Employment and Training Administration. The solution was created by the grantee and does not necessarily reflect the official position of the U.S. Department of Labor. The Department of Labor makes no guarantees, warranties, or assurances of any kind, express or implied, with respect to such information, including any information on linked sites and including, but not limited to, accuracy of the information or its completeness, timeliness, usefulness, adequacy, continued availability, or ownership. This solution is copyrighted by the institution that created it. Internal use by an organization and/or personal use by an individual for non-commercial purposes is permissible. All other uses require the prior authorization of the copyright owner.