Interpreting a Topographic Map

Slides:



Advertisements
Similar presentations
Topographic Maps Obj- 7. Describe how contour lines and contour intervals are used to show elevation on topographic maps 8. List the 5 rules of topographic.
Advertisements

Topographic Maps.
Topographic Maps.
Chapter 3 Topographic Maps
Chapter 3 Topographic Maps
Topographic Maps.
Do Now Write out the “Rules for Isolines” in your Do Now Section of your Notebook using your Homework from last night ISOLINES 1.) Isolines NEVER touch.
Topographic Maps TOPOGRAPHIC MAPS.
I. Contour Maps--Introduction 20 September 2007 RELIEF: difference in elevation between two points.
A Different Kind of Topography:
Topographic Maps.
Aim: Topographic Maps Do Now:
Mapping.
Topographic Maps specialized maps which show the highs and lows (relief) of the Earth’s surface.
Visualizing Earth’s Surface
Topographic Maps Topographic Maps: ____________
Topographic Maps.
OBJECTIVES: Describe isolines and contour lines
Topographic Maps.
Mapping Earth Midterm Review
Maps Maps are model representations of a three dimensional world. Latitude and Longitude give us two dimensions Elevation gives us the third In order to.
Topographic Map Notes FIELD- Area where a value is measured. ISOLINES- a line connecting points of equal value.
Where is this? The cell.
Topographic Maps September, 2011.
Contour Lines.
 A topographic map is a special type of map that shows the “contour” of the land. For this reason, they are sometimes referred to as a “contour map”.
RULES of Contour Mapping.
Topographic Maps 15 September Why are there two roads from Louberg to Luluville?
Aim: How do we read Topographic Maps? Do Now: In your notes, list all the different types of landforms/features of Earth that you can think of. Example:
Isolines: contour lines on an elevation map Isotherms: contour lines on a temperature map Isobars: contour lines on an air pressure.
Aim: How do we read/use Topographic Maps?
Do Now ISOLINES 1.) Isolines NEVER touch or cross each other.
Interpreting a Topographic Map
Isolines Isolines = lines that connect points of equal values. (iso = equal) The “values” can be anything… temp, pressure, elevation, etc.
What are topographic maps? 2-D map that uses contour lines to represent 3-D elevation Overhead view of elevation (as if we were flying over the landform.
Topographic Maps. A.4 B.3 C.2 D.1 What is a Topographic Map? Topographic maps show elevation by using contour lines –These maps would be important.
Topographic Maps. Gradient The rate of change from place to place within the field is called the gradient. It is also called the ____________________.
Topic: Topographic Maps PSSA: A/S8.D.1.1. Objective: TLW explain how contour lines show elevation on a map. TLW explain how relief of an area determines.
Topographic (Topo) Maps (also called Contour Maps)
Maps Topographic Maps Latitude & Longitude Latitude & Longitude.
What are topographic maps?. Topographic maps are also called contour maps A topographic map is a field map where the field value is elevation. Elevation-
Visualizing Earth’s Surface
Earth Science Regents Review
Topography Review DO NOW List three rules for drawing isolines.
1) Using the review books define the following:
Topographic Maps.
Isolines An isoline is a line connecting points of equal value.
Aim: How do we read/use Topographic Maps?
Field Maps.
Introduction to Topography
Topographic Maps Topographic Maps: ____________
Bellwork Review.
What are the Rules That All Contour Line Must Follow?
Why might this map be useful?
Field Maps Aim: What are fields?.
Introduction to Topographic Maps
Mapping Earth’s surface
An isoline is a line connecting points of equal value.
Topographic Maps TOPOGRAPHIC MAPS.
Topographic Maps.
Topographic Maps Notes
Interpreting a Topographic Map
Bellwork Review.
Isolines and Topographic Maps
What are the Rules That All Contour Line Must Follow?
What is the maximum elevation of the hill on west side of island?
Table of Contents Title: Topographic Maps Page #: 19 Date: 9/26/2012.
Isolines and Topographic Maps
After School Review Commack High School
Mapping Earth Do Now: Example: Hills
Presentation transcript:

Interpreting a Topographic Map Today’s Objective: Interpreting a Topographic Map Do Now: When would knowing your altitude be important?

** Important Vocabulary ** Isoline - A term used to describe lines that connect points of equal value on a map. Types of Isolines - Isotherms - equal temperatures Contour Lines - equal elevations Isobars – equal pressures

Index Contour Line Heavy lines spaced at a predetermined labeled elevations on a topographic map. Index Contour

- The Distance between contour lines (what it is counting by). Contour Interval - The Distance between contour lines (what it is counting by). What is the contour interval of this map? 100 Benchmark – tells the real elevation at that point

Estimating Elevation 15 m 23 m Label the contour lines based on the map interval Find the contour line before and after the point you are trying to determine Your answer should be a point in between those lines Contour Interval = 10 m 10 . a 20 30 . b . c Give a possible elevation for point “a” 15 m Give a possible elevation for point “b” 23 m

Give the HIGHEST possible elevation for What is the highest possible elevation? The highest possible point on a contour map will always be one unit less than the next possible contour line. Give the HIGHEST possible elevation for point “c” Contour Interval = 10 m 10 . a 20 30 . b . c 39 m

Give the LOWEST possible elevation for What about the LOWEST possible point? The lowest possible point on a contour map will always be one unit more than the lower contour line. Give the LOWEST possible elevation for point “c” Contour Interval = 10 m 10 . a 20 30 . b . c 31 m

Where would it be easier to hike? Why? B has a gentle slope, or gradient.

Gradient Refers to the steepness of the land (slope) Closer contour lines = steep slopes. Further contour lines = gradual slopes. Which side of the hill is the steepest? WHY? Steep Gentle

Contour lines will either Run off the map or Close on themselves to create circles

Contour lines will NEVER cross. If contour lines touch they represent a very steep gradient, otherwise called a cliff.

Closed contours with hachure marks represent depressions (holes). Hachure Contours

The contour line with the marks, or hachures , has the same elevation as the line before it. 50 Meters

River and Streams When a river or stream crosses a contour line, the contour line bends and points upstream. upstream downstream Upstream is where the river starts, higher elevation. Downstream is where the river ends, lower elevation.

10 m Northwest 30 m 100 m 70 m 40 m What is the contour interval? What compass direction is Eagle Mt. located? What is the elevation at the edge of Wolf Pond? What is the elevation of point B? 10 m Northwest 30 m Point C? Point E? 100 m 70 m 40 m

V points upstream (in this case East). Place an “X” on the map where the steepest location would be. What direction is the Creek flowing? Explain how your know. upstream x V points upstream (in this case East). So the downstream (direction of creek flow) is West.

What is the contour interval of this map? 20

If given the contour interval, can you label the lines? 15 10 5