Table 2. Air-water flow cases

Slides:

Advertisements

Similar presentations

and Statistics, 2016, Vol. 4, No. 1, 1-8. doi: /ajams-4-1-1

Advertisements

© The Author(s) Published by Science and Education Publishing.

Table 4. Mechanical properties of repair and substrate concrete

© The Author(s) Published by Science and Education Publishing.

Modulus of elasticity (GPa) Shear modulus elasticity (GPa)

Research, 2015, Vol. 3, No. 6, doi: /education

Table 2. Type designation of sensors in the security robot

Areas of Specialization

SON Nurse Practitioner Blackboard Community

Tensile Test after Firing

Table 2. Hydraulic system characteristics

Table 1. Operating Conditions

© The Author(s) Published by Science and Education Publishing.

Marshall characteristics

Table 3. Student’s Mathematical Critical Thinking Ability Description

© The Author(s) Published by Science and Education Publishing.

© The Author(s) Published by Science and Education Publishing.

Total CO2 Emissions (Electricity + Fossil Fuel)

© The Author(s) Published by Science and Education Publishing.

Table 2. Waste characterization in Port Harcourt, Source [1]

© The Author(s) Published by Science and Education Publishing.

Table 4. INVESTMENTS COST

Rating of Water Quality

XW9048(Xantrex inverters)

© The Author(s) Published by Science and Education Publishing.

© The Author(s) Published by Science and Education Publishing.

Table 1. Rice yield in MT (Source-USDA, Foreign Agricultural Service)

Number of categories that are mentioned (0% < categories < 5%)

Table 1. Diagnostic methods for systemic fungal infection (n=70)

Table 2. Modal parameters estimated by Pulse Reflex®

© The Author(s) Published by Science and Education Publishing.

No. Of units of single building Rated power (W) of unit load

Table 7. Status of CF in Nepal as of 2009

Table 5. Pvalues of ttests for direction a

Transformer Annual MVA Loadings (%) Average MVA Loading (%)

Entrapment Efficiency (%) ± S.D.

Interpass temperature

Table 1. Population by University

Table 3. Main properties of the thin brass electrode

Table 5. Maximum stress, strain and deformation values

Insulation, kWh/m²/day

Table 1. Characterization Result of Leaded Petrol and Blends

Order cycle in which item n has to be sent

Simulation Frequency(Hz)

Number of questionnaires sent out

Table 6. Pvalues of ttests for direction b

Table 1. Descriptive Statistics

Table 2. Regression statistics for direction a

Table 3. Regression statistics for direction b

Control Valve Tag Number

Table 6. The effect of porosity on pore velocity

Table 4. Summary of Multi ways ANOVA results

© The Author(s) Published by Science and Education Publishing.

Table 2. SUMMARIZED OBSERVATIONS FROM MODEL ANALYSIS

Table 4. Surface roughness (outer faces)

Table 1. Measurements of LEDs

Table 2. Control Valves & Bypass Valves Process Data

Control Valve Tag Number

Table 3. (d) Summary of two way ANOVA for overall adjustment

Table 1. K-T Diagram for Bicycle Seat

Category Quantity Secondary school 3 Student participant

Table 3. Surface roughness (inner faces)

Table 3. Simulation results

Compressive Strength difference at 1 week (MPa)

Table 6. Twisting moment of counter shaft at different torques

© The Author(s) Published by Science and Education Publishing.

Average Execution Time in seconds

© The Author(s) Published by Science and Education Publishing.

FDM (Fused Deposition Modeling)

Power per unit land or water area

Presentation transcript:

Table 2. Air-water flow cases Case number Air/water discharges (l/min) Air/water velocities (m/sec) Air/water discharge (l/min) 1 10/20 1.32/0.50 5 20/20 2.63/0.50 2 10/25 1.32/0.63 6 20/25 2.63/0.63 3 10/35 1.32/0.87 7 20/35 2.63/0.87 4 10/45 1.32/1.12 8 20/45 2.63/1.12 9 30/20 3.95/0.50 13 40/20 5.26/0.50 10 30/25 3.95/0.63 14 40/25 5.26/0.63 11 30/35 3.95/0.87 15 40/35 5.26/0.87 12 30/45 3.95/1.12 16 40/45 5.26/1.12 Laith Jaafer Habeeb et al. Experimental Study and CFD Simulation of Two-Phase Flow around Multi-Shape Obstacles in Enlarging Channel. American Journal of Mechanical Engineering, 2013, Vol. 1, No. 8, 470-486. doi:10.12691/ajme-1-8-1 © The Author(s) 2013. Published by Science and Education Publishing.