Chapter 9 Assessment of Fitness

Assessing Fitness Assessment of Fitness

Reasons for Fitness Testing Identify the athlete’s capability to perform certain tasks Identify athlete’s strengths and weaknesses, which can be used to develop/evaluate a training program Tests should be re-tested every 8-12 weeks to give coach-athlete feedback (one-off testing is pointless) Testing can motivate athlete’s to strive for improvement in their fitness. VCE Physical Education - Unit 4

Lab vs. Field testing Laboratory Tests; Assessment from expensive and sophisticated equipment in laboratories. Performed usually only at elite level (Sports institutes), but are very accurate (Eg. Maximal tests) Field Tests; Commonly carried out, as they are simple and results are instantaneous. Commonly carried out in individual and team sports to gauge ones fitness levels and can are specific to the fitness components required in particular sports. Maximal and Sub-maximal Testing See Page 229

Lab Testing Laboratory tests are those tests conducted under clinical laboratory conditions. They are the preferred means of assessing fitness components (especially for elite athletes) because they provide the most accurate indication of functional abilities. However, laboratory tests often require the use of expensive and sophisticated equipment, controlled environments, qualified personnel and considerable amounts of time to complete, which can prohibit their use. An example of such a state-of-the-art fitness testing program is the annual AFL draft selection camp at the Australian Institute of Sport (AIS) in Canberra. Some of the most promising young footballers across Australia vie for the attention of club recruiters during this camp. (See video later in PowerPoint)

Field Testing The alternative to laboratory testing is a carefully chosen battery of easily administered field tests, using readily available and inexpensive equipment. Such tests, although not as precise as laboratory tests, can provide accurate estimates or predictions of fitness levels. They also allow simultaneous testing of large groups. Field tests are the type of fitness test that you will most often use in your Physical Education classes. Complete the following in your notes: Lab Testing Field Testing Definition Advantages Disadvantages

Direct and Indirect Testing There are two broad approaches to testing – direct, maximal testing and indirect sub-maximal testing. Each has its advantages and disadvantages Direct – lab equipment, HR monitor, etc Indirect predictive measures/ equations Direct testing tends to be confined to laboratories Indirect sub-maximal testing tends to be used most often because it is easy to administer, requires less expertise and requires minimal effort. VCE Physical Education - Unit 4

See footage of VO2 max test https://www.youtube.com/watch?v=i7kn3mkO7Ec https://www.youtube.com/watch?v=fn3Yr-LS_l0 Field or lab test? Advantages and disadvantages? Direct or predictive measure? VCE Physical Education - Unit 4

VCE Physical Education - Unit 4 Absolute V02 / Relative V02? Absolute V02 is the total amount of 02 consumed. It is measured in L/min Relative V02 is the total amount of 02 consumed relative to your body size. It is a much greater reflection of a persons fitness. It is measured in mL/kg/min. VCE Physical Education - Unit 4

VCE Physical Education - Unit 4 Case Study BOB FRANK Absolute V02 3.8L/min Weight 105 60 Relative V02 36mL/kg/min 53mL/kg/min Absolute V02 / Relative V02? Its all about comparing apples with apples. As Frank is a smaller guy, but has a similar Absolute V02 – then considering his weight, he is much fitter and able to extract much more 02 than Bob per kg/min VCE Physical Education - Unit 4

The Evaluation Process Select the fitness components to be tested (Via game analysis) Select a suitable fitness test* Collect the data scientifically Analyse the data to determine strengths and weaknesses Make decisions as to what to do with the test results Design a training program to work on an athletes weaknesses and maintain their strengths VCE Physical Education - Unit 4

Each fitness test should be…. Relevant: Specific: Valid: Reliable: Work out the definitions for each protocol! An appropriate fitness test should measure what it claims to measure. For example, if a test claims to measure aerobic capacity it should be of sufficient duration to test the capacity of this energy system. Fitness tests must be able to be repeated with consistently accurate results. This is dependent upon a number of factors remaining constant. The predominant energy systems and fitness components utilised in an activity should form the basis for the selection of tests. Selected fitness should assess the performance capabilities of the relevant major muscle groups, and also the patterns and speeds of movement performed.

Test Selection Criteria Each fitness test should be: Relevant: Selected fitness should assess the performance capabilities of the relevant major muscle groups, and also the patterns and speeds of movement performed. Specific: The predominant energy systems and fitness components utilised in an activity should form the basis for the selection of tests. Valid: An appropriate fitness test must be valid in that it should measure what it claims to measure. For example, if a test claims to measure aerobic capacity it should be of sufficient duration to test the capacity of this energy system. Reliable: Fitness tests must be able to be repeated with consistently accurate results. Reliability is dependent upon a number of factors remaining constant. — The same warm-up should be performed. — The same sequence of tests should be conducted. — The same recovery period between tests should be provided. — The athlete should be tested at approximately the same time of day. — The athlete should be in a similar fluid and nutritional state. — The environmental conditions of heat, humidity and air movement should be similar. VCE Physical Education - Unit 4

2015 2011

Pre-testing procedures The following is a checklist of recommended procedures and precautions that should be followed before undertaking any form of fitness testing. • The individual should be fully informed and familiarised with the procedures and format of the test(s). • No food should be consumed immediately before the testing session. (approx 2hrs) • Appropriate clothing and footwear should be worn. • Heavy or intense exercise should be avoided on the day prior to testing. • The individual should give their consent and appropriate medical clearances should have been obtained. • Untrained individuals should work at maximum intensities for short periods only, and their responses should be closely monitored. This is to ensure that they do not injure themselves or run the risk of overtaxing themselves. VCE Physical Education - Unit 4

VCE Physical Education - Unit 4 Standards and Norms Where available, an athlete may make use of ‘norms’ (standards that are ‘normal’ or typical for a group) but caution should be exercised in referring to these norms. Where norms are not available, the athlete should use personal bests (PB’s) as a guide. VCE Physical Education - Unit 4

Examples of a norm…

Protocols to follow before testing Players’ rights and coaches’ responsibilities are an essential aspect of fitness and training. Before any fitness tests are carried out, it is essential that: all coaches and trainers clarify all testing procedures and risks to their athletes. All athletes should be clearly informed about the nature of the fitness testing they are being directed to undertake, including: aims of the testing methods of testing risks of the testing. Athletes may also be required to give their informed consent for undertaking the testing, and acknowledge the confidentiality of the test results. VCE Physical Education - Unit 4

Fitness Tests Assessment of Fitness

VCE Physical Education - Unit 4 Aerobic Capacity Aerobic Capacity Cooper’s 12 minute run Step Tests Harvard Step test Queen’s College Step test 20m shuttle run test 1.6km jog test (1 mile) VCE Physical Education - Unit 4

VCE Physical Education - Unit 4 Anaerobic Capacity The two measures of anaerobic capacity include measurement of the capacity of the ATP–PC system and measurement of the capacity of the anaerobic glycolysis (lactic acid) system. Tests to assess the capacity of the ATP–PC system need to include activities of short duration (0–10 seconds) and maximum intensity (100 per cent effort). Tests to measure the capacity of the anaerobic glycolysis system need to be performed at maximal or near-maxima intensity (95−100 per cent) and be sustained for a period of time between 30−90 seconds. VCE Physical Education - Unit 4

Anaerobic Power/Speed Phosphate recovery test Repco peak power test Sprint standing starts 50m sprint test VCE Physical Education - Unit 4

Muscular Endurance, Strength and Power Sit ups Push ups Modified/pull ups Muscular strength Grip strength Core muscle strength Muscular Power Standing Long Jump Vertical Jump VCE Physical Education - Unit 4

VCE Physical Education - Unit 4 Flexibility Flexibility Sit and reach Shoulder & wrist elevation Trunk and neck extension Shoulder rotation Ankle extension / flexion VCE Physical Education - Unit 4

VCE Physical Education - Unit 4 Agility Agility Illinois agility test Semo agility test VCE Physical Education - Unit 4

VCE Physical Education - Unit 4 Body Composition BMI Skinfold test underwater weighing (hydrodensitometry), waist-to-hip ratio. VCE Physical Education - Unit 4

VCE Physical Education - Unit 4 AIS / AFL draft combine https://www.youtube.com/watch?v=Fkx-fYYxm7M VCE Physical Education - Unit 4

For each fitness component, you will need to know x2 tests to complete a fitness battery. Using the handouts and your chapter notes, select x2 tests for each fitness component Be sure to cut out and paste the procedure for each test. You will need to know these!

Health-related Fitness Components Skill-related Fitness Components Test #1 Test #2 Health-related Fitness Components Aerobic Capacity i.e. 20m shuttle test Queen’s College Step Test Anaerobic Capacity Muscular Strength Local Muscular Endurance Flexibility Body Composition Skill-related Fitness Components Speed Muscular Power Agility Coordination Balance Reaction Time VCE Physical Education - Unit 4

2016

2015

2014

2014 M/C 2014 Qn9 Continued… (& over Page)

VCE Physical Education - Unit 4

VCE Physical Education - Unit 4 2013 VCE Physical Education - Unit 4

2013