Following Directions Lesson

Slides:



Advertisements
Similar presentations
Following Directions Lesson
Advertisements

FRACTIONS.
Following Directions Lesson
Escambia County School Board Office of Career and Technical Education
Westside Tech Curriculum Department Learning Guides Westside Tech Westside Tech Westside Tech.
MODULE THREE SCALES AND DIMENSIONS
Unit 6: Scale Factor and Measurement
Subtraction Addition.
Accuracy Counts Measure Twice Cut Once. From 0 to 1 is equal to 1 inch 01.
Fractions How much pie do I get? PART WHOLE A fraction is a PART of a WHOLE Whole pizzaA fraction of a pizza.
By the end of the lesson, you will be able to…
By the end of the lesson, you will be able to…
Miss Crump’s Introduction to Fractions When do you see fractions? What do you know about fractions?
Materials Reminders. Get out your agenda if you see your name below. I would like to have you in my FLEX tomorrow. Period 2Period 7.
Unit 8 Fractions and Ratios.
Simplifying Rational Expressions – Part I
Lets begin, next Instruction Read each question and answer by clicking the correct answer. Lets go.
Green Meadow Elementary
Converting Fractions to Decimals
Comic Book Lesson You will: Apply 2 inch by 2 inch grid lines to your poster board Poster board is 13 inches wide by 20 inches long.
Objective: Learn to write fractions in simplest form.
Understanding Fractions By Bob Snyder Writing Fractions Fractions can be written two ways: 1.With a flat line - ⅝ 2.With a slanted line – 5 / 8.
Learning the Language of Math ESOL. FRACTIONS Learning Outcome I can… * explain what is a fraction. * explain the difference between a whole number and.
Following Directions Lesson
Background – World Wide  Two main systems of measurement  Metric System  Based on the number 10  U.S. Customary System  Based on halving or doubling.
Measuring Equipment Units of Measurement Whole Numbers (1, 2, 3) Fractions (1/8”) Decimals (0.392) Metric (1 mm)
Fractions BROUGHT TO YOU BY POWERPOINTPROS.COM. What are fractions? A fraction is a part of a whole.
Equivalent Fractions A fraction is a ratio that compares how much of something exists. They contain a numerator ( the top ) and a denominator ( the bottom.
Stage Craft Measuring basics Swartz Creek High School 2014.
What makes something whole?. Unit Questions n Why are things broken into parts? n What can be broken into sections? n Are fractions are part of our lives?
Module 5 Lesson 19 Understand distance and position on the number line as strategies for comparing fractions.
Introduction to Engineering and Technology Concepts Unit Eight Chapter Three – Standard Measurement.
Unit 1, Lesson 1 Introducing the MathBoard. MathBoard  The top bar shows one whole. The other bars show this same whole divided into different numbers.
Following Directions Lesson How to Read a Ruler WDT 110 Industrial Blueprint Reading Creative Commons License How to Read a Ruler by Bruce Sasser, Scott.
KS3 Mathematics N5 Using Fractions
Escambia County School Board Office of Career and Technical Education
Measurement Inch, 1/2”, and ¼”
Introduction to Standard and Metric Measurement
Adding and Subtracting Fractions with like Denominators
GTT – Unit 7 – Green Architecture
GTT – Unit 7 – Green Architecture
Introduction to Standard and Metric Measurement
An Instructional Power Point by The Curriculum Corner
5-4 Identifying and Writing Proportions Warm Up Problem of the Day
Fractions are even parts of shapes & groups
Engage NY Math Module 3 Lesson 1: Making equivalent fractions with the number line, area model and with numbers.
Introduction to Standard and Metric Measurement
GTT – Unit 7 – Green Architecture
For example:
Introduction to Standard and Metric Measurement
Fractional Parts of Objects
Introduction to Measurement
Can fractions be equivalent to whole numbers?
EQUIVALENT FRACTIONS MINI-LESSON
Reading a Ruler with Precision
Find Equivalent Fractions
Reading a Ruler with Precision
Reading a Ruler with Precision
Wednesday, March 18, 2015 SCIENCE TIME 8:10 – 8:40.
Reading a Ruler with Precision
Introduction to Standard and Metric Measurement
Gateway – Unit 7 – Green Architecture
Ratio and Proportion.
Engage NY Math Module 3 Lesson 1: Making equivalent fractions with the number line, area model and with numbers.
Multiplying Fractions: Visual Fraction Models
Understanding Equivalent Fractions
Halves, Thirds and Fourths! Fraction Fantastic!
Fractions and Division
Fractions.
Presentation transcript:

Following Directions Lesson Mrs. Williams LVHS

Following Directions Lesson Take out a clean sheet of notebook paper and something to write with. Place it in front of you on your desk.

Following Directions Lesson Fold your paper in half long ways (vertically)

Following Directions Lesson Open your paper up and place it with the holes toward the top on your desk. Draw a line all the way down the crease on the paper. “DO NOT WRITE ON THE DESK!!”

Following Directions Lesson Fold the paper in half the other way (horizontally) You can see my line because I used a Sharpie Marker and it bled through the paper.

Following Directions Lesson Open the paper up with the holes toward the top. Draw a line from the center of the paper to the red margin closest to you.

Following Directions Lesson Fold the paper like you had it last horizontally. Then fold it over again in the same direction.

Following Directions Lesson Open the paper up. Draw a line on each of the creases half way to the bottom margin. Then fold your paper back up like you last had it.

Following Directions Lesson Fold the paper over one more time in the same direction as your last fold, making it even more slender.

Following Directions Lesson Open the paper up. Draw lines on the four creases half as long as the last lines you drew, or ¼ of the way to the bottom margin.

Following Directions Lesson Draw small lines on your paper in between each of the lines already on your paper and the left and right edges. Make the lines extend down and be half as long as the last lines drawn.

Following Directions Lesson Next, draw lines on the left and right edges all the way down below the margin, half way between the margin and the bottom of the paper. And in case you haven’t already figured it out, we are making a ruler.

Following Directions Lesson Now all you have to do is count the lines as you go from left to right. 3 5 1 7 9 11 13 15 2 6 10 14 4 12 8 16

Reading A Ruler By counting you realize that you have 16 equal parts to an inch. Next you show each number as a fraction or portion of the total number 16. 1/16 3/16 5/16 7/16 9/16 11/16 13/16 15/16 2/16 6/16 10/16 14/16 4/16 12/16 8/16 16/16

Reading A Ruler Next, you must remember from math that a fraction should always be expressed in lowest possible terms. 1/16 for example is in its lowest form, it cannot be reduced any farther. 2/16 however, can be reduced. 2 is the numerator (top number in a fraction) 16 is the denominator (bottom number in a fraction)

Reading A Ruler 2/16 can be reduced by 2. This means that both 2 and 16 are divisible by 2. 2 divided by 2 = 1 16 divided by 2 = 8 Therefore our reduced fraction will be 1/8.

Reading A Ruler Now lets take 3/16, will it reduce? I bet that someone said yes! Some people look at the three as the numerator and the six in the sixteen (denominator) and automatically think that this fraction will reduce. However, it will not reduce. 3/16 is already in its lowest terms.

Reading A Ruler Next, lets look at 4/16. Yes it will reduce. There are two ways to reduce fractions like this one. If you’re a math wiz, you might say that 4 will go into 16. If you do, you are right. You can divide the numerator into the denominator. This is the quickest of the two ways, but you can divided both the numerator and the denominator by 2, twice. You have to be careful to get fractions like this one into lowest possible terms.

Reading A Ruler The easiest way to deal with 4/16: 4 divided by 4 = 1 Your reduced fraction is ¼.

Reading A Ruler The other way to deal with 4/16 is: 4 divided by 2 = 2 Your fraction is 2/8, but is it reduced to lowest possible terms? NO, you have to reduce again. 2 divided by 2 = 1 8 divided by 2 = 4 Your reduced fraction is 1/4

Reading A Ruler Now that you know how to reduce these fractions, you finish reducing the rest of the fractions on your ruler.

Reading A Ruler Now Check your fractions against these correct answers. 1/16 3/16 5/16 7/16 9/16 11/16 13/16 15/16 1/8 3/8 5/8 7/8 1/4 3/4 1/2 1

Now that you know how to use a ruler, here are some short cuts for you. As you have noticed, the lines are different lengths on the ruler. As we go across one more time pay attention to the line length and the denominator associated with it. Reading A Ruler 1/16 3/16 5/16 7/16 9/16 11/16 13/16 15/16 1/8 3/8 5/8 7/8 1/4 3/4 1/2 1

Reading A Ruler Did you notice a trend? The longest lines were of course whole numbers. 1

Reading A Ruler The second longest line is 1/2. The third longest line has a denominator of 4. 1/4 3/4 1/2

Reading A Ruler The fourth longest lines always have a denominator of 8. 1/16 3/16 5/16 7/16 9/16 11/16 13/16 15/16 1/8 3/8 5/8 7/8 The shortest lines always have a denominator of 16.

Reading A Ruler Now let’s look at the whole ruler. Can you tell me what would be the correct measurement for the letter A. The answer is 5-7/16. You start at the whole number and you add the calculated fraction to the whole number to give the correct distance. A 6 5

Reading A Ruler What is the correct measurement for the letter A. The answer is 10-3/16. What is the correct measurement for the letter B. The answer is 10-3/8. What is the correct measurement for the letter C. The answer is 10-3/4. A B C 11 10

Reading A Ruler Now you know how to read a ruler and deal with the fractions involved. But these are measurements, and have to be expressed as measurements. Write the following notes on your paper. This standard ruler is to be expressed in inches or in. or”. Example: 1 ½” 12 inches is equal to 1 foot or ft. or ‘. Example 4’ 1 ½” Three feet is equal to 1 yard or yd.

Reading A Ruler See if you can tell the measurements of the objects on the Quiz given by the Teacher On the back of your paper title it Measurement Quiz and number from 1 to 5.