Multifunctional Sensor SB-CMS-12in1

Functions SB-CMS-12in1 PIR motion sensor Ultrasonic sensor LUX sensor Temperature sensor 2 Dry contacts 2 external condition inputs IR(infrared) receiver IR(infrared) transmitter 2ch 5A Relay outputs Constant LUX control security alarm logic (works with Security Module) 24 configurable logics SB-CMS-12in1

Basic information Subnet ID and Device ID Device remark LED on/off option

IR Transmitter 1.Input a range to be involved 2.Select codes and upload it to 12IN1,it would show in the left table 3.Test the code in 12IN1

IR Receiver Enabe /Disable IR code receiver These 8 keys match with the 8 keys of HDL remote HDL-MTIRW(Select LCD panel,the 5 pages correspond to this 5 pages)

IR Reveiver Select control mode Save

IR Reveiver Set the target for each key

Sensor Setting Right click to refresh the status displaying you can enable/disable these functions here, you also can send the UV switch ON/OFF commond to enable/disable these functions Constant LUX function(pay attention to remark)

Sensor Setting Power off recover options Right click to refresh the status displaying Power off recover options

Logic Relation Select Logic relation Combine Logic input condition

Logic Relation Logic True delay time trigger targets when the logic is true. Logic False delay time trigger taegets when the logic is false.

Security Function Enable the security function of ch1 Assign ch1 to the security module(10/12), area1

Relay Settings Built-in 2 channel 5A Relay Cycle Mode:Relay turns on and off periodically

Simulate Test Simulate some sensors' value or status. This is very useful when test the new-created Logic.

Application Requirements: 1. When people open the door and come into the meeting room, turn on the lights automatically 2. 1 minute after people come into the room, turn on the AC and set the temperature as 25℃ 3. 1 minute after people left the room, turn off the lights and set temperature as 27 ℃ 4. 3 minutes after people left the room, turn off the AC automatically 5/2/2018

Application When people open the door and come into the meeting room, turn on the lights automatically

Application Delay time=1m Select "Movement" Suppose dry contact 1 has been connet with a magnetic contact and used to detect the door status. Select "AND" Save

Application Turn on the light when the Logic is true

Application B. 1 minute after people come into the room, turn on the AC and set the temperature as 25℃

Application Delay time=1m Select "Movement" Select "Connect"--Close the door Select "AND" Save

Application Check the index no. in SB-DN-EM,the third one is colling 25 Fill in the index no. here

Application C. 1 minute after people left the room, turn off the lights and set temperature as 27 ℃ 5/2/2018

Application Delay time=1m Select "No Movement" Save

Application Turn off the light and set the temperature as 27 ℃

Application D. After 3 minutes people left the room, turn off the AC automatically 5/2/2018

Application Delay time=3m Select "No Movement" Save

Application Fill in the index no., Index no.=2