1. Guitar Intonation & Setup

2. Introduction Guitar setup on your new guitar is an iterative process that will take you approximately an hour. Additional time will be needed for nut and string retainer installation

3. String names Standard Tuning big to little… E, A, D, g, b, e Standard Tuning big to little… E, A, D, g, b, e

4. Install the nut The nut has a burr on the bottom edge, making it wider than 1/8 The nut has a burr on the bottom edge, making it wider than 1/8 Sand the nut thinner to fit the nut slot Sand the nut thinner to fit the nut slot Ideal fit = wont fall out Ideal fit = wont fall out Clean the nut slot out so it is free of finish and glue Clean the nut slot out so it is free of finish and glue

5. Install the nut Shims may be needed beneath the nut to raise the nut up if the strings touch the first fret Shims may be needed beneath the nut to raise the nut up if the strings touch the first fret Evergreen strip styrene.125 wide. Evergreen strip styrene.125 wide.

6. Install strings There are several methods to wind strings around tuning machine posts There are several methods to wind strings around tuning machine posts Simplest is to wrap starting at the top of the post and work down Simplest is to wrap starting at the top of the post and work down

7. Install strings Unwound strings=approx 5 or 6 winds Unwound strings=approx 5 or 6 winds Wound strings, less Wound strings, less D = 4, A = 3, E = 2 winds D = 4, A = 3, E = 2 winds Leave enough extra string to wind around the post Leave enough extra string to wind around the post Pull taught, then back up for the winds Pull taught, then back up for the winds Do not kink the strings Do not kink the strings

8. Tuning stability For tuning stability, tug new strings to stretch them. Tug about as much as you could stand to have your hair pulled, just to ouch. For tuning stability, tug new strings to stretch them. Tug about as much as you could stand to have your hair pulled, just to ouch. This also causes the windings to slip a little against each other and lock in place. This also causes the windings to slip a little against each other and lock in place. Repeat tug and retune several times for larger strings. Repeat tug and retune several times for larger strings.

9. Install string retainer bar Bar increases break angle Bar increases break angle Eliminates buzz, side-to-side motion at the nut Eliminates buzz, side-to-side motion at the nut Sitar-like effect Sitar-like effect

10. String Heights at 1 st fret.020 -.030 at the 1 st fret.020 -.030 at the 1 st fret Shim behind nut if strings too low Shim behind nut if strings too low Cut slots deeper if strings too high Cut slots deeper if strings too high

11. String Heights at 21 st fret.080 at the 21 st fret…less on the treble side Set saddles in a 12R arc Use allen wrench in saddles

12. String Heights at 21 st fret Set two E strings, and make the other four too high on purpose. Set two E strings, and make the other four too high on purpose. Once satisfied with the two E strings, lower the other four to just touch the understring radius gauge. Once satisfied with the two E strings, lower the other four to just touch the understring radius gauge.

13. String Lengths – rough-in Measure 12.75 from 12 th fret to little e string to start Measure 12.75 from 12 th fret to little e string to start Stagger saddles as shown for rough-in Stagger saddles as shown for rough-in D and B about the same distance D and B about the same distance

14. Scope software link free http://www.zeitnitz.de/Christian/scope_en

15. Scope software Tune the guitar, open strings, using SCOPE software Tune the guitar, open strings, using SCOPE software E - 82Hz E - 82Hz A - 110Hz A - 110Hz D - 147Hz D - 147Hz g - 196Hz g - 196Hz b - 247Hz b - 247Hz e - 330 Hz e - 330 Hz

16. Scope software

17. Scope Choose Frequency Analysis display no peak hold

18. Scope Set Zoom slider to 20 and right-hand scroll all the way to the left to see frequencies in the range of the guitar

19. Scope Set Band pass frequency filter to isolate desired frequencies, otherwise you will see many harmonic overtones! Adjust cut-offs for each string and octave

20. Neck Relief Neck relief is where you have some intentional concave curvature to the neck We do this after tuning open to ensure the neck is experiencing typical forces of string tension It allows strings to vibrate without buzzing against frets

21. Neck Relief 1 st fret and 17th fret (fret where neck meets body) 1 st fret and 17th fret (fret where neck meets body).010 gap between strings and 8 th fret.010 gap between strings and 8 th fret Information from http://support.fender.com/manuals/instruments/Fender_Guitars_and_Basses_(1992-1994)_manual.pdf

22. Neck Relief As you look from the bridge of the guitar toward the string nut…… As you look from the bridge of the guitar toward the string nut…… Turn truss rod adjuster CCW to lower the middle of the neck Turn truss rod adjuster CCW to lower the middle of the neck Turn truss rod adjuster CW to raise the middle of the neck Turn truss rod adjuster CW to raise the middle of the neck

23. Intonation Intonate after tuning open and setting neck relief to ensure the neck is experiencing typical forces of string tension Intonate after tuning open and setting neck relief to ensure the neck is experiencing typical forces of string tension Adjusting the truss rod requires readjusting the saddles Adjusting the truss rod requires readjusting the saddles –(overall length is changed) Detune string before moving saddle! Detune string before moving saddle!

24. Intonation Use Scope software 12 th fret to bridge saddle Sharp = string too short, turn CW to lengthen Flat = string too long, turn CCW to shorten

25. Intonation Any time you move the bridge saddle, the open string must be retuned Any time you move the bridge saddle, the open string must be retuned Then re-check the 12 th fret to see if it is an octave higher, or flat, or sharp. Then re-check the 12 th fret to see if it is an octave higher, or flat, or sharp. Repeat Repeat

26. Intonation Guitar neck will change shape with seasons Guitar neck will change shape with seasons Guitar will settle in over the next 3-6 months Guitar will settle in over the next 3-6 months Adjustments will be necessary Adjustments will be necessary

27. Congratulations This concludes guitar setup dhunt@swell.k12.in.us