1. Advanced Engineering Design and Presentation Wood Clamp Parametric Modeling Skill Builder Copyright © Texas Education Agency, 2014. All rights reserved.

2. Creating a Wood Clamp Create it to the specifications given. Change the wood to whatever type you prefer. Make sure that you use the correct threads on the screw. Copyright © Texas Education Agency, 2014. All rights reserved. 2

3. Layout Page 1 Copyright © Texas Education Agency, 2014. All rights reserved. 3

4. Layout Page 2 Copyright © Texas Education Agency, 2014. All rights reserved. 4

5. How to Create the Parts Create a folder on your drive for all of the Wood Clamp parts and assemblies. Make sure you save to this folder only! The following slides will help you figure out how to create the parts. Part #1 – Jaw Part #2 – Screw Part #3 – Pin Copyright © Texas Education Agency, 2014. All rights reserved. 5

6. Part #1 - Jaw 6

7. Draw this and extrude it. Copyright © Texas Education Agency, 2014. All rights reserved. 7

8. Add fillet to the bottom. Copyright © Texas Education Agency, 2014. All rights reserved. Part #1 - Jaw 8

9. Find centers and add the two holes. Copyright © Texas Education Agency, 2014. All rights reserved. Part #1 - Jaw 9

10. Add screw threads to the hole. Copyright © Texas Education Agency, 2014. All rights reserved. Part #1 - Jaw 10

11. Copyright © Texas Education Agency, 2014. All rights reserved. Part #2 - Screw 11

12. Part #2 - Screw Draw and then extrude this. Copyright © Texas Education Agency, 2014. All rights reserved. 12

13. Draw and extrude the top. Copyright © Texas Education Agency, 2014. All rights reserved. Part #2 - Screw 13

14. Copyright © Texas Education Agency, 2014. All rights reserved. Part #2 - Screw Create a new offset work plane as needed, draw, then extrude cut or use the hole command. 14

15. Add the correct threads. Copyright © Texas Education Agency, 2014. All rights reserved. Part #2 - Screw 15

16. Part #3 - Pin Draw and extrude this. Copyright © Texas Education Agency, 2014. All rights reserved. 16

17. Add the fillet to both ends. Copyright © Texas Education Agency, 2014. All rights reserved. Part #3 - Pin 17

18. Assembly Copyright © Texas Education Agency, 2014. All rights reserved. Place parts and constrain them to look like this. 18

19. Make an Exploded View Copyright © Texas Education Agency, 2014. All rights reserved. Make an exploded view by tweaking, moving, and rotating, to look like this. 19

20. Place the exploded and assembled views onto layout page #1; add the parts list and balloon annotations. Copyright © Texas Education Agency, 2014. All rights reserved. 20

21. Place the Wood Clamp Jaw, Pin, and Screw onto layout page #2; add annotations. Copyright © Texas Education Agency, 2014. All rights reserved. 21

22. Follow the example and rubric given. Copyright © Texas Education Agency, 2014. All rights reserved. 22