1. 1 Remove seat from vehicle and remove seat trim cover

2. 2 Drill out rivets and spot welds as shown. Use ¼” drill. Remove risers (4) as shown.

3. 3 4 Remove carpet staples (3) from rear of rocker panel and remove white plastic support strip (rear only) Will need to modify rocker panel cover to accommodate pivot point bearings Set ER into vehicle to mark where to cut

4. 5 6 Install seat onto ER Use ¼-20 x 1/2 button head cap screws (provided) to attach front of seat tracks to ER (1 each side) Install ER into vehicle using OEM hardware May or may not need to modify rocker panel cover to accommodate ramp

5. 7 8 Use ¼-20x1/2 buttonhead cap screws (provided) to attach rear of seat tracks to ER (2 each side) Remove rear door panel as shown. Re- attach seatbelt anchor as shown.

6. 10 9 Bend tab in to avoid contact with ER when door is closed Front door panel may require minor modifications here (ER) Try using heat gun to form panel enough to close door

7. 11 If heat gun is not enough, cut door panel here and refinish as needed Cut rear door panel here. Refinish as needed. 12

8. Attach OEM wire harness under seat and connect to coil cord provided with ER. Be sure that wires do not interfere with the seat sliding forward and backward, nor with the operation of the Easy-Reach.