Download presentation
Presentation is loading. Please wait.
1
with Barcode Reader 24.09.2015 05:33
2
with Barcode Reader 24.09.2015 05:33 Selection of barcode reader 1a. Select the button „Configuration“.
3
with Barcode Reader 24.09.2015 05:33 1b. Click in the area which is coloured green in the drawing. This is the base configuration area.
4
with Barcode Reader 24.09.2015 05:33 1c. Click the check box „Barcode reader“, so that it is checked. Hint: With „Barcode reader“ checked the „Edit mode“ box within the „Create Order Files“ window is hided. The barcode reader reads the ID and type. Manual input is not necessary.
5
with Barcode Reader 24.09.2015 05:33 1d. Check the Barcode reader serial port. Hint: In this example the cable is connected with Com Port 2. Click „OK“.
6
with Barcode Reader 24.09.2015 05:33 Destination Selection Mode 2a. Select in the menu „Edit settings“. In the next screen we distinguish two cases: Case 1: Working with automatic destination assignment. Case 2: Working with manual destination assignment.
7
with Barcode Reader 24.09.2015 05:33 Case 1: Working with automatic destination assignment: Click the box, so that it is unchecked. Enter the matrix type. WD6216 WP24211 WH12@1MM209B 209B@209B WH12@WH12DS209 209@209 WH12 WH12@WH12DR 205MI 854B 668 205 853B 853B@209 203 526B 526B@209B 202 348B 201 306B 200 304B Rack/Wellplate Type on Barcode (.........# ) Case 2: Working with manual destination assignment: Click the box, so that it is checked.
8
with Barcode Reader 24.09.2015 05:33 Start Automation Initializing / Home seeking Reading barcodes Create orders without SampleTrack Verify orders Preparation 3a. Click the green button to start automation.
9
with Barcode Reader 24.09.2015 05:33 3b. The program asks, if the barcodes should be read. Click „Yes“, if you run the program in a new setting.
10
with Barcode Reader 24.09.2015 05:33 Case 1: Working with automatic destination assignment The destination checkbox is hided and the destination is defined by program. Case 2: Working with manual destination assignment The destination must be selected.
11
with Barcode Reader 24.09.2015 05:33 4a. Case 1: Working with automatic destination assignment: Select the source tubes with a lasso operation: Click and hold the left mouse cursor. Draw a rectangle. The marked positions will be shown as orders.
12
with Barcode Reader 24.09.2015 05:33 Click „Create Orders“. Click „OK“.
13
with Barcode Reader 24.09.2015 05:33 5. The orders are running.
Similar presentations
