1. Metalwork Tools 2 Quiz

2. What is the correct name for this tool?
Bevel Edged Chisel
What is the correct name for this tool?
Firmer Chisel
Mortise Chisel
Gouge
Cold Chisel

3. Wrought Iron
2. What type of metal is a cold chisel
made from?
High Carbon Steel
Mild Steel
Cast Iron
High Speed Steel

4. 3. What is the correct name for the tool shown below
Rivet Bar
Rivet Set & Snap
Rivet Punch
Riveter

5. 4. What is a hand countersink used for?
Centre Punching Holes
Removing Burrs
Drilling Holes

6. 5) What is the correct name for this tool?
Tinsnips
Pliers
End Cutters
Shears

7. 6. Which of the following tools would be used to cut 6mm Dia steel bar?
A Coping Saw
A Piercing saw
A Jnr Hacksaw
A Panel Saw

8. 7. What is another name for Mole Grips?
Self Grip Pliers
Engineers Pliers
Long nose Pliers
Stillson
Plumbers Wrench

9. It can grip round objects like pipe
8. What major advantage does a
Stillson Wrench have over an
Adjustable Spanner?
It is cheaper to buy
It is easier to use
It can grip round objects like pipe
It has been drop forged

10. 9. What is the correct name for this tool?
Tin Snips
Heavy Duty Snips
Jewellers Snips
Diagonal Cutters

11. 10. Which tool is designed to cut rivets?
Engineers Pliers
Long Nose Pliers
Diagonal Cutters
End Cutters

12. 11. What is the correct name for this tool?
Stillson
Engineers Pliers
Water Pump Pliers
Long Nose Pliers

13. 12. Which tool is designed for working in tight areas and cutting fine wire?
Engineers Pliers
Long Nose Pliers
Diagonal Cutters
End Cutters

14. 13. What is the correct name for
this tool?
Pin Hammer
Ball Pein Hammer
Cross Pein Hammer
Planishing Hammer
Claw Hammer
Repousse Hammer
Blocking Hammer

15. 14. What is the correct name for these tools?
Centre Punches
Nail Punches
Parallel Punches
Letter Punches

16. 15. Letter stamps can be used to stamp letters on which of the following?
Perspex
Acrylic
Aluminium
High Speed Steel

17. 16. What are Toolmakers
clamps used for?
The Toolmakers clamp can
be used to hold small pieces of
work while it is being brazed
The Toolmakers clamp can
be used to hold small pieces of
work while working on them
The Toolmakers clamp can
be used to hold small pieces of
work while it is being welded

18. Cross Pein Hammer
17. Which tool could be used to create
this dimpled pattern on the back of
this drawer handle?
Repousse Hammer
Pillar Drill
Centre Punch
Parallel Punch

19. 18. Which of the following tools would be used to cut 0
18. Which of the following tools would be used to cut 0.5mm thick Copper Sheet?
A Coping Saw
Tin Snips
Engineers Pliers
A Panel Saw

20. 19. What is the main disadvantage
to using an adjustable spanner
It takes time to adjust the spanner to
the correct size.
The adjustable Spanner has a tendency to round the corners of the nut or bolt.
Adjustable spanners are bigger than ordinary spanners.

21. Quiz Completed
Well Done

22. 
Wrong
Click here to try again