1. Standard Grade Technological Studies
Flow control valves

2. Flow control valves Normally pneumatic pistons move very quickly.
This can be dangerous.
To slow the speed of a piston down we can use a flow control valve.
There are generally two types available to us.

3. The Restrictor Often referred to as a throttle valve.
Works by reducing the amount of space the air can flow through.
Can be adjusted by turning the small screw on top of the valve.
The symbol for a restrictor is shown.

4. The Restrictor
The restrictor slows the flow of air in both directions.
In the circuit shown, a restrictor is used to slow the speed of the single acting cylinder.
The problem with this type of restrictor is that it slows the piston in both directions.

5. The Unidirectional Restrictor
This restrictor slows the flow of air in one direction only.
The symbol for a unidirectional restrictor is as follows...

6. The Unidirectional Restrictor
Air flows into port 1...
Some of the air takes the bypass route...
This blows a small ball against a valve and blocks this path...
The air is forced through the restriction, slowing down the airflow.
By-pass
Air flow
Restriction

7. The Unidirectional Restrictor
Air flows into port 2...
Again, some of the air takes the bypass route...
The ball is blown away from the valve...
The air is flows through the bypass unrestricted.
By-pass
Air flow

8. Restrictor circuits Unidirectional restrictors are more useful to us.
We must ensure that they are inserted into a circuit in the correct orientation.
We always restrict the exhaust air coming from the cylinder.
This makes the piston operate much more smoothly.

9. Assignment 8
1. Back to the car park barrier. Some one suggests further modifying the circuit...
Build and test the circuit shown to raise the barrier slowly
Describe how the system operates.
Why do we restrict the exhaust air when slowing down the speed of the piston?

10. Assignment 8
2. For safety reasons, the entrance door to a store room must open and close slowly. A double acting cylinder is used to slide the door.

11. Assignment 8
2. The circuit diagram for the door mechanism is shown, with some of the piping missing.
Copy and complete the circuit diagram.
Build and test the door opening circuit.
Describe how the circuit operates and why two restrictors are needed in this circuit.

12. Assignment 8
3. Part of a manufacturing process involves dipping components in a chemical solution to prepare them before they are painted.
A double acting cylinder controls the process.
For safety reasons the cylinder must outstroke and instroke slowly.

13. Assignment 8 Design a circuit that will solve this problem.
Using computer simulation, build and test your solution.
Construct your circuit using the pneumatic components.
Describe how your circuit operates to solve the problem.
Why is it important that the cylinder operates slowly in both directions?