1. Corning Cabelcon 1

2. 2 To begin with – we need some tools… Cable cutter Cabelcon RG11 Rotary Stripper Mounting tools Compression tool Please read the instructions before using the tools!

3. Corning Cabelcon 3 Let’s start to work… First step is to cut your cable using a proper cable cutter.

4. Corning Cabelcon 4 Strip your cable… Insert the cable into the cable stripper as shown… Attention: Please make sure to adjust the tool blades for your cable dimensions before using it for the first time! Please read instructions supplied with the tool. Screws for adjustment of blades Hex tool for adjustment

5. Corning Cabelcon 5 Strip your cable… Turn the stripper clockwise 4-5 times…

6. Corning Cabelcon 6 Strip your cable… - Press the tool jaws together around the cable and pull to remove the scraps…

7. Corning Cabelcon 7 Strip your cable… Optional: You can check the stripping dimensions against the guide printed on the connectors 6,5 + 6,5 mm (¼” + ¼”)

8. Corning Cabelcon 8 Prepare your cable… Fold exposed braid over the jacket. Leave the inner foil attached to the dielectric and make sure that the foil is undamaged and smooth. For ”Quad shield”, ”Tri shield” and ”Super shield” cables: Remove the outer braid and foil only. Fold back the inner braid.

9. Corning Cabelcon 9 Push the connector over the foil and allow the support mandrel to slide between the foil and braid… Mount the connector…

10. Corning Cabelcon 10 Press and turn until the pin is pushed forward and visible as shown. Mount the connector… Mounting tools can be used to ensure a better grip on both connector and the cable…

11. Corning Cabelcon 11 Compress the connector… 1) Insert your connector/cable into the tool with the tool handle in open position… 2) Apply a downward pressure on the cable to allow the split jaws to secure the cable… Click!

12. Corning Cabelcon 12 Compress the connector… - and close the tool handle completely insuring the connector sleeve is fully compressed.

13. Corning Cabelcon 13 Open the tool - press the outside split-jaw tabs and pull out the connector assembly… Take out the connector… CX3 RG7/11 Compression completed!

14. Corning Cabelcon 14 The inner conductor grip is very precise due to the movable pin system. You cannot miss it. Use your scroll mouse or the arrow keys to go forward and back… Insert cable This how the movable pin technology works…

15. Corning Cabelcon 15 Insert cable Use your scroll mouse or the arrow keys to go forward and back… This how the movable pin technology works… The inner conductor moves forward to indicate proper installation when the cable is pushed forward in place.

16. Corning Cabelcon 16 Use your scroll mouse or the arrow keys to go forward and back… Compression locks the cable and terminates the installation. This how the movable pin technology works…

17. Corning Cabelcon 17 Corning Cabelcon 17 Thank you for watching this instruction January 2008