1. Coil HQ12 CMM measurements (before testing in HQM01) R. Bossert/R. Riley March 16, 2011

2. Coil HQ12 186 mm from lead end looking from lead end Never tested Average azimuthal size = +39.5 mils Average radial size = +3.5 mils One square = 250 um (10 mils) Note: This position through saddle

3. Coil HQ12 186 mm from lead end looking from lead end Never tested One square = 100 um (4 mils) Special measurement to observe details of outside surface Note: This position through saddle

4. Coil HQ12 408 mm from lead end looking from lead end Never tested Average azimuthal size = +41.2 mils One square = 250 um (10 mils) Average radial size = +5.3 mils

5. Coil HQ12 408 mm from lead end looking from lead end Never tested One square = 100 um (4 mils) Special measurement to observe details of outside surface

6. Coil HQ12 476 mm from lead end looking from lead end Never Tested Average azimuthal size = +41.2 mils Average radial size = +5.7 mils One square = 250 um (10 mils)

7. Coil HQ12 476 mm from lead end looking from lead end Never tested One square = 100 um (4 mils) Special measurement to observe details of outside surface Note: This position at drilled hole

8. Coil HQ12 630 mm from lead end looking from lead end Never Tested Average azimuthal size = +42.4 mils Average radial size = +8.1 mils One square = 250 um (10 mils)

9. Coil HQ12 630 mm from lead end looking from lead end Never tested One square = 100 um (4 mils) Special measurement to observe details of outside surface

10. Coil HQ12 742 mm from lead end looking from lead end Never Tested Average azimuthal size = 42.8 mils Average radial size = +7.9 mils One square = 250 um (10 mils)

11. Coil HQ12 742 mm from lead end looking from lead end Never tested One square = 100 um (4 mils) Special measurement to observe details of outside surface Note: This position at drilled hole

12. Coil HQ12 868 mm from lead end looking from lead end Never Tested Average azimuthal size = 42.1 mils Average radial size = +7.2 mils One square = 250 um (10 mils)

13. Coil HQ12 868 mm from lead end looking from lead end Never tested One square = 100 um (4 mils) Special measurement to observe details of outside surface

14. Coil HQ12 1143 mm from lead end looking from lead end Never Tested Average azimuthal size = 38.2 mils Average radial size = +1.7 mils One square = 250 um (10 mils) Note: This position through saddle

15. Coil HQ12 1143 mm from lead end looking from lead end Never tested One square = 100 um (4 mils) Special measurement to observe details of outside surface Note: This position through saddle

16. HQ12 coil size (coil measured before testing) Size in mils (in. x 10 -3 ) over nominal Coil No.Lead EndBodyReturn End HQ1239.5 mils41.9 mils38.2 mils