Presentation is loading. Please wait.

Presentation is loading. Please wait.

General Information Date OK / NG Approved by 105.6mm 17.0mm 79.2mm

Similar presentations


Presentation on theme: "General Information Date OK / NG Approved by 105.6mm 17.0mm 79.2mm"— Presentation transcript:

1 General Information Date OK / NG Approved by 105.6mm 17.0mm 79.2mm
Client : William-US Cavities : 1+1 Machine size (tonnage): 150 Tons Mold #: PM008 Hot runner : No Cavity Steel: 738H Part name : DT-CASE Gate type : Sub gate Core Steel: Part No: JKD2008-1 Quantity of gate: 1 Slider steel: N/A General thickness : 2.5 mm Tool type : 2-Plate mold base steel : S50C Plastic material : ABS Surface Finish: TBD DFM by: Ryan Shrinkage: 0.5% Slider Qty : Approved by: Peter Part weight : 21.0 Grams Lifter Qty : Revision A

2 Parting Line Date Cavity PL Core OK / NG Approved by
Please confirm the parting line, see green line.

3 Gate Location Date Gate Location OK / NG Approved by Sub gate here,
please confirm if you can accept gating point here. 2

4 Draft angle information
OK / NG Approved by Date Draft Angle No draft angle on green surface, we need to put 1 degree for releasing the part from the mold.

5 No sliders needed for this part.
OK / NG Approved by Date Sliders No sliders needed for this part. Plastopia Molding Limited

6 No lifters needed for this part.
OK / NG Approved by Date Lifters No lifters needed for this part. Plastopia Molding Limited

7 Ejector Pins Marks Date OK / NG Approved by
Ejector pins marks will be left on the part, please confirm.

8 Wall thickness Analysis-1
OK / NG Approved by Date Wall thickness Analysis-1 Too thick on pointed areas, which will cause sink marks. Suggest to core out some material

9 Wall thickness Analysis-2
OK / NG Approved by Date Wall thickness Analysis-2 Too thick on pointed areas, which will cause sink marks. Suggest to core out some material Plastopia Molding Limited

10 Modification Suggestion-1
OK / NG Approved by Date Modification Suggestion-1 What’s function for the thin material? For ultrasonic welding? If not, we suggest to remove them and make flat surface for better molding Plastopia Molding Limited

11 Modification Suggestion-2
OK / NG Approved by Date Modification Suggestion-2 Difficult to machine these radius-red surfaces. Can we remove all radius on the top of ribs? Plastopia Molding Limited

12 Please specify the texture or engraving.
OK / NG Approved by Date Surface Finish Please specify the texture or engraving.

13 OK / NG Approved by Date Mold Layout


Download ppt "General Information Date OK / NG Approved by 105.6mm 17.0mm 79.2mm"

Similar presentations


Ads by Google