1. Fencing Options for Your Grazing System
2013 Georgia Grazing School
John W. Worley

2. Fencing Systems Plan the system before building
Choose the right materials
Use the right construction techniques
Don’t let a “temporary fence” turn into a high maintenance permanent fence

3. Types of Fences
Field Fence (Page wire, hog wire, woven wire) w/ barbed wire at top
Perimeter and baby calf areas
Note the long spacing between line posts, which is possible because high-tensile steel wire is used. Note also that the steel posts are galvanized.

4. Types of Fences Barbed wire Where electric doesn’t work well
Swampy, heavily vegetated areas

5. Types of Fences Electric (Note vinyl coated wire)
This poor quality photograph illustrates what a fence might look like to an animal and shows how the fence is much more visible because of the vinyl-coated wire.

6. Wire Types Steel (Standard or High Tensile)
Single, barbed, woven
Galvanizing (Class I or Class III)
Vinyl Coated (including conductive)
Electric Tapes and Ropes
Temporary
Permanent
High-tensile, Class III galvanized wire gives you the most strength and durability for your money. It’s one drawback is that it is harder to work with. It doesn’t bend easily and requires wire cutters that are designed to cut the hard steel.

7. Post Types Wood Steel (Painted or Galvanized)
Treated (at least 0.6 lb/ft3) Ground Contact
CCA is preferred
Untreated (Landscape Timbers are untreated or lightly treated)
Steel (Painted or Galvanized)
Plastic (Temporary electric)
Fiberglass
Sucker Rod (High Density FG)

8. Materials Perimeter Fencing Cross Fencing
Recommend High Tensile, Class III galvanized wire
Galvanized Steel or Treated Wood Posts
Class III galv. staples (1 ¾”)
Cross Fencing
If truly temporary, use plastic posts and electric rope or tape
High-tensile, Class III galvanized wire gives you the most strength and durability for your money. It’s one drawback is that it is harder to work with. It doesn’t bend easily and requires wire cutters that are designed to cut the hard steel.

9. Components with Similar Lives
Painted Posts with Class III galvanized wire

10. How Long Will It Last?
Painted Posts with Class III galvanized wire

11. How Long Will It Last?
Galvanized Posts with Class I galvanized wire

12. How Long Will It Last?
Galvanized Posts with Class I galvanized wire

13. How Long Will It Last?
Painted Posts, Class I woven wire, Class III barbed wire

16. Fence Chargers (Controllers, Energizers)
Look for Low-Impedance charger
Look for ratings at different loads (ohms)
50,000 ohms (fence in good condition)
5,000 ohms
500 ohms
100 ohms (fence in poor condition)
At least 1000 ohms

17. Cost per Mile

18. BRACES and INSTALLATION

19. H Brace Strongest Brace Top member 2 to 2 1/2 x height of fence
Brace transfers the load from the top to the bottom of the corner post.
Top member length keeps brace wire at a desirable (low) angle which helps keep corner post from being pulled up.

20. Pinning Braces Min. 8 ft. Min. 3 ft.
Galvanized pins will keep top brace from coming loose over time.
Min. 3 ft.

21. Pinning Braces 3/8” Galvanized Rod
Pin makes a good support for brace wire.

22. Installing Brace Wire
Allow wires to slip

23. Installing Brace Wire Tensioning the wire brace
Note that two high-tensile wires are sufficient for most any corner assembly.

24. Dead-Man Brace Need Larger Post Not as Strong Easier to Build
“Dead Man” should be about a 4-ft. post buried perpendicular to the corner post.

25. Stapling Technique Leave Wire Loose Only Horizontal Wires
Rotate from Vertical (Rotate away from slashes)
Right for right-handed staples
Left for left-handed
1 3/4” Galvanized Staples

26. Post Installation Driven wooden posts are stronger
Drive Small End Down

27. Post Installation
Proper Tamping Procedure

28. Electric Fence Grounding
Proper grounding of charger is vital
3 or more 8-ft rods
10 ft apart
Separate from other electrical grounds
Drive and connect all rods
Never Concrete Over
Ground Alternate Wires

29. Lightning Protection Good grounding is essential
Nothing is “Lightning Proof”
Use devices sold by charger manufacturer to maintain warranty

30. Lightning Protection “Choke” and “Lightning Arrestor”
Separate (Better) Grounding System
Protect Source side as well as fence side
Protection at Power Source
Choke
Energizer
Lightning
Arrestor
Cut-out
Switch
Energizer
Ground
Lightning Ground
8-ft Rods
At least
50 ft
10-ft apart
10-ft apart

31. QUESTIONS ?