1. Deconstructing a Hubsan and Rebuilding
Build Your Quadcopter
Deconstructing a Hubsan and Rebuilding

2. Hubsan and New Parts

3. Hubsan Parts Parts you will reuse Propellers 4 Motors 4
Flight controller board 1
Parts you will NOT reuse
Camera 1
Propeller Protector 1
Black rubber feet protectors 4
Battery Mount 1
Lights 4
Top and bottom of frame
Various small screws

4. New Parts Carbon Fiber X frame 1 White Motor Mounts 4
Black Carbon Fiber base 1
White Risers 4
Small Black Screws 4
Small Black Nuts 4
Small clear rubber bands 4
Propeller Remover Metal 1
Rubber Bands 2

5. Disassemble Hubson Using metal tool remove 4 propellers
Pull off propeller guard protector
Pull off rubber feet 4
Loosen 2 tiny screws on bottom of quad
Break 4 landing legs by pulling straight down behind the motors
Remove 4 screws from battery mount
Pull out battery mount
Pull camera out of front hole.

6. Keep Disassembling
Remove 2 screws that hold flight controller to frame
Use pointed tool to loosen colored motor wires and light wires (copper wire) and gently pull them out
Remove 4 motors carefully by using pliers and pulling up and twisting carefully. The motors are also magnets
Take to Bob do unsodder and resodder
You are now down with disassembly.

7. Assembling New Quadcopter
Attach double sided tape square to X frame
Clean out 4 white motor mounts with pick if necessary
Attach 4 white motor mounts to frame
Insert 4 motors. Motors have 2 different sets of wires. These need to be diagonal to each other
Press Flight Controller (FC) onto double sided tape.

8. Keep Assembling
Push motors through motor mounts until flush. Avoid touching the flight controller board
Take large rubber band and stretch over flight controller twice
Put large rubber band around base until it fits snugly
Take 4 long black screws and insert in each corner of base
Screw 4 white spacers over each black screw
Slide tiny white rubber bands over motor mounts to hold wires in place. Slide to middle of frame arm

9. Almost Done
Slide base through 4 holes on frame and secure with tiny black nuts onto black screws.
Identify propellers by A and B.
Attach propellers to correct spots.
Insert battery on top of quadcopter under rubber band
Plug battery in
Go flying!

10. All Done!