1. Promethean Board Functionality Orientation
How to connect your Connected Classroom and start working

2. Locate Your Equipment
For Each JPPSS Connected Classroom Promethean installation, a Projector Bag with Required Video and Data Cables, Projector Remote control, ActivStudio software, and ActivPens(2) inside.

3. The Bag

4. Video Cable
The Bag contains a 6 foot and a 25 foot Video Signal Cable that connects the laptop/desktop to the projector. Cable length is for convenience and both do the same duty

5. Projector Remote
To turn the projector on. Point the remote and press the green button.
The Dell remote control turns your projector on and off. It can also be used to momentarily hide the viewable image.
Point at the black remote sensors located on the front and back of the projector.
A single blue blinking light indicates electrical power to the projector.
The remote has turned the projector on when all lights turn blue.

6. Connecting Video
Connect one end of the cable to the Video connector located near your board (left or right or sometimes below the board.
Do not over tighten thumbscrews

7. Connecting Video cont’d
Connect the cable to the back of your laptop
On Dell Laptops, Press and hold FN then press F8
The Laptop cycles from LCD only, to LCD+Projector, to Projector only by pressing F8
The Projector will auto detect RGB(VGA) signal and display your desktop on the board
Be patient while it searches! It may take a minute or two.
SECOND Briefly hit key
FIRST Press down and hold key

8. USB Data Cable
2 Portable cables are provided to make one continuous signal from Laptop and Promethean Board
A 1 foot USB A plug to USB A plug cable must be connected to the wall plate.
A 15 foot USB A PLUG to A Jack cable completes connection from the 1ft cable to the laptop.
1 foot USB Short CABLE
15 foot USB Active repeater LONG CABLE

9. USB Data Cable Cont’d IMPORTANT Connect USB in this exact manner
Connect 1 foot cable to Wall plate

10. USB Data Cable Cont’d Wait 5 Seconds then move to next Step
With laptop on, connect USB A plug of 15 foot data cable to your laptop
Wait 5 Seconds then move to next Step

11. USB Data Cable Cont’d
Connect fat end USB A jack of long Cable to the 1 foot USB plug end of short cable at Wall plate.

12. USB Data Cable Troubleshooting
If ActivStudio icon on taskbar of computer does not change and has a red X, keep the cable arrangement.
Disconnect the power to the board, restart the computer, and once the computer starts, reconnect power to board.
Red X indicates no connectivity

13. ActivPen
The ActivPen is a stylus used to calibrate the video image with the board and also to interact with ActivStudio content

14. Promethean Board Use
A fixed projector installation has already been calibrated to the Promethean board so further calibration is not necessary.
If your ActivPen does not move your mouse when touching or moving across the board, your board may have lost calibration.
To calibrate your board from the computer, right click the Activboard icon on your taskbar, select calibrate and follow the onscreen prompts.
Refer to ActivStudio Training Documentation for further information

15. Promethean Planet
If you to get a jump start until your training, you can go to: