Standard Little League Field

Slides:

Advertisements

Similar presentations

WELCOME TO ASA UMPIRE TRAINING 1 AND 2 UMPIRE

Advertisements

Low Cost Little League Field  Pro’s Choice Sportsfields Products.

Working the Line. Definition RULE 1-2 ART A diamond (or infield) shall be a 90-foot square. When measuring the distance to first base and third.

2 MAN MECHANICS. F3 F4 F7 F8 F9 F5 F6 F1 F2 U1 P BR R1 R3 R2 Defense F1 – Pitcher F2 – Catcher F3 – 1 st Baseman F4 – 2 nd Baseman F5 – 3 rd Baseman F6.

Test Questions- Review

The Basics of Baseball for middle school physical education class’s

Geometry in Baseball By Zach Hand. Collinear points Collinear points are points that are on the same line. First base and home plate are on the same foul.

 1791 was the first mention of baseball because it was banned from being played with 80 yards of town hall in the state of Massachusetts.  Believed.

Baseball is a bat and ball sport played between two teams of nine players each. The goal is to score runs by hitting a thrown ball with a bat and touching.

WORLDWIDE HANDICAP SYSTEM Fixed Elements. The goal was to build, as far as possible, a more strict single system of fixed elements, before accepting the.

Baseball Mechanic Tutorial This is a basic system, more detailed mechanics will be covered in the meetings. The following tutorial is for baseball 2 man.

Baseball Mechanic Tutorial The following situations are meant to serve as a guide based on the field mechanic class All situations assume a normal fielder.

C. Dittmer Sept Girl’s Lacrosse Field Dimensions NOTE: While most dimensions of a girl’s field are flexible, the distance between the Restraining.

TWO UMPIRE SYSTEM POSITIONING AND MECHANICS. WHY CLASSROOM? When building a house, office building, bridge, etc., you first have to have a plan, written.

Base Running Awards. Definition Rule 2 section 2 page 15 Award is the right to advance without a play being made that is awarded. When bases are awarded.

This is a sequence shot of a home run by Albert Pujols off Roy Oswalt of Houston in the 2005 NLCS, both side and front views. You can start it by pressing.

How To Mark a Field. 4 May 06, Ver. 1.5How To Mark a Field2 Tools Required A long (150 yards) accurate tape measure with a ring on one end. A long (150.

POSITIONING AND MECHANICS

Presented by: Baseball Mechanics Clinic Plate Mechanics.

ASA UMPIRE TRAINING 1 UMPIRE FP & SP 2-UMPIRE FP.

WCWAA Coaching Reference Guide. WCWAA Baseball Contact List Quick Reference; Some tips on how to run a great practice or general pointers on how to coach.

Topographical Maps.

PU U1 U3 C C Pre-game Conference Both teams shall remain in their dugout/bench or bullpen area until pre-game conference has concluded Discussion: Verify.

5-8 Year Old Baseball Mechanics Pause – Read - React Position 1 Umpire Mechanics Hustle.

EXAMPLE 4 Solve a multi-step problem A softball field forms a sector with the dimensions shown. Find the length of the outfield fence and the area of the.

Some of the Basic Rules of Girl's Lacrosse The Game: Girls' lacrosse combines individual skills and team performance. Keeping possession is integral to.

2006 FHSAA State Field Clinic Hosted by Broward Baseball Umpires’ Association Broward County, Florida.

3 Man Mechanics Mechanics Manual 3 umpires 3 Man Mechanics

PUU1U3 Ladera Ranch Little League 3-Man Umpire Mechanics.

Legend Umpire Base Runner Batter Runner Batted Ball Thrown Ball Fielder Little League Baseball ®, Incorporated U1.

Baseball Taylor Brown. Baseball A baseball game is played by two teams who alternate between offense and defense. There are nine players on each side.

1.1c: Midpoint ,Segment Congruence, and Segment Addition

Mike Herrmann Audience: 6 th Grade Students  Major league baseball is composed of two leagues  National League present  American League –

Proper Field Maintenance Training Russiaville Youth Little League.

Information was gathered using kickball.com and kickballstrategies.com.

THREE UMPIRE SYSTEM POSITIONING AND MECHANICS. THINGS TO GO OVER IN PRE-GAME UMPIRE’S MEETING Down and set with runners on base. Who goes out if the ball.

RESPONSIBILITIES OF A SINGLE UMPIRE (Rule 10, Section 4) If only one umpire is assigned, his duties and jurisdictions will extend to all points. The umpire's.

Baseball Mechanic Tutorial The following situations are meant to serve as a guide based on the field mechanic class All situations assume a normal fielder.

A baseball/softball game is played by two teams who alternate between offense and defense. There are nine players on each side. The goal is to score more.

Introduction to Drafting and Design In order to begin our drawing we have to set the drawing limits or the paper size.

Johnny Fajardo. Statement of Problem In hitting for distance, which bat allows a farther hit, a wood one or a corked one.

Rookies, A & Minors Practice #1. Hitting 1. Teach the lower half of the swing 1. Stride – 3 Ss Short 4 – 6 inches Soft All toes on the ground Heel decidedly.

Four Umpire Mechanics Presented by: Brian Sonak District VI Rule Interpreter Centre County Chapter.

Warm-Up The infield of a baseball field is a square. The distance from home plate to first base is 90 feet. ◦ What is the distance from home plate to second.

Ohio High School Athletic Association 2 Man Mechanics 1.

Measurement. Introduction There are many different ways that measurement is used in the real world. When you stand on a scale to see how much you weigh,

1 SPECTATORS 15’ 18’ 42’ 24’ 22.5’ 28.5’ 24’ 120’ 22.5’ 46.5’ 75’ 103.5’ 127.5’ 150’ 3’ radius for Corner arcs 47.65’ 49.86’ ’ ’ 59.77’ 283’

Area of Triangles Section 5.6 The Area of a Triangle Using Trigonometry Therefore, we can find the area of a triangle if we are given any two sides of.

Miss Woodward’s Classes Softball. Softball - History Softball originated in Chicago on Thanksgiving Day, A group of about twenty young men had got.

Teknologi Dan Rekayasa

Rule 1.00 OBJECTIVES OF THE GAME.

University of Northwestern Baseball Pickoff Plays

Ohio High School Athletic Association

Rockers Windmill pitching Coach Joel Munson.

3 UMPIRE SYSTEM.

Texas East Volunteer Umpire Association

Angles And Distances.

Rule 1.00 OBJECTIVES OF THE GAME.

The Basics of Baseball for middle school physical education class’s

Gaskets and Packing An introduction to Gaskets Packing

3 UMPIRE SYSTEM.

6.00 The batter John watson.

Warm-up A Major League Baseball team is allowed to have 25 players. The ratio of pitchers to position players on one team is 2:3. How many position players.

Presentation transcript:

Standard Little League Field Not drawn to scale How to convert a standard Little League field to a Little League Intermediate (50/70) Baseball Division field

Standard Little League Field 200 feet or more 60 feet 46 feet Not drawn to scale This presentation will explain the step-by-step process of converting a standard Little League field, so that it can also be used for the Little League Intermediate (50/70) Baseball Division. A standard Little League field has base paths of 60 feet, and a pitching distance of 46 feet (measured from the back point of home plate to the front edge of the pitcher’s plate) . The distance from the back point of home plate to the outfield fence should be at least 200 feet, but not more than 275 feet, for a field that will be used for both the standard 46-60 Little League Division, and the Intermediate League.

Extending the “Skin” Area Grass to be removed Not drawn to scale Extending the “Skin” Area In this first section, part of the outfield grass is removed, which will extend the clay area of the infield.

Extending the “Skin” Area Stake goes here Not drawn to scale Extending the “Skin” Area Drive a stake into the ground at the center of the back edge of the pitcher’s plate.

Extending the “Skin” Area 69 feet Not drawn to scale Extending the “Skin” Area Extend the measuring tape (or 69-foot chain/rope) 69 feet until it intersects with one of the foul lines as shown.

Extending the “Skin” Area White Paint or chalk, 69 feet from back of pitcher’s plate Not drawn to scale Extending the “Skin” Area Using eco-friendly field marking paint or chalk, create an arc through the outfield grass to the other foul line, maintaining the 69-foot distance from the back of the pitcher’s plate.

Extending the “Skin” Area Remove Grass Not drawn to scale Extending the “Skin” Area Using a sod-cutter (ideally), remove the grass inside the arc. Replace soil with clay or infield mix.

New bases Not drawn to scale Adding New Bases The anchors for three new bases will need to be installed underground. First, second and third base at all levels are required to disengage their anchor.

The distances between bases for Intermediate League layout are shown. Distance from outside edge of first and third base to CENTER of second base: 70 feet. Distance from back point of home plate to outside edge of first and third base: 70 feet Not drawn to scale Adding New Bases The distances between bases for Intermediate League layout are shown.

The distances between bases for Intermediate League layout are shown. Distance from back point of home plate to CENTER of second base: 99 feet. Not drawn to scale Adding New Bases The distances between bases for Intermediate League layout are shown.

Dis-engageable base Ground level Low-profile rubber pad Metal sleeve Metal post Concrete anchor Not drawn to scale Adding New Bases The base must dislodge from its anchor. One style of such a base is shown above in cutaway view. The low-profile pad (shown in red) is at ground level, so it can be left in place while the dis-engageable base is removed. This permits the bases to be moved back and forth as needed, so that the field can be used for either 46-60 games, or Intermediate League games.

Modifying the Pitcher’s Mound Not drawn to scale Modifying the Pitcher’s Mound The next step is to enlarge the pitcher’s mound and install a new pitcher’s plate.

Aligned with middle of second base Drive stake here Existing Mound (10 foot diameter) 48 feet, 6 inches Not drawn to scale Modifying the Pitcher’s Mound Remove the stake placed in the mound earlier. Now, drive that stake into the ground, centered on a line between home plate and second base, 48 feet, six inches from the back point of home plate. (It will be 18 inches back from the front edge of the existing pitcher’s plate.)

Tape measure, chain or rope (6 feet) New Mound (12 foot diameter) Tape measure, chain or rope (6 feet) Stake 000 Existing Mound (10 foot diameter) Not drawn to scale Modifying the Pitcher’s Mound Using a tape measure or pre-measured length of rope or chain (6 feet ), create a 12-foot diameter circle as shown. Contouring the mound, detailed on the next page, is not necessary if the infield is “crowned” so that the rise from home plate to the pitcher’s plate is gradual.

Modifying the Pitcher’s Mound Stake (48 feet, 6 inches from the back point of home plate) Front edge of standard Little League pitcher’s plate (46 feet from the back point of home plate) Front edge of Intermediate League pitcher’s plate (50 feet from back point of home plate) Level of home plate Second base 8 inches 6 inches Feet 1 2 3 4 5 6 7 8 9 10 11 12 18 inches from stake to front edge of intermediate League pitcher’s plate Not drawn to scale 30 inches from stake to front edge of standard LL pitcher’s plate Modifying the Pitcher’s Mound Contour the mound as shown above in a cutaway view, with a gradual/even degree of slope. Both pitcher’s plates for Little League Majors and the Intermediate League are 18 inches by four inches. (Shown from the first-base side of the infield.)

Modifying the Pitcher’s Mound Level area of 50-foot pitcher’s plate Level area of 46-foot pitcher’s plate 6 inches 4 inches 15 inches 11 inches 18 inches 18 inches 11 inches 15 inches 40 inches 48 inches 17 inches 30 inches Level of home plate Second base Feet 1 2 3 4 5 6 7 8 9 10 11 12 Not drawn to scale 48 inches from front edge of standard Little League pitcher’s plate, to front edge of 50-foot (Intermediate League) pitcher’s plate Modifying the Pitcher’s Mound Create level areas as shown above for the two pitcher’s plates. (Shown from the first-base side of the infield.)

Modifying the Pitcher’s Mound New Mound (12 foot diameter) 000 000 Pitcher’s plate for standard Little League field to be removed during Intermediate League games Optional landing area Not drawn to scale Toward home plate Modifying the Pitcher’s Mound The pitcher’s plate that is noted above must be removed during Intermediate League games. Also, an optional extended area may be added, to help prevent loss of grass in front of the mound. However, this area is not considered part of the mound.