CEMENT CURRING COMPOUND S-102.  Replacement Of Water Curring  Concrete Curing Product Used On Concrete Floors/Decks, Pavements, Vertical Applications,

Slides:

Advertisements

Similar presentations

DAY ONE - STEP ONE - Preparation Pure Crete is added to a water truck with a spray bar located at the rear of the truck at a ratio of one gallon to 2000.

Advertisements

2.13 SPECIAL CONCRETES Low Cost Light Weight Heavy Weight Underwater Ultra High Strength Ultra Durable Architectural Low Noise Reduced environmental impact.

ARC313 Building Code II. Review What is the minimum bearing pressure allowed for soils to support foundations? 75 kPa How can you tell by looking at the.

Civil Engineering Materials

Portland Cement and Concrete

Reference Concrete Sidney Mindess J. Francis Young Prentice-Hall, Inc Chapters 3 and 4.

CE-303-Lecture #1 Fundamentals of Concrete Objectives To explain the basic concepts of concrete To explain briefly the properties of freshly mixed concrete.

Walls Ron Gatepain constructionsite.

Concrete Man made stone. constituents u mixture of aggregate and paste u paste30 to 40% u portland cement7% to 15% by Vol. u water 14% to 21% by Vol.

Lecture 2 Design of Concrete Mixes and Properties of Fresh Concrete Dr Magnus Currie ENG-1010: Reinforced Concrete Design.

Curing and Protection of Concrete

PC Cement Hydration PCC consists of binder and aggregates. Aggregates are typically used in two factions: fines and coarse. The binder phase normally.

Lecture No. 8 Tests on Aggregates (cont.) Prepared by: Dr. Salah Al-Dulaijan.

EXAMPLE QUESTIONS According to their sizes, aggregates are divided into 2 main groups, write down the names of these groups and give one example for each.

Pervious Concrete Pavement …more than just pavement. What makes it different? What makes it work? What makes it fail?

WORKSHEET 4 CONCRETE. Q1 a) what are the two main properties that concrete must have? (i) strength b) how do we achieve them? by using an acceptable water.

Introduction Dr Magnus Currie From Scotland, UK MEng Civil Engineering

How long will your concrete bridge last?

Civil Engineering Materials

Strength of Concrete.

Development of Strength. Development of strength: development of strength after placing of concrete. Curing: It is the procedures used for promoting the.

CURING CONCRETE.

Concrete Dry Quantities examples in class Week 3.

An Najah National University Faculty of Engineering

 Single Component Products TT-P-1952E - Waterborne traffic paint TT-P-1952E - Waterborne traffic paint A-A-2886A - Solvent traffic paint A-A-2886A - Solvent.

Placing Quality Concrete

Factors that Affect the Rate of Chemical Weathering.

1 Leading Provider of Environmental Solutions. EarthSeal Nanotechnology solution to help retain the strength of road bases by adding significant water.

Meteorite 101 Cutting, Surface Preparation, Etching, and Preserving Iron Meteorites Prepared for AOAS By Leonard Lynch.

Chapter 12 Concrete Construction Part 3 1CE 417, King Saud University.

ADMIXTURES Department of Civil Engineering,

Chapter 3 Cement.

BondChem TECHNICAL DATA Roll-a-crete ( Three Component Cementitious Waterproof Coating ) Page 1 / 2. DESCRIPTION BondChem’s Roll-a-crete is a three component.

“Properties of Concrete” Introduction

Silver Oak College Of Engineering & Technology.

Prepared by: HARSH SONI SD What is curing of concrete? Curing is the maintenance of a satisfactory moisture content and temperature in concrete.

Plastic Shrinkage Cracking How to make sure it happens!

Hot-Weather Concreting. Detrimental Hot Weather Conditions  High ambient temperature  High concrete temperature  Low relative humidity  High wind.

I-99 HPC Initiative: Upcoming Work. Phase II Testing  25 Phase II Mixes –Control, silica fume, fly ash, slag, ternary, Aquron, Ipanex  Phase II Testing.

LECTURE NOTES-CHAPTER 8 CURING OF CONCRETE

Waterproofing by fine crystalline fibers inside the capillary pores By Naeem Sohail Saleem

PREPARED BY: MARCIA C. BELCHER CONSTRUCTION ENGINEERING TECHNOLOGY Concrete: Fundamentals.

University of Sydney – Structures CONCRETE Peter Smith 1998 Concrete Making and Testing l Unique material çMade specially for each job çHandling on job.

SESSION 9 Construction Considerations. Objectives  Describe key aspects of: Prepaving operations Paving operations Postpaving operations  Understand.

Durability of Concrete §4.5 Durability of Concrete Definition Importance of Durability Anti-permeability Freezing Resistance Carbonation /Neutralization.

AAR-410 January 14, FAA Airport Pavement Technology Program u National Airport Pavement Test Facility, FAA William J. Hughes Technical Center, Atlantic.

The Earth’s Atmosphere: Factors That Affect the Weather SOL 6.6.

–Mineral Admixture –Ordinary Portland Cement (P.O) –Portland granulated Blast-furnance-slag Cement (P.S) –Portland-Pozzlana Cement (P.P) –Portland fly-ash.

Hot Weather Concreting

ADHESIVES. TWO MAIN INGREDIENTS – RESIN – GLUE SOLID SOLVENT – KEEPS LIQUIFIED UNTIL APPLIED.

Curing Definition The process of prevention of loss of moisture from fresh concrete while maintaining satisfactory temperature regime (BS 8110) Fig: The.

GURU NANAK DEV ENGINEERING COLLEGE, LUDHIANA Submitted to RESPECTED.C.S. SINGLA SIR (GNDEC) Submitted by Submitted by: Salman Khan Univ. Roll No

INTRODUCTION Plastic shrinkage cracking occurs when the concrete is in the plastic state, which is within the first 24 hours. Plastic shrinkage cracks.

Welcome To Astec Paints Paint With Pride

Concrete Man made stone.

CONCRETE TECHNOLOGY.

CONCRETE CHEMICALS & APPLICATIONS

Chemical Admixtures In Concrete

Design and Control of Concrete Mixtures CHAPTER 18

What are Admixtures? Admixtures are the material, other than Cement

Under the Guidance of Prof. Jayashree Sengupta

Supervised by Dr. Sami Hijjawi Prepared by Hamza Saifan

ADMIXTURES???? Materials added to the concrete besides cement, water and aggregate. To improve the properties of the concrete required. Admixtures can.

Chemical Admixtures In Concrete

Best Paint Options for a Concrete Around Pool By: Authentic Plastic and Tile

Silica Fume and Fly ash 5 minute Flash Mohamed Wagih

Influence of properties of coarse aggregate

Presentation transcript:

CEMENT CURRING COMPOUND S-102

 Replacement Of Water Curring  Concrete Curing Product Used On Concrete Floors/Decks, Pavements, Vertical Applications, Structural Concrete, Bridges And Precast Elements.  Water‐based Sodium Silicate Solution.  Clear Solution. Can Be Produced In Red Colour Using A Dye.  Non‐film Forming Reactive Curing Material  Requires No Mixing, Dilution Or Agitation  S‐102 Has An Indefinite Shelf‐life

 Sodium silicate reacts with hydrating cement products to produce additional gel at or very near concrete surface.  Added gel fills and blocks the channels responsible for moisture escape from the  concrete surface.  Preserving more moisture reduces surface tension responsible for plastic shrinkage cracking.  Prevention of moisture loss maintains high relative humidity inside the concrete.

 Applied earlier than other curing products.  Mitigates plastic shrinkage cracking.  Very effective in hot, dry or windy environment  Excellent surface finishing aide.  Produces less permeable more durable surfaces.

 Surface is available for foot traffic as soon as the surface is dry without affecting the cure.  If red dye is used the colour will last for 4‐5 days then it will dissipate.  Surface is compatible with all topically applied materials without extra preparation.  Surface is paintable in 5 days.

 Applied earlier than other curing products.  Mitigates plastic shrinkage cracking.  Very effective in hot, dry or windy environment  Excellent surface finishing aide.  Produces less permeable more durable surfaces.

 Water is prime and major factor for curing, the availability of water resources at sight to provide curing in High Rise Buildings, Curvature, Cross Corner designs, Bridges, Pools etc. are now days very tough and costly too. It’s also needs day to day curing perfection including labour engaged on sight. Also in some of the area the pure water is not available, the water like in Mumbai is salty “KHARA PANI” affecting the strength of iron bars and concrete is major factor.

 Sinak S-102 is replacement of water curing method with almost same strength and quality as per idle standards of water curing saves the labour cost, supervision on sight, blocking of other related equipments till 7 days of curing not completed, including the WATER- A nature Resources.

 Help nature by preventing this endless uses of water resources by replacing the SINAK S-102.  Let us Join hands to make India Green by stopping Natural water sources utilisation for curing.