MODULE 4 PATTERN MAKING TOPIC 5 DRAFTING METHOD CENTER OF EXCELLENCE APPERAL SECTOR

PURPOSE  TRAINEES WILL LEARN ABOUT DRAFTING METHOD.  TRAINEES WILL LEARN ABOUT PERFACTION.

INTRODUCTION  A SHEDED OUT LINE OF THE BODICE HAS BEEN SUPERRIMPOSED ON THE DRAFT TO ILLUSTRATE VISUALLY THE PURPOSE OF DEVLOPMENT DRAFT USING THE BODY MEASUREMENT.  A SYSTEM OF PATTERN MAKING THAT DEPENDS ON A SERIES OF FORM OR FIGURE MEASUREMENTS TO COMPLET THE PAPER PATTERN.  IT IS THE BASIS FOR THE FLAT PATTERN MAKING SYSTEM, THE BASIS PATTERN MUST BE PERFECTED TO ELIMINATE ALL ERROR THAT COULD BE PASSED ON TO EACH NEW DESIGN BASED ON IT.

QUESTIONS  WRITE ABOUT DRAFTING METHOD  WRITE ABOUT BASIC BLOCK OF UPPER TOURSSO  WRITE ABOUT BASIC BLOCK OF LOWER TOURSSO

CONCLUSION  TRAINEES LEARNT ABOUT DRAFTING METHOD.  TRAINEES LEARNT ABOUT PERFACTION.