WSPS Cutter WSPS Deflector Flash Suppressor Gun Barrel Recoil Dampener Chamber Access Door Gun Drive Motor Flex Chute Gun Cradle Utility Hydraulic Line.

Slides:

Advertisements

Similar presentations

Unit C: Agricultural Power Systems

Advertisements

B757 Review Questions.

2009 / 03 NOTE Year / Month T1003/T903 FIG 101 ALTERNATOR GP-CHARGING 4 P1.

737 PNEUMATICS MENU PRINCIPAL.

the Engine Starting systems.

C130 Fire Systems Part 2 This lesson covers the Fire Detection

Ignition System Provides a method of turning a spark ignition engine on & off. Operates on various supply voltages (Battery & Alternator) Produces high.

Engine Systems and Components

1B-1 Fire Engine Maintenance Unit 1B – Pump Inspections and Maintenance.

KLINGE’S NMR 262 Two Independent Systems Integrated into one Unit This Requires Special Features:  Total Redundancy of Refrigeration Components  Total.

Leak Checks Shall Be Conducted By IP’s prior to the first flight of the day, during crew changes, and while serving as Site Watch By Solo SNA’s prior.

Avionics Bay. Junction Box Avionics Bay Slaving Accessory Recieves inputs from the flux detector in the left wingtip and the directional gyro. Computes.

Simple Carburettor Fuel System for a Piston Engine

B757 Review Questions.

GD150 Liquid bulk contactless compressor. GD150 Compressors.

TH-57 Transmission / Hydraulic Review

ELECTRONIC FUEL INJECTION COMPONENTS

Engine Information & Engine Components and Systems.

Engine Compartment Left Side. Oil-to-Fuel Heat Exchanger.

Propellers The engines are equipped with four bladed, full

Gas Turbine Theory and Construction

Reservoir 0.6 Gal HYDRAULICS Engine Driven Pump NWS ± 12 o 3 Gear 6 sec Doors SB 70 o Flaps 23 o / 50 o Chk Valve Filter 3500 PSI Release Helium Hyd Fl.

Instructor: CW2 Scott Paul Rogers

CH-47D Auxiliary Power Unit

Section 703 Apparatus Inspection. Procedures The driver/operator should follow a systematic procedure for inspecting apparatus This ensures that all important.

Idea Development TTTTo have a Better Understanding of How Mechanically a Helicopter Flies IIIIntrigue of part design AAAA chance to better.

Weekly Checks Monday – VSP Room Tuesday – Pilothouse System Controls Wednesday – Starboard / Engine Room Thursday – Foam Room Friday – Port / Engine Room.

CLM Maintenance. Covers : 1 - Side cover, 2 - Back cover, 3 Top cover, 4 - Lamp door, 5 - Side cover input and communication side, 6 - HEPA dust filter,

Red/Green Fire Fighting Systems Fi Fi Mains ●Red System: Port Side Fire Main supplies two Monitors. M7 (6000) gpm on centerline on the fwd Wheelhouse top.

1. Gear housing 2. Engine dataplate 3. Air intake 4. Fuel pump 5. Fuel filter 6. Starter 7. Lube oil pan 8. Lube oil drain 9. Crankshaft timing pin port.

Period 7.   The more curved side generates low air pressures, due to more surface area. While high pressure air, pushes on the other side of the design.

F35 Program Information Non Export Controlled Data – Releasable to Foreign Nationals © 2007 Lockheed Martin Corporation Chuck Meyer 3/24/07 CV – CDR –

MAIN DRIVE SHAFT The main drive shaft consists of a flanged hollow shaft with flexible splined couplings. This assembly is installed between the freewheeling.

Initial Pilot Ground School Tail Rotor Drive System

FLIGHT CONTROLS AND HYDRAULICS. FLIGHT CONTROLS The flight control systems are mechanical linkages, actuated by conventional controls, and are used to.

Initial Pilot Ground School

FUEL SYSTEM The fuel system is comprised of three interconnected crash resistant fuel cells. Two forward fuel cells are located under the aft facing passenger.

TM dated 31 OCT 96 Current Change #3 dated 30 OCT 98 UH-60A Preflight Procedures.

Chapter 5 Light vehicle engine systems © Pearson Education Ltd Copying permitted for purchasing institution only. This material is not copyright.

UH-60L FAMILIARIZATION CW4 Sandbakken

UH-60 IPC/MOI CW2 JAMES THOMAS.

The General Electric T-700

BASIC AUTOMATIC CONTROLS UNIT 16 ADVANCED AUTOMATIC CONTROLS

UH-60A/L Fuel System.

T700 System Overview UH-60 IPC CW4 Jim Hill.

Tractor Safety, Operation, and Maintenance

CW2 Scott Turvey UH-60 IPC UNCLASSIFIED

IN THE NAME OF ALLAH, THE BENEFICENT, THE MERCIFUL

250-C20J Engine System.

Ignition System Provides a method of turning a spark ignition engine on & off. Operates on various supply voltages (Battery & Alternator) Produces high.

Produced By James Benson

Tractor Safety, Operation, and Maintenance

Fuel-Injection Systems

CYLINDER BLOCK GROUP FIG 101

TH-57 Transmission / Hydraulic Review

Leak Check Training.

An OVERVIEW ON AUTOMOBILE ENGINEERING

Propeller Based Propulsion

Small Engine Parts I.D.

Tractor Safety, Operation, and Maintenance

TH- 67A PRE-FLIGHT FOR BEGINNERS.

DANGER DANGER DANGER INTAKE DANGER INTAKE DANGER DANGER DANGER R R E E

Engine Removal, Disassembly, Inspection, and In-Chassis Repairs

Two Common Types of EFI Chapter 22 Lesson 3.

Ignition System Provides a method of turning a spark ignition engine on & off. Operates on various supply voltages (Battery & Alternator) Produces high.

Fuel-Injection Systems

Presentation transcript:

WSPS Cutter WSPS Deflector Flash Suppressor Gun Barrel Recoil Dampener Chamber Access Door Gun Drive Motor Flex Chute Gun Cradle Utility Hydraulic Line Elevation Actuator Gun Cannon Plug

Side Loader / Magazine Controller Display Processor #2 Communications Interface Unit Weapons Processor #2 Gun Control Box Turret Control Box ECS Filter PNVS Electronic Unit Sight Electronics Unit Display Electronics Unit Flight Management Computer Electronic Load Center #2

Rounds Counter / Magazine Controller Side Loader

Fuel Filter Inlet Anti-ice Valve Anti-ice/Start Bleed Valve Anti-ice Temp Sensor Liquid to liquid cooler Overspeed Drain Valve Air Particle Separator Fuel Pressure Sensor Fuel Filter Impending Bypass Button Thermocouple Harness Fuel Line Oil Sight Gauge Anti-ice Switch Overspeed Cable Fuel Bypass Sensor

Fuel Line History RecorderAir Turbine Starter Oil Temp Sensor (not connected) Oil Pressure Sensor Alternator Oil Bypass Switch Oil Filter Chip Detector Oil Pump Fuel Pump Liquid to Liquid Cooler Hydro-mechanical Unit Overspeed Drain Valve Power Available Spindle Air Particle Separator

Fuel Line Oil Temp Sensor (not connected) Oil Pressure Sensor Alternator Oil Filter By-pass Switch Oil Pump Oil Filter Chip Detector Fuel Pump Liquid To Liquid Cooler Air Turbine StarterHydro Mechanical Unit Overspeed Drain Valve Oil Filter Bypass Button Fuel Filter Bypass Button Oil Cap Fire Louver Doors B Sump Sense Line

Rotating Swash Plate Pitch / Change Link Scissors Assembly Non-rotating Swash Plate Static Mast Pitch Housing Main Rotor Dampener Spherical Bearing Droop Stop Ring Droop Stop Retainer De-rotational Unit Toque Link Lateral Link Ice Detector Sensor Strap Pack Hub Tug

Fine DF Sensors Course DF Sensor Course DF Sensor Course DF Sensor

Engine Cooling Louvers Engine Fire Doors Fire Bottle Discharge Disk AN/AVR-2 LASER Detector ALQ-144 IR Jammer ADS Boom Left Avionics Bay Fan Position Light Engine Nacelle

System Processor #2 Low Power Radio Frequency Generator ECS Filter Battery Battery Charger

Video Recorder Load Maintenance Panel Radar Altimeter Avionics Bay Fan Fuel Boost Pump Access Cover FM#1FM#2 Fill Port Diplexer Singars Battery Box VHF Radio IFM Amplifier NIU Bit Indicator & Test Button ADF Turbine Speed Controller

Tail Wheel WSPS Deflector Tail Landing Gear Strut Stabilator Actuator Tug Tail Wheel Unlock Switch Tail Wheel Unlock Handle

Pitch Change Link Directional Servo Static Mast Non-rotating Swashplate Rotating Swashplate Fork Assembly Capped De-ice Cannon Plug Elastomeric Bearing Drive Links

Chaff Module Chaff / Flare Mode Switch Lower Transponder Antenna Chaff Safety Pin Hole

Lower Transponder Antenna APR-39 C/D Blade Antenna UHF Radio Antenna

FM#2/VHF Antenna Doppler Antenna Fairing Survival Kit Bay Left Aft Avionics Bay Radar Altimeter RECIEVER Antenna Radar Altimeter XMTR Antenna

AN/AVR-2 Processor KY-58 UHF Radio APR-39 Processor

ALQ-144 IR Jammer ALQ-144 IR Jammer Access Panel AN/AVR-2 LASER Detector AN/AVR-2 LASER Detector Toque Link Non-rotating Swash Plate Rotating Swash Plate Lateral Link Longitudinal Bellcrank Canopy Defog Line Ice Detector Sensor Line

#3 Drive Shaft NR Reference SDC Cover Plate Fuel Crossfeed Line Power Available Cable Load Demand Cable AFT Deck Fire Sensor Transmission Cooling Line Rotor Brake #7 Drive Shaft Accessory Gearbox By-pass Button

APU Cover APU Controller APU Fuel Controller

Transmission Cooler Reserve Fire Bottle Primary Fire Bottle Squibs NR Reference Fuel Air Pressure Regulating Valve Fire Bottle Diverter Valve Fire Louver Actuator IPAS Pre-cooler Bypass Valve Pre-cooler Thermostat “Bleed Air Hot” Switch Lower Transponder Antenna Cable )

ECS DCU#2 PAS Manifold Tail Rotor Bellcrank Reserve Fire Bottle Primary Fire Bottle Fire Louver Actuator ECS DCU#1 Pre-cooler Thermostat

Spherical Bearing Blade Retention Pin Lead / Lag Link Main Rotor Dampener Blade Blade Weights Pitch Housing Rotating Swash Plate Pitch Change Link De-rotation Unit Hub Ice Detector Sensor

Strap Pack Hub Scissors Assembly Droop Stop Retainer Droop Stop Ring Static Mast Spherical Bearing Pitch Change Link Droop Stop Pitch Change Link

Programmable Signal Processor RFI Processor User Data Module

LASER Electronic Unit TADS Electronic Unit TADS Power Supply Electronic Load Center #1 ALQ-136 Processor Lighting System ControllerSystems Processor #1 Improved Data Modem