Kirchhoff part 2. Starter 1.5Ω Learning objectives State Kirchhoff’s second law Apply Kirchhoff’s second law to circuits Solve circuit problems involving.

Slides:



Advertisements
Similar presentations
Unit 3 Day 5: EMF & Terminal Voltage, & DC Resistor Circuits Electromotive Force (EMF) Terminal Voltage Internal Resistance Series, Parallel, and Series-
Advertisements

+ V (Volt) = W (work done, J) Q (charge, C)
More Circuit Calculations Electricity Lesson 9. Learning Objectives To know how to calculate the total emf and the total resistance for cells connected.
Kirchhoff’s laws. Kirchhoff’s laws: current law: voltage law: Equations.
Fundamentals of Circuits: Direct Current (DC)
Monday, Mar. 6, 2006PHYS , Spring 2006 Dr. Jaehoon Yu 1 PHYS 1444 – Section 501 Lecture #12 Monday, Mar. 6, 2006 Dr. Jaehoon Yu EMF and Terminal.
DC Circuits Resistors in Series and Parallel resistor: resistors connected in series: battery: + - V R A B Put your finger on the wire at A. If you can.
DC circuits Physics Department, New York City College of Technology.
Chapter 26 DC Circuits. I Junction rule: The sum of currents entering a junction equals the sum of the currents leaving it Kirchhoff’s Rules.
Parallel Resistors Checkpoint
Electric current and direct-current circuits A flow of electric charge is called an electric current.
Series Circuits AKA Voltage Dividers Cardinal Rules for Series Circuits Potential difference is divided proportionately amongst each of the resistors placed.
Electricity and Magnetism Topic 5.2 Electric Circuits.
Lecture 6 Direct Current Circuits Chapter 18 Outline Energy Source in Circuits Resistor Combinations Kirchhoff’s Rules RC Circuits.
Chapter 28 Direct Current Circuits 1.R connections in series and in parallel 2.Define DC (direct current), AC (alternating current) 3.Model of a battery.
MHS Physics Department AP Unit III C 2 Steady state direct current circuits with batteries and resistors only.
Direct Current Circuits Electrolytes are solutions that can transfer charge from electrodes (dissimilar materials). A potential difference (V) will exist.
Electric Currents Topic 5.2 Electric Circuits. Electromotive Force Defining potential difference Defining potential difference The coulombs entering a.
Circuits Chapter 23.
Electricity.
Potential difference and electromotive force.
Series and Parallel Circuits. Series Circuit Current must pass through all resistors.
KIRCHHOFF’S LAWS & COMBINATIONS OF RESISTORS
Circuits with more than one resistor, then Watt happens? Series and Parallel are the 2 ways of connecting multiple resistors.
ELECTRIC CURRENT 2 Ohm’s law shows the relationship between current, potential, and voltage. We need a few more rules to make predictions about current.
Lecture 11-1 Electric Current Current = charges in motion Magnitude rate at which net positive charges move across a cross sectional surface Units: [I]
Current of Electricity Electric Current Potential Difference Resistance and Resistivity Electromotive Force.
Electromotive Force and Internal Resistance Before we start, the golden rules from GCSE:  The ? through any components connected in series is the same.
Chapter 28 Direct Current Circuits CHAPTER OUTLINE 28.1 Electromotive Force 28.2 Resistors in Series and Parallel 28.3 Kirchhoff’s Rules.
CH Review Series resistors have the same current; the total voltage is “divided” across the resistors. Parallel resistors have the same voltage;
19-2 EMF and Terminal Voltage A battery or generator, or other electrical energy creation device, is called the seat or source of electromotive force,
Circuit Rules Electricity Lesson 7. Learning Objectives To know the rules for series and parallel circuits. To know the principle behind these rules.
Series and Parallel Circuits
ELECTRIC CURRENTS. SIMPLE CIRCUIT What’s providing the energy? What’s “moving” in the circuit? What’s causing the movement? e.m.f. = Electromotive Force.
Kirchhoff’s laws. Apply Kirchhoff’s first and second laws. Calculate the current and voltage for resistor circuits connected in parallel. Calculate the.
Chapter 27 Lecture 23: Circuits: I. Direct Current When the current in a circuit has a constant direction, the current is called direct current Most of.
Kirchhoff’s Laws Kirchhoff’s Current Law Kirchhoff’s Voltage Law Series Circuits Parallel Circuits Polarity.
Lectures 7 to 10 The Electric Current and the resistance Electric current and Ohm’s law The Electromotive Force and Internal Resistance Electrical energy.
Thursday, Mach 10, PHYS Dr. Andrew Brandt PHYS 1444 – Section 02 Lecture #12 Chapter 26 Thursday Mar 10, 2011 Dr. Andrew Brandt HW6 Ch 26.
EMF and Internal Resistance Electricity Lesson 8.
EMF and Potential Difference Animation of current flow.
5.2.2 D.C. Circuits Practical circuits Electromotive force and internal resistance Kirchhoff’s laws Series and parallel arrangements Potential divider.
Internal Resistance. electromotive force revisited Remember the e.m.f.(ε) is the amount of energy given by the cell to each coulomb of charge passing.
5.3 Electric cells. Primary cell Designed to be used once and thrown away – the electrochemical reaction in the cell is not easily reversible.
Internal Resistance Review Kirchhoff’s Rules DC Electricity.
Series and Parallel Circuits SNC1D. Series and Parallel Circuits Key Question: How do series and parallel circuits work?
Properties of Current Current must flow in a complete circuit - current cannot be “lost” anywhere. Kirchoff’s point rule - the current flowing into any.
1 TOPIC 7 Electric circuits. 2 Charges will flow to lower potential energy To maintain a current, something must raise the charge to higher potential.
Chapter 26 DC Circuits. I 26-3 Kirchhoff’s Rules Example 26-9: Using Kirchhoff’s rules. Calculate the currents I 1, I 2, and I 3 in the three branches.
Circuits.
Determining Equivalent Resistance
Kirchhoff’s Rules.
Circuits Series Parallel.
Electromotive Force and Potential Difference
A B C Which of the circuits shown above are wired in parallel?
Internal Resistance in EMF
ELECTROMOTIVE FORCE AND POTENTIAL DIFFERENCE
Kirchhoff’s Rules.
Series and Parallel Circuits
DC circuits Physics /3/2018 Lecture X.
Circuits with more than one resistor, then Watt happens?
E.M.F and Internal Resistance
  emf Chapter 31 – Some Basics of Circuits The Basic things to know:
Current Electricity & Circuits W. Sautter 2007.
Current Directions and
Ideal vs Real Battery Ideal battery: no internal energy dissipation
Circuits Kirchhoff’s Rules
Direct Current Circuits
PHYS 1444 – Section 501 Lecture #12
Warm up 2/18 Explain Power What formula do you use to calculate the power used in a circuit? How can you know how much current will flow or how much voltage.
Presentation transcript:

Kirchhoff part 2

Starter

1.5Ω

Learning objectives State Kirchhoff’s second law Apply Kirchhoff’s second law to circuits Solve circuit problems involving series and parallel circuits with one or more sources of e.m.f.

Kirchhoff’s Second Law I am back!! This time it is slightly more complicated

What’s it all about?

Kirchhoff’s second law The sum of the e.m.f.s is equal to the sum of the p.d.s in a closed loop. This is an example of conservation of energy. What it essentially says is that all the energy put into a circuit from the battery has to go somewhere. And this balance must be exact. You can't have even a small amount of energy appearing from nowhere or disappearing without trace.

V R r Є V I Terminal p.d. measured here Lost volts across the internal resistance e.m.f. = terminal p.d. + lost volts Є = V + v We know that current through both resistors is I So applying V= IR to each resistor Є = V +IrЄ = IR + Ir Є = I(R+r)

6.0V 1Ω1Ω 7Ω7Ω 4Ω4Ω I A battery of e.m.f. 6.0V and internal resistance 1Ω is connected to two resistors of 4Ω and 7Ω in series: calculate a.The total resistance in the external circuit b.The current supplied by the battery c.The terminal p.d. of the battery

12V 14V 0.040Ω 0.050Ω A 12V car battery is recharged by passing a current through it in the reverse direction using a 14V charger. Calculate the charging current Note the 12 V e.m.f. opposes the 14V e.m.f. so: the sum of the e.m.f.s = = 2V There are 2 internal resistors, and both ‘waste’ electrical energy Є = I( R +r)