How to Change Your Oil By Ben Wirjosemito. Materials Gather all materials Having them close by is important Oil pan, funnel and socket wrench Newspaper/cloth.

Slides:

Advertisements

Similar presentations

BMW 1985 – 325e Timing Belt and Water Pump Replacement

Advertisements

The primary learning outcomes desirable from this lesson are as follows: 1)Become knowledgeable concerning the various types of vehicle insurance and.

C230 Kompressor Oil Change Procedure

CHAPTER 45 Engine Lubrication.

Motor number located on the clutch housing.

Cooling System Service CS6 NATEF Task A.1 D.7 By Vance Bloom.

Permanent Head Gasket & Block Repair w/Nanotechnology, 32 Fl Oz

REMOVE AND INSTALL THERMOSTAT AND TEST OPERATION CS4 A.1 D.6 P-5/6.

Changing the Oil in a 2006 Mitsubishi Eclipse. Introduction Changing the oil in your 2006 Mitsubishi Eclipse is easier than you may think. With a few.

Troubleshooting Guide. Table of Contents 2 Shower Filter 3 Leak Between Top Housing & Filter4 Leak Between Swivel Collar & Housing5 Leak at Top of Swivel.

Basic Automotive Care Oil, Transmission Fluid, Brake Fluid, Power Steering Fluid, Radiator Coolant, Tires.

Representor: Yoo D. Moon Date : November 25, 2008.

Mr. Jody Hannan Automotive Technology.  Topic- This presentation will give students knowledge of emergency car repair. We will explore how to change.

What should be checked?  When driving long distance?  During a regular vehicle inspection?  How often should oil changes be done?

Engine Overhaul Chevy 350.

Engine Removal and Disassembly

PowerPoint presentation to accompany Heizer/Render – Principles of Operations Management, 5e, and Operations Management, 7e © 2004 by Prentice Hall, Inc.,

How to Change Your Oil By: Sam Wallace. Overview Introduction (Importance) When? Tools Required Changing the Oil Clean Up.

860 (LF), 880 ½”- 2” 860 (LF), 880 ½”- 2”. Modification Overview  Production of the ½ - 2” 860 series began in 1997 and is current.  The 880 is an “N”

Steps for performing monthly service on the biotizer ® Dispenser The time to service the biotizer ® dispenser is less than one minute.

Ana Parise ENGL 393.  Checking a car’s oil is essential to keeping it maintained properly.  The purpose of checking the oil is to keep the car functioning.

PHSAUTOMOTIVESALSPHSAUTOMOTIVESALS SPARK PLUGS Thanks to NGK for picture.

Step 1 Park vehicle on a level surface then engage the parking brake and turn off engine. If you cannot comfortably get under the car, raise the front.

CARBURETED FUEL SYSTEM

Lube, Oil and Filter Service

ENGINE CLEAN OIL TOOL OIL RX • 999 TRAINING

1 Routine Preventative Maintenance. 2 to maximize the fuel economy & longevity of a vehicle and minimize breakdowns, maintenance should be performed regularlyto.

Cooling System Service CS6 NATEF Task A.1 D.7. O BJECTIVE Student will inspect, test and flush cooling system.

Changing your car's oil yourself is not only a money saver—it’s also a lot easier than it sounds! By Rachel Ammann ENGL 393.

PRE s ENT TO TRANSFER CASE WORK…….. ALL TO THE GEAR BOX……. -MAINTAINANCE….. -CHANGING OIL GEAR BOX…. -CHECKING OIL GEAR BOX……

Period 8Gary Clements1 How to do an oil change Gary Clements Period 8.

Getting Ready Gather tools, oil and filter. If you plan to change your oil regularly, consider investing in jack stands, a socket set and an oil drain.

How to Check Your Engine’s Oil By: Hector Gomez Sanchez.

LAB #9 Valve Head replacement. Insert the valve. Make sure that the cap goes on the intake valve. Insert the springs. Insert the keeper.

LAB #7 Reassembly. Get Check Off Sheet Before you start, make sure you get a reassembly packet from Mrs. Winegar. If you do not have her check your work.

HPU FILTERS LOW PRESSURE FILTER FROM APU UNIT. CLOSE APU HYDRAULIC FLUID VALVE. FILL FILTER WITH HYDRAULIC FLUID PRIO TO INSTALLATION. LUBRICATE GASKET.

D-Oily Tools 02/01/06 Week 5 Deliverables Aaron Lunt Adam Kan Justin Chastang Richard Burge Michelle Siverd Tyler Warnock Patent/Product Search.

Model 12 Intek Horizontal OHV

HOW TO CHANGE OIL IN A CAR

1 MOMENTUM 3800 RC ASSEMBLY INSTRUCTIONS PART NUMBER

XR621 Drive Hose Update Kit. Removal Turn off Battery dis Drain hydraulic tank Remove both rubber lines under chassis and discard. Remove and discard.

Presented by: Timothy Wheeler December 4 th, 2008 ENGL393, Mrs. Harris.

1 Spark Plugs. 2 Spark Plugs ignite the air fuel mixture in the engine. ≈10,000 volts jump the gap between the center electrode & the ground electrode.

 A car Jack  A wrench  A flat surface Put the car into park and apply the parking brake.

774X DCDA 21/2”, 6”, 8” 774X DCDA 21/2”, 6”, 8”. Modification Overview  Production began in  The 2 ½” 774X DCDA was discontinued in  The.

This lesson contains 48 slides. 16 slides are presented here as samples…(the videos are not included in the samples)

Routine Preventative Maintenance

Oil Change Christchurch

Routine Preventative Maintenance

Service Procedure For Changing Engine Oil And An Oil Filter

Automatic Transmissions and Transaxles

FIRST LOOK AT SMALL ENGINE REPAIR

774X 21/2”, 6”, 8”.

2000SS 2½”-12”.

30E & 30G STATOR TUBE REPLACEMENT

How to Change a Flat Tire

CHAPTER 45 Engine Lubrication.

Engine Oil Changes.

Engine Oil Changes.

FIRST LOOK AT SMALL ENGINE REPAIR

774 DCDA 21/2”-12”.

2000SS 2½”-12”.

774 2½”-12”.

3000SE 21/2”, 6”, 8”.

Subaru CV Transmissions

Changing Oil and an Oil Filter

Lubrication System.

Automatic Transmission/ Transaxle In-Vehicle Service

Replace Timing Belt 300 Hours.

Presentation transcript:

How to Change Your Oil By Ben Wirjosemito

Materials Gather all materials Having them close by is important Oil pan, funnel and socket wrench Newspaper/cloth (for spills)

Preparations Pop the hood of the car Open oil filter cap Locate and loosen the drain plug at bottom of oil pan

Draining Loosen Drain plug counter clockwise using socket wrench Be sure to use exact size Clean off oil gasket

Changing Filter Locate oil filter assembly (refer to manual if can’t find) Remove filter Remove rubber gasket from filter

Installing New Filter Remove packaging from new filter Rub new oil on rubber gasket Replace the drain plug on the oil pan. (finger tight)

Wrapping It Up Secure the new filter onto the engine. (do not cross threads) Clean up any spillage or residue Make sure you tighten filter as much as it says in the manual

New Oil Add new oil through the fill hole and a funnel. Amount needed is in owner’s manual Close the fill hole and remove any tools from the engine. Close hood.

HORRAY! Oil should be changed and maintained every 3000 miles or 3 months. To check, use the dipstick first thing in the morning while the car has been sitting cold for a while. This way, the oil is settled in the pan and more accurate to measure.