An Integrated Solution for Suppressing WLAN Signals in UWB Receivers LI BO.

Slides:



Advertisements
Similar presentations
Impedance Matching (2). Outline Three Element Matching – Motivation – Pi Network – T Network Low Q or Wideband Matching Network Impedance Matching on.
Advertisements

Communication Circuits Research Group
E3 237 Integrated Circuits for Wireless Communication Gaurab Banerjee Department of Electrical Communication Engineering, Indian Institute of Science,
1 A Low Power CMOS Low Noise Amplifier for Ultra-wideband Wireless Applications 指導教授 : 林志明 學生 : 黃世一
RF Circuit Design Chris Fuller /7/2012.
Built-In Self-Test for Radio Frequency System-On-Chip Bruce Kim The University of Alabama.
Design of RF CMOS Low Noise Amplifiers Using a Current Based MOSFET Model Virgínia Helena Varotto Baroncini Oscar da Costa Gouveia Filho.
CMOS Linear Mixer Design for High Performance Receiver Applications Jiming Jiang22 Sept 2005 Department of Engineering, University of Cambridge.
Mid-Semester Design Review High Frequency Radio with BPSK Modulation.
Low Power RF/Analog Amplifier Design Tong Zhang Auburn University Tong Zhang Auburn University.
Microwave Interference Effects on Device,
Low Noise Amplifier. DSB/SC-AM Modulation (Review)
An Ultra-Wideband CMOS Low Noise Amplifier for 3–5-GHz UWB System
Wireless Transceiver RF Front-Ends An overview of the main architectures in RF front-end design Fraidun Akhi April 1, 2003 Electrical and Computer Engineering.
High-Speed Circuits & Systems Laboratory Electronic Circuits for Optical Systems : Transimpedance Amplifier (TIA) Jin-Sung Youn
ECE1352F University of Toronto 1 60 GHz Radio Circuit Blocks 60 GHz Radio Circuit Blocks Analog Integrated Circuit Design ECE1352F Theodoros Chalvatzis.
1 Wideband LNA for a Multistandard Wireless Receiver in 0.18μm CMOS 指導教授 : 林志明 學生 : 黃世一
Wireless RF Receiver Front-end System – Wei-Liang Chen Wei-Liang Chen Wireless RF Receiver Front-end System Yuan-Ze University, VLSI Systems Lab
University of Toronto (TH2B - 01) 65-GHz Doppler Sensor with On-Chip Antenna in 0.18µm SiGe BiCMOS Terry Yao, Lamia Tchoketch-Kebir, Olga Yuryevich, Michael.
BY MD YOUSUF IRFAN.  GLOBAL Positioning System (GPS) receivers for the consumer market require solutions that are compact, cheap, and low power.  This.
An Ultra-Wideband CMOS VCO with 3~5GHz Tuning Range 指導教授 : 林志明 教授 學 生 : 劉彥均 RFIT IEEE International Workshop on Radio-Frequency Integration Technology,
Phase-Locked Loop Design S emiconducto r S imulation L aboratory Phase-locked loops: Building blocks in receivers and other communication electronics Main.
Design of LNA at 2.4 GHz Using 0.25 µm Technology
Seoul National University CMOS for Power Device CMOS for Power Device 전파공학 연구실 노 영 우 Microwave Device Term Project.
Study of 60GHz Wireless Network & Circuit Ahn Yong-joon.
New MMIC-based Millimeter-wave Power Source Chau-Ching Chiong, Ping-Chen Huang, Yuh-Jing Huang, Ming-Tang Chen (ASIAA), Shou-Hsien Weng, Ho-Yeh Chang (NCUEE),
An Ultra-Wide-Band GHz LNA in 0.18µm CMOS technology RF Communication Systems-on-chip Spring 2007.
1 Carson’s rule for a Sinusoidal Signal Angle-modulated signal by a sinusoidal message Total power, Power up to Nth harmonic, Find N such that satisfies.
A 30-GS/sec Track and Hold Amplifier in 0.13-µm CMOS Technology
ADS Design Guide.
Presenter: Chun-Han Hou ( 侯 鈞 瀚)
A 1.5-V 6-10-GHz Low LO-Power Broadband CMOS Folded-Mirror Mixer for UWB Radio H.-W. Chung, H.-C. Kuo, and H.-R. Chuang Institute of Computer and Communication.
Final Project in RFCS in the MINT Program of the UPC by Sven Günther
18/10/20151 Calibration of Input-Matching and its Center Frequency for an Inductively Degenerated Low Noise Amplifier Laboratory of Electronics and Information.
ITRS: RF and Analog/Mixed- Signal Technologies for Wireless Communications Nick Krajewski CMPE /16/2005.
A High-Gain, Low-Noise, +6dBm PA in 90nm CMOS for 60-GHz Radio
CommunicationElectronics Principles & Applications Third Edition Chapter 6 Radio Transmitters ©2001 Glencoe/McGraw-Hill Louis E. Frenzel.
Solid State Microwave Oscillators Convert dc energy to microwave signals Can be used as generators in all communication systems, radars, electronic counter.
Phan Tuan Anh Dec Reconfigurable Multiband Multimode LNA for LTE/GSM, WiMAX, and IEEE a/b/g/n 17 th IEEE ICECS 2010, Athens, Greece.
Integrated receivers for mid-band SKA Suzy Jackson Engineer, Australia Telescope National Facility SKADS FP6 Meeting – Chateau de Limelette – 4-6 November,
University of Toronto - Chihou Lee UltraWideBand a.k.a. UWB Chihou Lee : ECE1352 : December 2003.
A NEW METHOD TO STABILIZE HIGH FREQUENCY HIGH GAIN CMOS LNA RF Communications Systems-on-chip Primavera 2007 Pierpaolo Passarelli.
An Ultra-low Voltage UWB CMOS Low Noise Amplifier Presenter: Chun-Han Hou ( 侯 鈞 瀚 ) 1 Yueh-Hua Yu, Yi-Jan Emery Chen, and Deukhyoun Heo* Department of.
MMIC design activities at ASIAA Chau-Ching Chiong, Ping-Chen Huang, Yuh-Jing Huang, Ming-Tang Chen (ASIAA), Ho-Yeh Chang (NCUEE), Ping-Cheng Huang, Che-Chung.
Jinna Yan Nanyang Technological University Singapore
Introduction LNA Design figure of merits: operating power consumption, power gain, supply voltage level, noise figure, stability (Kf & B1f), linearity.
Final Design Review of a 1 GHz LNA / Down-Converter Charles Baylis University of South Florida April 22, 2005.
© Sean Nicolson, BCTM 2006 © Sean Nicolson, 2007 A 2.5V, 77-GHz, Automotive Radar Chipset Sean T. Nicolson 1, Keith A. Tang 1, Kenneth H.K. Yau 1, Pascal.
Ph.D. Candidate: Yunlei Li Advisor: Jin Liu 9/10/03
EMBRACE receiver 8th SKADS Board Meeting Château de Limelette, Belgium, 3 November 2009 DS5 EMBRACE IRA&ASTRON DS5 Eng. Group Presentation by Jader Monari.
ECE 4710: Lecture #37 1 Link Budget Analysis  BER baseband performance determined by signal to noise ratio ( S / N ) at input to detector (product, envelope,
CSE598A Analog Mixed Signal CMOS Chip Design FM Mixer CMOS Realization (Final Presentation) Zhang Yi.
Mackenzie Cook Mohamed Khelifi Jonathon Lee Meshegna Shumye Supervisors: John W.M. Rogers, Calvin Plett 1.
December 1997 Circuit Analysis Examples 걼 Hairpin Edge Coupled Filter 걼 Bipolar Amplifier 걼 Statistical Analysis and Design Centering 걼 Frequency Doubler.
RF Systems Target Radio-Frequencies Wireless communication systems require specific radio- frequency integrated circuits, which often require optimum performances.
EKT 314/4 WEEK 7 : CHAPTER 3 SIGNAL CONDITIONING ELECTRONIC INSTRUMENTATION.
High Gain Transimpedance Amplifier with Current Mirror Load By: Mohamed Atef Electrical Engineering Department Assiut University Assiut, Egypt.
Integrated Phased Array Systems in Silicon
RF components Design for the Internet Over TV Band Adaptor
Communication 40 GHz Anurag Nigam.
A High-Dynamic-Range W-band
Input Stages for Radio Systems (Low Noise Amplifiers) (LNAs)
A 1 V RF front-end for both HIPERLAN2 and a
Introducing: LTC5553 A 3GHz to 20GHz Microwave Mixer with Integrated LO Buffer ©2017 Analog Devices, Inc. All rights reserved.
CSE598A Analog Mixed Signal CMOS Chip Design
Mobile Broadcast and Spectrum Issues (DVB-T) Workshop April 2003
Variable Gain CMOS LNA MOREIRA E SILVA, Paulo Marcio, DE SOUSA, Fernando Rangel Introduction Simulation.
A 3.1–10.6 GHz Ultra-Wideband CMOS Low Noise Amplifier With Current-Reused Technique Microwave and Wireless Components Letters, IEEE Volume 17,  Issue.
Graduation Project Presentation
5.8GHz CMOS 射頻前端接收電路 晶片設計實作 5.8GHz CMOS Front-End Circuit Design
Presentation transcript:

An Integrated Solution for Suppressing WLAN Signals in UWB Receivers LI BO

Motivation UWB system becomes more interested in Wireless Personal Area Networks (WPAN) due to its high bandwidth after federal release the unlicensed spectrum in GHZ Wireless Local Area Network (WLAN) is operated in GHZ

Intermodulation products in UWB Band

Suppressing WLAN signal Third-order intermodulation Second order intermodilation It is a natural idea to suppress WLAN and other noise to improve performance

Possible solutions Off-chip pre-filter  Increase cost due to additional external component  signal lost  lower speed Integrate a filter to avoid WLAN interferers  Increase speed  Low cost

Wide-band filter VS tunable narrowband filter Wide-band  High order filter Need many inductor ( a lot of space) Impairs gain of receiver Tunable narrowband filter  Can be easily implemented through low order filter  Must have tuning due to small band

Tunable narrowband filter receiver scenario

Low Noise Amplifier (LNA) LNA will determine noise figure of receivers Challenges in design LNA  Input resistor need to be 50 ohms  Very low noise figure  Gain with high linearity which often measured in IP3  Maximize output power

Low noise amplifier (LNA) L 1,C 1,L 2 C 2 use for matching Inductively degenerated common- source amplifier Lg is added to give flexibility to design\ Cascode circuit to imporve frequency response

Notch filter simple example At resonant frequency, Zf is equal to zero so steal all signals

Notch Filter design Two resonant frequency Q4 works as a negative resistor It is tunable through varactor

Mixer A multiply circuit R3,L4 are use to isolate RF signal L4 is 5 nH, an area of 70x70 um 2

LO input and output buffer

Chips Due to Sidewall capacity of pad

Measured noise figure (NF) Parasitic resistance of notch filter Poor model and layout of the varactor

Measured results

Performance

Conclusion Implement tunable filter idea to suppress WLAN inference in GHZ using SiGe 0.35um technology The LNA, Mixer and filter power consumptions are 25.2,6 and 18 mW. The NF is not coherent with design which maybe due to poor model and layout of varactor

Feedback: Privacy Policy Feedback
Do Not Sell My Personal Information
About project: SlidePlayer Terms of Service

© 2024 SlidePlayer.com Inc. All rights reserved.