1. Seoul National University CMOS for Power Device CMOS for Power Device 전파공학 연구실 2003-21576 노 영 우 2004-1 2004-1 Microwave Device Term Project

2. Seoul National University OutlineOutline RF Performance of CMOS RF CMOS Modeling Problem of CMOS for Power device Power performance of CMOS Solution for CMOS Power Amplifier Conclusion

3. Seoul National University View of RF CMOS for System on a Chip 5~6 years ago  RF CMOS ?  Few works in Device modeling  Insufficient design environment  Digital CMOS Tech.  Most work from Univ.  CMOS PA (Study)  Only LDMOS, BV > 20V  RF CMOS is optional  Much work  Sufficient design enviroment  RF CMOS Tech. Inductor, MIM, Varactor  How many product !  No commercial  Handle design for CMOS RF/Analog/Digital chip  Much work for CMOS PA Integration  Essential for low cost product  Provide design kit  model, layout DB  Deep well tech.  GSM phone (Si-lab)  1.8 V/ 3.3 V & Circuit  below 200 mW is common 2~3 years ago Today Expectation of CMOS limit always changes with time - Enormous research, investment, engineers, foundry……….

4. Seoul National University RF performance of CMOS  0.18 CMOS shows 150 GHz f max  0.05 um SOI of CMOS - f T of 178 GHz - f T of 178 GHz - f max of 193 GHz - f max of 193 GHz  Comparable with SiGe HBT Technology - f max of 240 GHz - f max of 240 GHz Performance Ref. : L. F. Tiemeijer, et al., ’01 IEDM, Secession 10-4 S. Narasimha, et al., ’01 IEDM, Secession 29-2 S. Narasimha, et al., ’01 IEDM, Secession 29-2  RF performance of Active Device

5. Seoul National University RF performance of CMOS  Device Performance with Scale-down  Fmax & Noise of CMOS  Inductor Q, linearity  Gm increase : improve fmax, Fmin, IP3  Metal layer increase : improve inductor Q Ref. : SIA The national Technology Roadmap for Semiconductors, 1998 E.Moriuji, et al., Sysm. On VLSI Circuits, 1999 E.Moriuji, et al., Sysm. On VLSI Circuits, 1999

6. Seoul National University RF performance of CMOS  Noise performance  NMOSFET vs PMOSFET  Two times lower f max, f T compared with NMOSFET because of mobility (Transconductance) Ref. : C. S. Kim, et al., EDL, pp 607-609, Dec.2000

7. Seoul National University RF CMOS Modeling  Basic CMOS model for RF  UC Berkeley Model  For successful RF circuit design, the proper prediction of  Frequency characteristics (f T, f max )  Small signal modeling  Linearity characteristics (P 1dB, IP 3 )  Large signal modeling  Noise characteristics (NF, Rn)  Noise modeling are required.  Limit of SPICE Model (BSIM3v3)  Limit in High freq. For Digital, low freq Analog Circuit Need Rg for S11, Rsub for S22

8. Seoul National University What is the market asking for ? Distributed Active Transformer

9. Seoul National University Problem of CMOS for PA  Unsuitable Device for PA ( High Knee Voltage )  For high efficiency, V knee should be low, V max should be high (~BV dss ~ 2V DD )

10. Seoul National University Problem of CMOS for PA  Unsuitable Device for PA ( Large Voltage Swing )  Load line for Pin=25 dBm  ~ 2Vdd BVdss of LDMOS ~ 20V, Unsuitable for integration  Oxide breakdoun limit  Hot carrier effect  Reliability limit  Excellent potential for 2~5 GHz wireless comm.

11. Seoul National University Problem of CMOS for PA  Effect of Scaling on the Design of CMOS PA  As minimum channel length Lmin of MOS Tr scales down,  Reduced supply voltage ( 3.3 V for 0.35 um & 2.5 V for 0.25 um )  Required load resistance to be reduced  The smaller load resistance required for a down scaled CMOS technology results in larger power loss in the impedance matching network  lower efficiency “1 W still remains a challenge !”

12. Seoul National University Power performance of CMOS  800 ~ 900 MHz  1700 ~ 1900 MHz

13. Seoul National University Power performance of CMOS  2.4 GHz  5 ~ 5.3 GHz

14. Seoul National University Power performance for W finger Device Size  VDD = 3.0 V  Thick Oxide, L= 0.35 um  Current 22 mA Load pull measurement

15. Seoul National University Load Pull Measurement of Power Transistor @ 2 GHz@ 5 GHz  V DD = 3.0 V  Thick Oxide, L= 0.35 um Thick Oxide power transistor using 0.25 um

16. Seoul National University Solutions for Large Swing (Case 1)  Thick Gate Oxide in 0.2 um CMOS ( Timothy C. Kuo, Philips, ISSCC’01  A 1.5W Class F RF PA in 0.2 um CMOS  By using Thick Ox. : output node sustain 7 Vp  Sine wave driver VS square wave driver  Inductor tuning driver: Negative swing  damage oxide  Higher efficiency in square driver case

17. Seoul National University Solutions for Large Swing (Case 1)  Inverter Driven 2-stg Power Amplifier in 0.2 um CMOS  Class F: Resonate Co & Lo @ 2fo  Power control: Control the cascode bias  Class D, E (switching PA) : BV dss > 3.6 V DD  V DD (3V/1.8V), 900 MHz, 1.5W, PAE(43%), Class F

18. Seoul National University Solutions for Large Swing (Case 2)  Self-biased Cascode 0.18 um CMOS ( Tirdad Sowlati, Philips, ISSCC’02 )  DC of D 2 and G 2 : same  Bias for G 2 is provided by R b /C b  R b /C b is chosen for Equal gate- drain signal swing on M 1 and M 2

19. Seoul National University Solutions for Large Swing (Case 2)  Self-biased Cascode 0.18 um CMOS ( Tirdad Sowlati, Philips, ISSCC’02 )  Inter stage LC, Output MN (off chip)  VDD=2.4 V, Po= 23.5 dBm, PAE(45%), Gain 38 dB  Hot carrier degradation @ 23.5 dBm (6 days)  23.4 dBm

20. Seoul National University 5 GHz CMOS Power Amplifier (Case 3)  802.11a WLAN ( David Su, Atheros, ISSCC’02 )  Fully differential Class A  0.25 um CMOS, 3.3 V, 190 mA  22 dBm

21. Seoul National University Multi-Band/ Mode CMOS PA  Dual Band PA ( WLAN Application )  Highly linear PA for OFDM  Single power supply 3.3 V  Small size package with heat sink

22. Seoul National University ConclusionConclusion  CMOS is most unsuitable device for power amplifier, but much works to integrate the PA will be continue.  Good performance RFIC ~ Good active device design  Library is not sufficient for high performance IC design.  802.11 a/b/g low power, multi-band, multi-mode PA application - High integration level