Dennis Sabre Fire Appliances

Slides:



Advertisements
Similar presentations
Service Delivery 3 Pumps.
Advertisements

Getting Started with the EELD601 After you remove your EELD601 from the box, check to make sure you have all accessories shown below. Click here for next.
Preferred Utilities Manufacturing Corp.
Dennis Fire Appliances Operations & use. PTO Step 1 Move slide cover towards the drivers seat to lock out the gearbox Step 2 Select drive on the gear.
Operation of One Speed Control valve. Transmission control valve N-range operation Transmission Control valve.
START-UP AND OPERATION OF MECHANICALLY SEALED EQUIPMENT 1:13.
Engineer Training XL1200 Ink System. Engineer Training XL1200 Ink System Confidential 2 Ink System The XL1200 Ink System consists of the following elements:
Morgan City Rentals Diesel Jet Pump 6 x 6 Peerless Safe Operating Practices and Procedures.
Passive Leak Detection Operation Training October 2014.
FoamPro 1600 Series Fully automatic Class A foam ONLY
© Blue Graphics Concept Sauer-Danfoss START-UP PROCEDURE PROPEL PUMP Instruction Sauer-Danfoss Belgium – T. Van Mossevelde.
CAFS On-Line Orientation
Water supply and drafting. Objectives Understand and be able to demonstrate the different hydrant lays and hook ups Explain/demonstrate how to operate.
1B-1 Fire Engine Maintenance Unit 1B – Pump Inspections and Maintenance.
Power-Fill Operation Demonstration Power-Fill Operation Demonstration (See Installation and Operation Manual for detailed instructions)
Boiler Mountings.
CVFD Training – Water Supply SFFMA Training Objectives: –
AccuMax Multi-Point Injection Mechanics
5.1.2 Student Book © 2005 Propane Education & Research CouncilPage 1 NFPA 58, LP-Gas Code, sets out the minimum valve and fitting requirements for propane.
Fuel Oil Systems Fuel Oil Systems consist of: Storage Tanks Pumps
Mechanical for Oil Heat
Series Operational Training. 2 Water Tank Water Pump Multiple Discharges 2000 Series Line Strainer Foam Tank Electronic Direct Injection Proportioner.
Imago LEAP Recovery Procedure for Cryo-Compressor and Cold Finger The LEAP is equipped with a Uninterrupted Power Supply (UPS). Located in the 19 inch.
1 Fuel Pumps. 2 Pumps 1.All oil burners for residential heating have pumps A. They are connected to a motor through a coupling 2.Description A. An oil.
Water Handling Operations
Instructor Lee Lautzenheiser
Left side compressor behind Left control box Right side compressor behind Right control box.
NFPA 31 Standard for the installation of Oil- Burning Equipment
Placing Vapor Distribution Systems and Appliances into Operation MODULE 8 System Tests.
Gasoline fuel supply systems Function: store, transport, Pressurize and filter gasoline going to carburetor or fuel injection system.
Water Supply Skill Drills.
Spill and Overfill Prevention Alaska Spring 2004.
ENGINES. VEHICLE / HEAVY EQUIPMENT SAFETY INSPECTION CHECKLIST OF 296.
Section 703 Apparatus Inspection. Procedures The driver/operator should follow a systematic procedure for inspecting apparatus This ensures that all important.
Tweety Operation Manual. Refurbish History Motor 1) Cummings Diesel (V6), ) Red Line 3000 (hums at 2800) 3) Top Speed 60 MPH.
1 A/C Pressure Test and Evacuation. 2 Leak Detection Leak detection must be done after every repair job. It must also be done anytime the appliance can.
Las Delicias Water Supply System OPERATION AND MAINTENANCE MANUAL 1.
Automotive Heating and Air Conditioning CHAPTER Automotive Heating and Air Conditioning, 7e James D. Halderman | Tom Birch SEVENTH EDITION Copyright ©
Diesel Fuel - Fill Place all spill safety equipment where needed
Fire Fighting Systems Fi Fi Mains ●White System: This system has a lower output as far as volume goes. This main supplies 3x Eductor/Hydrants (500 gpm).
Weekly Checks Monday – VSP Room Tuesday – Pilothouse System Controls Wednesday – Starboard / Engine Room Thursday – Foam Room Friday – Port / Engine Room.
Launch Chameleon Plus P - More Preventive features and safety L - More Longer Lasting and robust U - More User friendly operation S - More Service friendly.
Fire/General Service/Ballast Pumping Systems
Machinery Cooling Water System Locations and Operations.
Coolant Fill Coolant Check and Fill. Oil Fill & Dip Stick Main Engine Oil Fill Dip Stick Delo 400 – 40 wt. Engine Oil.
Wednesday – starboard side engine room weekly checks Cycle all valves on the starboard side of the engine room Check all systems, connections, valves,
STEP 1 Locate the transmission cooler line connection on the vehicle. Identify the correct adapters to be used by referring to the vehicle application.
CCNA1 v3 Module 9 v3 A+ Type 1 JEOPARDY K. Martin.
EBS-1 # COOLANT FLUID EXCHANGE QUICK REFERENCE ATTENTION: Using the Coolant Fluid Exchange requires the FILL and VAC Valves on the SERVICE.
Vertical Pump Motor Manifold Upgrade. VPMM Replaces Existing Pumps, Motors, Relief Valves, Check Valves, Discharge Filters, Pump Running Pressure Gauges,
ATP FOAM SYSTEM Engine 438 Ansul / Rockwood Model B2 400 GPM Around The Pump Foam System.
Automotive Heating And Air Conditioning
Chapter 37: Fluid Containment
Dual Pumping Definition: An operation where a strong hydrant is used to supply two Engines by connecting the Engines intake-to-intake. The second Engine.
14 Refrigerant Recovery, Recycling, and Recharging.
Pneumatic and Hydraulic
Student CD for Commercial Refrigeration for A/C Technicians Chapter 12 Ice Machines.
SB Packing Automatic Downpuller Power Unit
Fuel Supply System Service
Introduction to Overfill Prevention for USTs
FUEL DELIVERY SYSTEM Copyright © MILE 2011 MILE / XUV500 / IC / VER 01 / JUL 2011.
WATER SUPPLY FOR NON-HYDRANT AREAS
NEW COMPLIANCE REGULATIONS
State of Georgia BASIC FIRE FIGHTER TRAINING COURSE
Ultra Light Tanker V2 Nissan Patrol DX (4x4)
Presentation transcript:

Dennis Sabre Fire Appliances Godiva Water Pump Operations & use Start

Water pump NEXT Shut off valve for Nearside High Pressure hose reel. Select ‘Foam’ or ‘Water’ (to be closed when not in use) Shut off valve for Offside High Pressure hose reel. Select ‘Foam’ or ‘Water’ (to be closed when not in use) Supply valve for High Pressure hose reels Low pressure deliveries Engine speed control. Suction fill coupling Please note filters must be used on open water. Main water tank to pump Shut off valve Pump drain taps For winter draining to prevent pump frost damage Hydrant fill to water tank NEXT

PTO To select PTO With the engine running at tick over and the gearbox in Natural press the ‘MODE’ button When the PTO is engaged the red light will show on the selector To disengage the PTO press the ‘MODE’ button again. NEXT

Fill Water tank from Hydrant Connect Hydrant hose to Hydrant fill and opening the hydrant to fill the tank Note;- Some vehicles have a manual or automatic shut off valve in addition or in place of a non return valve When the tank is full (water will over flow from the top vent) close the hydrant, close the tank fill valve, then carefully release the hydrant hose, it may still have some water pressure in the hose NEXT

Supply the pump from Hydrant Close main water tank to pump Shut off valve Connect Hydrant hose to Hydrant fill and open the hydrant to feed the water pump With the pump running you can now have water supply from either the low pressure ports of the High pressure hose reels The more hydrant hoses the greater the flow rate of the pump (up to 3 for the 4 inch suction eye, 4 for the 6 inch eye) NEXT

Supply the pump from open water Connect the hard suction hose together and to the water pump Fit the filter to the end of the hard hose This MUST be used in all cases to prevent damage to the pump Close main water tank to pump Shut off valve Run the pump at priming speed and observe the compound gauge read a vacuum If no vacuum is shown check to see that there is no leaks on the suction pipe and that the basket is fully in the water When pressure is shown on the Low pressure gauge open a delivery and allow the water to flow NEXT

Low pressure water Select water supply option. Main water tank or external supply. Open Low pressure delivery valve as required. When the water is not being used do not keep the pump running at higher revs as the water and the pump will over heat causing potential damage. NEXT

High pressure water Select water supply option. Main water tank or external supply. Open supply valve for High Pressure hose reels Select the setting for the shut off valve for the High Pressure hose reel (one for each side) Select ‘Foam’ or ‘Water’ Foam is supplied via the pick up tube (by hose reel or in pump bay) down the HP hose only and must always be flushed through after use. NEXT

EFA (Trading) Limited Engineering Training We are the wholly owned and controlled local authority company of the Essex Fire Authority For more information please contact us via the web links below Engineering Vehicles & Equipment repair & maintenance Second life Fire Appliance sales www.fireappliances.com Training Professional & commercial fire fighter training www.essex-fire.gov.uk/Training