WESP FUNCTIONS  REMOVAL OF FUMES AND MIST CREATED DURING FRYING PROCESS.  FUMES-GAS MIST- SOLIDS  REDUCE POLLUTANTS TO ATMOSPHERE  REDUCE HEAT IN BUILDING.

Slides:

Advertisements

Similar presentations

Big Lagoon Small Lagoon 20,000 Gal Tank Flood lane Main Drain Separator Liquids form Solids Solid holding area Pump Station Licorice Lane Farms Heike Fry.

Advertisements

MicroMistTM Wet Scrubber Advanced Scrubbing Technology

I E Industrial Equipment Servicing the North State Environmental Cleaning Systems Site Design Comparisons Site Design Comparisons (System Pretreatment)

Cooling System Get the engine up to optimum operating Temperature as quickly as possible and maintains it at that temperature. Controls the heat produced.

ＫｕｂｏｔａＪｏｈｋａｓｏｕＭｏｄｅｌＨＳ－Ｐ

Cold feed to hot water cylinder Sink Basin Bath Drain valve Stop valve WC cistern 100 litre (minimum storage cistern)

Ventilation Systems As Control Measures. Introduction A good and effective ventilation system is necessary in a workplace which have processes that emit.

Unit 12 Oil Heat Components

Heat and States of Matter

DRYING SYSTEM Concentrate from Evaporation section At 40% - 60% Concentration Rotary Dryer Mixed 15% Moisture Boiler System Hot Air Spray Dryer.

Paint Circulation Technology Level 1 - Training Document

2-PIPE DIRECT RETURN SYSTEM

1 GREENHOUS MANAGEMENT GREENHOUSE STRUCTURES HEATING, COOLING, AND LIGHTING SYSTEMS.

By : Theresa & Sade..  Showers that go on too long.  Using a hose instead of a broom to sweep your garage/driveway.  Using washing machines & dishwashers.

What is going on inside a packed stuffing box?

TRI MARTIANA.  A good and effective ventilation system is necessary in a workplace which have processes that emit air contaminants such as dust, fumes,

The Milking Machine. 1. Vacuum Pump Creates a vacuum which is used to: Transfer milk to the receiving vessel To perform the milking process To transport.

Natural Draft Cooling Towers

VENTILASI TRI MARTIANA. Introduction A good and effective ventilation system is necessary in a workplace which have processes that emit air contaminants.

What is EcoMachine?  It is a machine that reduces water consumption in the Aiken Center by treating sewage exiting the building and then returning it.

Survey Results from 2014 presentation: Maintenance of Conditions/Change in Conditions Robbie Walker.

WATER USE AND MANAGEMENT. Residential Use United States – 80 gallons water used per person per day – ½ used for drinking, cooking, washing, toilet – ½.

CHAZ TEKLE – TIM KERN – MARK FREIERMUTH – CHA THAO Fargo Bank IT Upgrade.

Saving lives, changing minds. Vietnam Red Cross Society – DRT WatSan Training Nepal Red Cross Society - NDRT WatSan Training MAINTENANCE.

(U-shaped tank) WATER TANK SLUDGE TANK This system makes it possible to recover the liquid part of the suctioned material in the sludge compartment.

Heat Diagram of H2O.

Using Thermal Energy Chapter 6 Notes. Thermal Energy on the “Moo”ve Conduction- transfer of energy by direct contact of particles Convection- transfer.

IMPROVING COOLING SYSTEM EFFICIENCY WITH PRE-COOLING AJ Schutte 15 August 2012.

Changes of State Chapter 3 Section 2. Changing State By removing or adding energy, a substance can lose or absorb energy, its temperature can change,

Prep for Gain Tests: Some Progress, Some Setbacks TKH for the Stony Brook Crew.

Section 3 Using Heat.

Photovoltaic Panels to generate electricity Six “banks” total 6.6kW = home requirement.

CHILLED WATER AIR-CONDITIONING SYSTEMS

Monday – VSP Room weekly checks Visually Check: Hvac system for leaks & valve settings Fresh water system for leaks & valve settings VSP linkage Autopilot.

52 RCACS Ground School Engines PO 407 EO 2 “Cooling, Fuel and Lubrication Systems”

Rainwater Overflow Rainwater Captured & Used Potable Water Used Rainwater Harvesting: Cistern Performance Simulation Cistern Size (Thousands of Gallons)

ES06A – Teach About Earth ’ s Renewable Resources Use with BrishLab ES06A.

Properties of Air Test Review. Name that Property! Q: Air is less dense than water because the molecules are more spread out. A: 1.It is a mixture of.

Semester Exam Demo Project

SATMathVideos.Net Water is pumped into an tank at 20 gallons per minute. The tank has a length of 10 feet and a width of 5 feet. If the tank starts empty,

Using Thermal Energy—Chapter 6

Poultry Equipment Used On Broiler Farms Ag. Ed. Computer Workshop June 27, 2002 Pictures and Program Prepared by John Sutton Georgia Agriculture Education.

Important Terms & Notes Feb , Energy Flow During Phase Changes of Matter Energy must be ABSORBED by matter when the phase changes from: –

Raffia Siddique National University of Sciences and Technology sector H-12 Islamabad

D D PC B Loose Roof End of Water x x x x Suction hose 6 posts x x Posts set Refuge chamber Sump with pump Door opened Door closed Water over knee deep.

The C.I. Engines Fuel System  The C.I. engine demands that the fuel supplied is –  Timed to inject when the piston is near the end of the compression.

ALSI Air and Liquid Systems, Inc. CheckMark vs. Centrifuge.

Symbols and Room Finishes

VENTILATION AND AIR CONDITIONING Under the Subject Industrial Safety and Environment || ||

ARÇELİK TİCARİ KLİMA EĞİTİM DÖKÜMANI APPENDIX.

Chapter 6 Section 3.

Automotive Engines Theory and Servicing

Chapter 5 – Thermal Energy

Engine Systems Overview

Book E3 Section 1.4 Air-conditioning

Greenhouse Components at Kirkwood

Presented by:- ARAVIND P V MS S5 NO:-60

Cooling System Get the engine up to optimum operating Temperature as quickly as possible and maintains it at that temperature. Controls the heat produced.

Notes 7: Using Heat Chapter 6 Section 3 Page 172.

Auto Upkeep Basic Car Care, Maintenance, and Repair (2nd Edition)

Nature of ecosystems Energy flow – microbes are decomposers Water

Reasons for Lubrication

Solve the following equation for x:

HYBRID AIR COOLING TECHNOLOGY

The Heat Pump-pumps heat from a cold area to a warmer area.

Dose in l/h clean liquid

Presentation transcript:

WESP FUNCTIONS  REMOVAL OF FUMES AND MIST CREATED DURING FRYING PROCESS.  FUMES-GAS MIST- SOLIDS  REDUCE POLLUTANTS TO ATMOSPHERE  REDUCE HEAT IN BUILDING  REMOVES SMOKE FROM BUILDING.

GENERAL LAYOUT  DUCTWORK/DAMPER SECTION  QUENCH CHAMBER 5’x60’ WATER SPRAYS  CYCLONE WITH WATER SPRAYS  E-TUBES/GRID ”x 13’ CENTER PROBES W/15 ELECTRODE DISKS  FLOOR WASH  DEMISTER PADS  I D FAN 68, F  EXHAUST STACK 6’x60’

PUMPING SYSTEMS  RECYCLE PUMP Constant flow through sprays.  FLUSH PUMP Intermittent cleaning sprays.  TRANSFER PUMP Floor sump to recycle tank.  GORMAN RUPP SUMP PUMP from overflow sump to fume room sump.  SKIMMER DIAPHRAGM PUMP from recycle tank to fume room sump.  OUTSIDE SUMP DIAPHRAGM PUMP (Located by inside sump pump) Pumps from outside apron sump to inside sump.

RECYCLE and FLUSH SYSTEM  PRIMARY RECYCLE SYSTEM RECIRCULATES THROUGH WHOLE SYSTEM FROM 6000 GALLON TANK.  FLUSH SYSTEM WASHES INTERNAL AREAS FROM 800 GALLON TANK AT 3 HOUR INTERVALS. (Approx. 350 Gal. per flush)  MAKE UP WATER IS ADDED TO RECYCLE AND FLUSH TANKS TO MAKE UP FOR EVAPORATION AND SKIMMER.

WESP LAYOUT DRAWING