Training Course on the WJ-HD300A Series DVR Hard Drive Replacement Procedure WJ-HD300A Series DVR

Training Course on the WJ-HD300A Series DVR PAL

Training Course on the WJ-HD300A Series DVR –Option 1: Pre-Sales Support –Option 2: Technical Support –Option 3: Service Centre Panasonic CCVE Homepage S 3 Service Support Contact Details Training Course on the WJ-HD300A Series DVR

Training Course on the WJ-HD300A Series DVRAB  Remove the screw under the end panel (A)  Slide front panel across to remove it (B) WJ-HD300A Series Hard Drive Installation

Training Course on the WJ-HD300A Series DVR  The front panel will fall forward (A)  Carefully remove connector (B)AB WJ-HD300A Series Hard Drive Installation

Training Course on the WJ-HD300A Series DVR  Remove the 4 draw screws (A)  Pull draw out towards the front (B)AB WJ-HD300A Series Hard Drive Installation

Training Course on the WJ-HD300A Series DVR  The draw will separate from the main unit completely  Connect the Hard Drive to the power connector and SATA cable. WJ-HD300A Series Hard Drive Installation

Training Course on the WJ-HD300A Series DVR  Screw the Hard Drive into place using the holes shown  This MUST be done to ensure correct operation  The screws come supplied with the main unit WJ-HD300A Series Hard Drive Installation

Training Course on the WJ-HD300A Series DVR WJ-HD300A Series Hard Drive Installation - Format After replacing or adding an additional hard drive, the WJ-HD300A will need to format the hard drive in order to record to it. Upon boot up, providing the hard drive was installed correctly, the WJ-HD300A will force you into the format screen. The password for formatting is the same as the ADMIN user password. This by default is “ ” If the WJ-HD300A does not see the hard drive it may be down to: 1.The drive not set to “ Master ” 2.The connectors not seated correctly 3.The wrong type of drive has been used, or 4.A faulty hard drive