doc.:IEEE /xxxxr0 Submission Nov. 8, 2010 Notification on Change of BW & Rx Nss Joshua Zhao, et al1 Date: Authors:

doc.:IEEE /xxxxr0 Submission Nov. 8, 2010 Motivation STA may change BW for performance or power save Notify Channel Width frame was defined in 11n STA may shut down some RF chains for PS AP needs to know how many spatial streams the STA can receive A new action frame needs to be defined AP may ask whole BSS to change channel/BW Simply extend Channel Switch Announcement frame Joshua Zhao, et al2

doc.:IEEE /xxxxr0 Submission Nov. 8, 2010 Concerns AP may have frames queued for this STA before the action frame is processed –The AP may transmit to the STA while the STA is in process of changing operating mode and thus unable to receive –Unnecessary re-transmissions may occur –Packet loss may result It takes time for STA to change operating BW (or RF chains) –After receiving ACK from AP, the STA may not be quick enough to switch mode within PIFS interval (shortest time before an AP may transmit) –STA may want to wait a bit before making the change (to avoid packet loss) –AP can not predict when the STA will be ready to receive Suggestion: Use operating mode notification with the existing PS behavior –AP holds packets for STAs in PS –AP HW doesn’t need to do special processing on action frames Joshua Zhao, et al3

doc.:IEEE /xxxxr0 Submission Nov. 8, 2010 Operating Mode Notification Sequence The STA sends operating mode notification frame with PS bit set. After the STA is done switching modes, it sends a frame to the AP with PS bit cleared. Optional to STA if it has no worry on packet loss during mode transition. Joshua Zhao, et al4 STAAP Mode change notification with PS on AP holds up tx to STA in sleep Turn PS off Packet delivery STA in mode change

doc.:IEEE /xxxxr0 Submission Nov. 8, 2010 Notification frame format Define a new frame for operating mode change for 11ac –Leave existing Notify Channel Width frame unchanged for 11n devices –Define a new action type: avoid confusion between HT and VHT actions Use this new action type for both BW and Rx Nss STA may want to adjust both BW and RF chains simultaneously Or a STA can change one and keep the other same as before Joshua Zhao, et al 5 BWReservedNssReserved B0-B1B2-B3B4-B6B7

doc.:IEEE /xxxxr0 Submission Nov. 8, 2010 BSS Channel/BW change Extended Channel Switch Announcement frame will automatically support wider BW options as operating class definition is extended. But some old devices may not support it. For better compatibility, legacy Channel Switch Announcement frame might still be used. We can either extend bits definitions in Secondary Channel Offset element (one example is shown below) or define new elements for wider BW options. Details are to be decided in BSS Channel Specification discussion. Joshua Zhao, et al6

doc.:IEEE /xxxxr0 Submission Nov. 8, 2010 Pre-Motion #1 Do you support defining a new VHT action frame for operating mode change as defined in Slide 5? Joshua Zhao, et al7

doc.:IEEE /xxxxr0 Submission Nov. 8, 2010 Pre-Motion #2 Do you support the concept of optionally using Power Save mode in the “operating mode notification” frame exchange sequence as described in slide 4? Joshua Zhao, et al8