Table 1. Project Control Factors and their hierarchy

Slides:

Advertisements

Similar presentations

and Statistics, 2016, Vol. 4, No. 1, 1-8. doi: /ajams-4-1-1

Advertisements

© The Author(s) Published by Science and Education Publishing.

Table 4. Mechanical properties of repair and substrate concrete

Percentage of Polyethylene

Properties Test results

Table 1. Empirical MSE to estimate the CP distribution parameter λ

© The Author(s) Published by Science and Education Publishing.

Research, 2015, Vol. 3, No. 6, doi: /education

Table 5. Properties of The Tested Soil

© The Author(s) Published by Science and Education Publishing.

Tensile strength (MPa) Length (m) of fibers/kg

Table 2. Result of intention to use

Table 2. Physical properties of Portland cement

osteoporosis among the studied working women (n= 365)

Research, 2017, Vol. 5, No. 4, doi: /ajnr-5-4-6

SON Nurse Practitioner Blackboard Community

Total Energy Consumed (%)

Tensile Test after Firing

intervals from six months to one year

© The Author(s) Published by Science and Education Publishing.

Marshall characteristics

Table 1. Chemical composition of materials

بسم الله الرحمن الرحیم.

© The Author(s) Published by Science and Education Publishing.

Table 8. Drawing result before game

in the last evaluation of the software

© The Author(s) Published by Science and Education Publishing.

Total CO2 Emissions (Electricity + Fossil Fuel)

Table 1. Student’s attitude towards technology (%)

© The Author(s) Published by Science and Education Publishing.

Table 2. Waste characterization in Port Harcourt, Source [1]

© The Author(s) Published by Science and Education Publishing.

Rating of Water Quality

Inscribed circle diameter

© The Author(s) Published by Science and Education Publishing.

Table 3. The needed requirements of the Concrete Sustainability

FSV Interpretation (qualitative)

© The Author(s) Published by Science and Education Publishing.

Table 1. Rice yield in MT (Source-USDA, Foreign Agricultural Service)

Number of categories that are mentioned (0% < categories < 5%)

Table 1. Diagnostic methods for systemic fungal infection (n=70)

Table 1. Geometric properties of steel tubes used

Table 2. Modal parameters estimated by Pulse Reflex®

© The Author(s) Published by Science and Education Publishing.

Table 1. The most important aspect applied in MIVES

Table 7. Status of CF in Nepal as of 2009

Table 5. Pvalues of ttests for direction a

Entrapment Efficiency (%) ± S.D.

Simulation Frequency(Hz)

Number of questionnaires sent out

Table 6. Pvalues of ttests for direction b

Table 1. Descriptive Statistics

Table 2. Regression statistics for direction a

Table 3. Regression statistics for direction b

Table 3. List of PT specimens

© The Author(s) Published by Science and Education Publishing.

Table 2. SUMMARIZED OBSERVATIONS FROM MODEL ANALYSIS

Table 6. Percentages of Indicators

95% Confidence Interval for Mean

Control Valve Tag Number

Category Quantity Secondary school 3 Student participant

Table 4. Value creation (Y2)

S. No. Product Name yield content

© The Author(s) Published by Science and Education Publishing.

Compressive Strength difference at 1 week (MPa)

Table 6. Twisting moment of counter shaft at different torques

© The Author(s) Published by Science and Education Publishing.

© The Author(s) Published by Science and Education Publishing.

Average Execution Time in seconds

© The Author(s) Published by Science and Education Publishing.

Presentation transcript:

Table 1. Project Control Factors and their hierarchy Sl. No. Factors 1.10 Safety 1.101 Policy, Procedures & Standards 1.102 Housekeeping, accessibility 1.103 Use of Personal Protective Equipment 1.20 Quality 1.201 QA Policy, Procedures and Standards 1.202 Quality Audit 1.203 Specification 1.204 Control charts & analysis 1.30 Cost 1.301 Cost Estimates (baseline) 1.302 Budget and Budgetary Controls 1.303 Cost monitoring system 1.304 Change Order Management 1.40 Schedule Control 1.401 Construction Schedule (Master Schedule) 1.402 Resource Schedule 1.403 Use of Software and tools for Schedule control 1.50 Risk Management 1.501 Risk Identification 1.502 Risk Analysis- Quantitative & Qualitative 1.503 Risk Mitigation 1.504 Risk Monitoring & Control Devanshu Pandit et al. Project Control Factors at Front End: Indian Perspective. American Journal of Civil Engineering and Architecture, 2014, Vol. 2, No. 2, 77-82. doi:10.12691/ajcea-2-2-4 © The Author(s) 2014. Published by Science and Education Publishing.