Solidworks Computer-Aided Drafting Program LESSON 7- Angle Bracket Presenter Billy Fowler

Lesson 6- Angle Bracket 2D Sketch to 3D Extrude View Extrude Cut , Fillet Insert Hole on a reference point/line

Sketch lines in an “L” pattern with set dimension of 4” x 3”

Insert horizontal lines with set dimension of 0.5”

Sketch vertical and horizontal lines in accordance of already existing lines

Extrude to a Depth of 2”

Rotate Part until you can see the following faces of part

Fillet both Edge 1 and Edge 2 @ 1 inch

Insert the following Reference lines on the following face

Insert a Hole at the vertex of crossing reference lines, set hole settings at 0.5” depth and 1” diameter Insert, Features, Hole, simple

Rotate part so you can focus on the opposing face Fillet the other edges of part at 0.25

Insert the following reference line

Rotate and zoom on the edge of face, apply the following lines, use smart dimension to set the following spacing and dimension

Apply three point arc connecting the two sketched lines, set radius at 0.25

Extrude cut the following sketch at 0.5”

Rotate and Zoom in on the following edges

Fillet the following Edges @ 0.25”