Series and Parallel Circuits

Slides:

Advertisements

Similar presentations

Notes on Chapter 35 Electric Circuits

Advertisements

+ V (Volt) = W (work done, J) Q (charge, C)

Circuits & Circuit Diagrams

Series and Parallel Circuits

Tuesday December 4, 2007SNC1D | A. Manaktola Ohm’s Law Quiz – take up What are the coordinates for the two points? A(0,0) B(0.8,4) What is the difference.

Circuits Series and Parallel. Series Circuits Example: A 6.00 Ω resistor and a 3.00 Ω resistor are connected in series with a 12.0 V battery. Determine.

Electricity refers to the presence of electric current in wires, motors, light bulbs, and other devices. Electricity carries power. Power (P)

Electric Circuits and Power Page 706. Ohm’s Law Resistance is equal to the voltage divided by the current. Resistance = Voltage Current Ohms ( ) = Volts.

Electricity Foundations of Physics. Electricity The movement of charge from one place to another Requires energy to move the charge Also requires conductors.

Current and Resistance

Copyright © 2008 Pearson Education, Inc., publishing as Pearson Addison-Wesley Electricity Physics 102 Goderya Chapter(s): 22 and 23 Learning Outcomes:

Current, Voltage, and Resistance in a circuit

Circuits & Electronics

Electric Circuits. What is an Electric Circuit? Electric Circuit: is a closed loop through which charges can continuously move. Need to have complete.

Circuits, Volts, Amps, and Resistance. Series circuits Simple circuits that have only one path for the current to flow are called series circuits.

Electrical Resistance and Ohm’s Law Electric circuits are used to convert electrical energy into some other form of energy we need.

Cells in Series and Parallel (page 310) Cells in Series and Parallel Dry cells can be connected together into two basic types of circuits: series.

10.7 Cells in Series and Parallel (page 310). A “dry cell” is another term for a battery. Dry cells can be put together in two ways to change the energy.

Ch. 34 Electric Current.

4.2.3B Electrical Power What About Watts?. Power Law Moving electrons (current) requires ENERGY How much energy gets used depends on: Strength of push.

Chapter 7 Electricity. What is Charge? Protons have a (+) charge Electrons have a (-) charge Charge (q) is measured in Coulombs The elementary charge.

Electric Current and Ohms Law. Electric Current The continuous flow of electric charge –The two types of current are direct current (DC) and alternating.

Circuits with more than one resistor, then Watt happens? Series and Parallel are the 2 ways of connecting multiple resistors.

Unit 5 Packet Answers Notes.

Electric Circuits.

describes the relationship between current, voltage, and resistance greater the voltage across a device with resistance, the greater the current through.

Unfortunate book names:. A circuit must contain a source of potential difference, and a path for the flow of charge. It will probably also contain.

Circuits. In circuits, elements are connected by wires. Any connected region of wire has the same potential. (same color = same potential) The potential.

Circuit Basics and Ohms Law. Types of Circuits There are two basic types of circuits SeriesParallel.

Parallel and Series Circuits 1 1 Definitions Voltage (V) –electric potential, measured in volts (V) Electric Current (I) –a measure of the rate at which.

CELLS IN SERIES AND PARALLEL.  Looking at the collection of batteries below you can probably guess that each type of battery and cell produces different.

Electrical Current and Circuits How Electricity Gets To Where It Is Going.

Electricity Sections 2 and 3. Electric Energy Cells/Batteries - Cell - device that produces an electrical current by converting chemical energy into electrical.

Electric Circuits. Electric circuit: a complete path from the positive terminal to the negative terminal.

Electric Circuit Types Series and Parallel Circuits.

CELLS IN SERIES AND PARALLEL Lesson 9. Cells in Series  The electric potential given to a single electron by a dry cell has an average voltage of around.

5.2.2 D.C. Circuits Practical circuits Electromotive force and internal resistance Kirchhoff’s laws Series and parallel arrangements Potential divider.

 Circuit = Complete path where electrons can flow  Circuit diagram symbols:  Wire/Conductor  Resistor (light bulbs, fans)  Battery  Switch.

Electric Circuits. Ohm’s Law Current, voltage, and resistance are related to one another. The relationship among resistance, voltage, and current is summed.

Electric Current and Electrical Energy Current Electric current is the rate at which charges pass a given point An electric current can be made.

4.2.Potential difference By- Saral Tayal. Potential Difference Definition Potential Difference: (Voltage) the difference in electric potential energy.

Determining Equivalent Resistance

WARM UP Draw a picture of a SERIES Circuit. Show a battery, a switch, and a light bulb in your drawing. Draw a picture of a PARALLEL Circuit. Show a battery,

Solving Circuits.

Chapter 7 Section 2.

Lesson 9 Parallel Circuits.

ELECTRICITY! SERIES AND PARALLEL CIRCUITS

Electric Potential Energy and Voltage

Parallel vs. Series Circuit

Kirchhoff’s Laws.

Topic H: Electrical circuits

Loads in Series: Current and Resistance

Series & Parallel Circuits

Electrical Current & Circuits

STATIC CHARGES I OR C? BATTERIES CURRENT CIRCUITS SCIENTISTS.

Resistance in Series and Parallel

Electricity Review.

Loads in Series: Current and Resistance

Chapter Twenty One: Electrical Systems

Science 9 Electricity Review.

Electricity Review.

Announcement Ohm’s law video is due at midnight Makeup lab today

Series and Parallel Circuits

Series and Parallel Circuit

Current and Ohms law.

Presentation transcript:

Series and Parallel Circuits

Cells in Series The electric potential given to a single electron by a dry cell has an average voltage of around 1.5V. By connecting batteries together in series the voltage of each cell is added to the total electric potential of a circuit.

Cells in Series When the electron leaves the first cell it is given a boost to 1.5 volts. It then enters the second cell and given another boost of 1.5 volts for a total of 3.0 volts. Cells can be added in series indefinitely to increase the voltage of the battery.

Cells in Parallel In some electronics the voltage required to run them can be quite low but in order for the device to run for any length of time larger or more batteries are needed.

Cells in Parallel We can add more energy (current) without adding more voltage by adding the cells in parallel. By doing this the run time of the electrical device can be increased.

Cells in Parallel and Series This increases the voltage and the current supplied to the circuit. The voltage is increased by the addition two batteries in series and the current is increased by the batteries in parallel.

Series Circuits with Multiple Loads As loads are added to a series circuit, the voltage stays the same but the current will decrease with each load added because with each load added there is more resistance making it harder for the current to flow

Series Circuits with Multiple Loads This follows ohms law. V = R x I. As we add more resistance the current will drop because voltage stays the same.

Parallel Circuits with Multiple Loads As loads are added to parallel circuits the current increases because the electricity has more places to flow. With each load added the voltage stays the same and the resistance decreases.

Parallel Circuits with Multiple Loads Due to Ohms law, if voltage stays the same and resistance drops, current must increase.

Lab – Page 506 Designing Circuits