Electronic Game

This is what the board looks like on the copper side… This is what the board looks like on the copper side…. This is where you solder.

This gives you an idea where each of the components is to go This gives you an idea where each of the components is to go. ALL components must be placed on this side.

Resistors 100R BROWN BLACK BROWN 10K BROWN BLACK ORANGE There is ONE 10K resistor, and SEVEN that are 100. (These are marked as ‘R’ on the board, one for each LED)

Chip holder (Dil socket Duel in line) Carefully fit the Dil socket Ensure the notch is facing the correct way Use masking tape to hold it in place Very carefully solder the Dil sockets 8 legs

SWITCHES The push to make and the slide switch go into position – both can be either way around

The LEDs need to be attached using the height jig The LEDs need to be attached using the height jig. Make sure you place them correctly, with the positive and negative legs in the right holes Flat edge _ +

Add power lead 3 V 0 V