Lecture on Field Effect Transistor (FET) by: GEC Bhavnagar

Slides:

Advertisements

Similar presentations

MICROWAVE FET Microwave FET : operates in the microwave frequencies

Advertisements

Chapter 6: Field-Effect Transistors

Field Effect Transistors

Field Effect Transistor characteristics

FET ( Field Effect Transistor)

FET ( Field Effect Transistor)

Chap. 5 Field-effect transistors (FET) Importance for LSI/VLSI –Low fabrication cost –Small size –Low power consumption Applications –Microprocessors –Memories.

ELEC 121 ELEC 121 Author unknown whsmsepiphany4.googlepages.com

FET ( Field Effect Transistor)

Lecture on Field Effect Transistor (FET) by:- Uttampreet Singh Lecturer-Electrical Engg. Govt. Polytechnic College, G.T.B.garh, Moga.

Chapter 28 Basic Transistor Theory. 2 Transistor Construction Bipolar Junction Transistor (BJT) –3 layers of doped semiconductor –2 p-n junctions –Layers.

Field Effect Transistors

Introduction to FET’s Current Controlled vs Voltage Controlled Devices.

Field-Effect Transistors

FET ( Field Effect Transistor)

Chapter 5: Field–Effect Transistors

Field Effect Transistor (FET)

DMT121 – ELECTRONIC DEVICES

Field Effect Transistors

CHAP3: MOS Field-Effect Transistors (MOSFETs)

Junction Field Effect Transistor

CHAPTER 5 FIELD EFFECT TRANSISTORS(part c) (FETs).

SMALL SIGNAL FET (Field– Effect Transistors) AMPLIFIER 1.Introduction/Basic 2.FET Small-Signal Model 3.Fixed-Bias Configuration 4.Self-Bias Configuration.

CHAPTER 5 FIELD EFFECT TRANSISTORS(part a) (FETs).

Field Effect Transistors

FET FET’s (Field – Effect Transistors) are much like BJT’s (Bipolar Junction Transistors). Similarities: • Amplifiers • Switching devices • Impedance matching.

course Name: Semiconductors

COURSE NAME: SEMICONDUCTORS Course Code: PHYS 473 Week No. 9.

SILVER OAK COLLEGE OF ENGG. & TECHNOLOGY  SUB – Electronics devices & Circuits  Topic- JFET  Student name – Kirmani Sehrish  Enroll. No

BJT transistors FET ( Field Effect Transistor) 1. Unipolar device i. e. operation depends on only one type of charge carriers (h or e) 2. Voltage controlled.

Hardik Patel & Jatin Patel

CHAPTER 4 :JFET Junction Field Effect Transistor.

FET ( Field Effect Transistor) 1.Unipolar device i. e. operation depends on only one type of charge carriers (h or e) 2.Voltage controlled.

FET JFET MOSFET Introduction  The MOSFET (metal oxide semiconductor field effect transistor) It is another category of field effect transistor.

JFET &MOSFET PREPARED BY  JAYSWAL JAYDEEP ( )  GOHIL DARSHAN ( )  PARMAR NARESH ( )  THAKOR MAHESH ( )

SIGMA INSTITUTE OF ENGINEERING DEPARTMENT OF ELECTRICAL ENGINEERING ACTIVE LEARNING ASSIGNMENT TOPIC ON: PREPARED BY; BHAGYASHRI SHRIVASTAV( )

Chapter 6 The Field Effect Transistor

MAHATMA PHULE A.S.C. COLLEGE, PANVEL Field Effect Transistor

Electronics The Sixteenth and Seventh Lectures

MOSFET The MOSFET (Metal Oxide Semiconductor Field Effect Transistor) transistor is a semiconductor device which is widely used for switching and amplifying.

MOS Field-Effect Transistors (MOSFETs)

Field Effect Transistor

FIELD EFFECT TRANSISTOR

Instrumentation & Power Electronic Systems

EMT 112 / 4 ANALOGUE ELECTRONICS

Recall Last Lecture Common collector Voltage gain and Current gain

ChapTer FiVE FIELD EFFECT TRANSISTORS (FETs)

GOVERMENT ENGINEERING COLLEGE

Field-effect transistors (FETs)

Lecture 20 OUTLINE The MOSFET (cont’d) Qualitative theory

Intro to Semiconductors and p-n junction devices

ELECTRONICS AND COMMUNICATION

Chapter 6 Field Effect Transistors (FETs)

6.3.3 Short Channel Effects When the channel length is small (less than 1m), high field effect must be considered. For Si, a better approximation of field-dependent.

Principles & Applications

Satish Pradhan Dnyanasadhana College, Thane

B.Sc. (Semester -5) Subject: Physics Course: US05CPHY05 Analog Devices and Circuits UNIT-I FET and MOSFET.

Analog Electronics Lecture 4:Transistors.

Reading: Finish Chapter 17,

DMT 121 – ELECTRONIC DEVICES

MOSFET POWERPOINT PRESENTATION BY:- POONAM SHARMA LECTURER ELECTRICAL

EMT 182 Analog Electronics I

Chapter 2 – Transistors – Part 2

LECTURE # 8 FIELD EFFECT TRANSISTOR (FET)

Lecture 20 OUTLINE The MOSFET (cont’d) Qualitative theory

Subject Name: Electronic Circuits Subject Code:10cs32

ELECTRONICS AND SOLID STATE DEVICES-II

JFET Junction Field Effect Transistor.

CHAPTER 63 FIELD EFFECT TRANSISTORS

Solid State Electronics ECE-1109

Presentation transcript:

Lecture on Field Effect Transistor (FET) by:- 140210111021 GEC Bhavnagar

What is FET? FET is uni-polar device i.e. operation depends on only one type of charge carriers (h or e) . It is a Voltage controlled Device (gate voltage controls drain current)

ADVANTAGES OF FET Very high input impedance (109-1012 ) Source and drain are interchangeable Low Voltage Low Current Operation is possible (Low-power consumption) Less Noisy No minority carrier storage (Turn off is faster) Very small in size, occupies very small space in ICs

Current Controlled vs Voltage Controlled Devices

Types of Field Effect Transistors (The Classification) JFET MOSFET (IGFET) JFET MOSFET (IGFET) JFET MOSFET (IGFET) n-Channel JFET p-Channel JFET FET FET FET FET FET Enhancement MOSFET Depletion MOSFET n-Channel EMOSFET n-Channel DMOSFET p-Channel DMOSFET p-Channel EMOSFET

JFET Construction There are two types of JFET’s: n-channel and p-channel. The n-channel is more widely used. There are three terminals: Drain (D) and Source (S) are connected to n-channel Gate (G) is connected to the p-type material

SYMBOLS Drain Drain Gate Gate Source Source p-channel JFET n-channel JFET

ID  IDSS As VGS becomes more negative: • the JFET will pinch-off at a lower voltage (Vp). • ID decreases (ID < IDSS) even though VDS is increased. • Eventually ID will reach 0A. VGS at this point is called Vp or VGS(off). • Also note that at high levels of VDS the JFET reaches a breakdown situation. ID will increases uncontrollably if VDS > VDSmax.

Transfer Characteristics The input-output transfer characteristic of the JFET is not as straight forward as it is for the BJT In a JFET, the relationship (Shockley’s Equation) between VGS (input voltage) and ID (output current) is used to define the transfer characteristics, and a little more complicated (and not linear): As a result, FET’s are often referred to a square law devices

Transfer (Transconductance) Curve From this graph it is easy to determine the value of ID for a given value of VGS It is also possible to determine IDSS and VP by looking at the knee where VGS is 0

p-Channel JFET p-Channel JFET operates in a similar manner as the n-channel JFET except the voltage polarities and current directions are reversed

P-Channel JFET Characteristics As VGS increases more positively the depletion zone increases ID decreases (ID < IDSS) eventually ID = 0A Also note that at high levels of VDS the JFET reaches a breakdown situation. ID increases uncontrollably if VDS > VDSmax.

MOSFET There are two types of MOSFET’s: Depletion mode MOSFET (D-MOSFET) Operates in Depletion mode the same way as a JFET when VGS  0 Operates in Enhancement mode like E-MOSFET when VGS > 0 Enhancement Mode MOSFET (E-MOSFET) Operates in Enhancement mode IDSS = 0 until VGS > VT (threshold voltage)

Depletion Mode MOSFET Construction The Drain (D) and Source (S) leads connect to the to n-doped regions These N-doped regions are connected via an n-channel This n-channel is connected to the Gate (G) via a thin insulating layer of SiO2 The n-doped material lies on a p-doped substrate that may have an additional terminal connection called SS

D-MOSFET Symbols

E-MOSFET Symbols

Summary Table JFET D-MOSFET E-MOSFET