Table 4. Mechanical properties of repair and substrate concrete

Slides:



Advertisements
Similar presentations
and Statistics, 2016, Vol. 4, No. 1, 1-8. doi: /ajams-4-1-1
Advertisements

ACI Fall 2016 Convention-Philadelphia
Percentage of Polyethylene
Properties Test results
© The Author(s) Published by Science and Education Publishing.
Biological (Effect on Pulp)
Modulus of elasticity (GPa) Shear modulus elasticity (GPa)
Dan Meng, C.K. Lee, Y.X. Zhang*
Research, 2015, Vol. 3, No. 6, doi: /education
© The Author(s) Published by Science and Education Publishing.
Table 5. Properties of The Tested Soil
Tensile strength (MPa) Length (m) of fibers/kg
NbB2 and TaB2 compounds at room temperature
Table 2. Physical properties of Portland cement
Tensile Strength (MPa)
Areas of Specialization
SON Nurse Practitioner Blackboard Community
Tensile Test after Firing
Rigidity Modulus (Gpa)
© The Author(s) Published by Science and Education Publishing.
Marshall characteristics
Tutorial in Mechanical Properties
Table 1. Chemical composition of materials
© The Author(s) Published by Science and Education Publishing.
Acrylic Type SOV SS df MS F–value p–value
Table 11. Chi-Square Analysis Based on Grade Shift for Study Group
Table 2. Student's t–test (Tensile Strength)
Table 1. The radial spheroidal functions
Total CO2 Emissions (Electricity + Fossil Fuel)
© The Author(s) Published by Science and Education Publishing.
Table 2. Waste characterization in Port Harcourt, Source [1]
Rating of Water Quality
Inscribed circle diameter
© The Author(s) Published by Science and Education Publishing.
Table 3. The needed requirements of the Concrete Sustainability
Number of categories that are mentioned (0% < categories < 5%)
Table 1. Geometric properties of steel tubes used
Table 2. Modal parameters estimated by Pulse Reflex®
© The Author(s) Published by Science and Education Publishing.
Table 1. The most important aspect applied in MIVES
No. Of units of single building Rated power (W) of unit load
Table 7. Status of CF in Nepal as of 2009
© The Author(s) Published by Science and Education Publishing.
Table 5. Pvalues of ttests for direction a
Entrapment Efficiency (%) ± S.D.
Interpass temperature
Table 2. Air-water flow cases
Table 1. Population by University
Table 3. Main properties of the thin brass electrode
Table 5. Maximum stress, strain and deformation values
Table 1. LLC Academics Outcome Report ( )
Table 1. Characterization Result of Leaded Petrol and Blends
Simulation Frequency(Hz)
Table 6. Pvalues of ttests for direction b
Table 2. Regression statistics for direction a
Table 3. Regression statistics for direction b
Table 3. List of PT specimens
Behavioral strategies
Table 6. Percentages of Indicators
Table 4. Surface roughness (outer faces)
Table 2. Control Valves & Bypass Valves Process Data
Control Valve Tag Number
© The Author(s) Published by Science and Education Publishing.
Table 1. Project Control Factors and their hierarchy
Table 1. K-T Diagram for Bicycle Seat
Category Quantity Secondary school 3 Student participant
Table 3. Surface roughness (inner faces)
Table 2. Pre and Post Test Scores for the Plaid Condition(N=16)
Compressive Strength difference at 1 week (MPa)
© The Author(s) Published by Science and Education Publishing.
Presentation transcript:

Table 4. Mechanical properties of repair and substrate concrete Compressive strength (MPa) 60.0 64.0 Flexural strength (MPa) 2.90 3.7 Tensile strength (MPa) 4.4 5.3 Modulus of elasticity (GPa) 37.0 35.0 Tensile bond strength (MPa) 5.2 Shear bond strength (MPa) 3.0 Niloufar Ghazanfari et al. Flexural Behavior of Post Tensioned Beams Damaged by Reinforcement Corrosion before and after Applying Patch-Repair. American Journal of Civil Engineering and Architecture, 2016, Vol. 4, No. 5, 171-180. doi:10.12691/ajcea-4-5-4 © The Author(s) 2015. Published by Science and Education Publishing.