Chris Booth Sheffield 29th March 2006

Slides:

Advertisements

Similar presentations

1 MICE Target Status Chris Booth 3 rd March 2004.

Advertisements

NLC - The Next Linear Collider Paul Czarapata Engineering Test Facility What is it and what does it do?

K. Long, 18 April, 2015 Beam-line status — red sky at night?

MICE Target Report Video Conference 15/03/07 Chris Booth Sheffield 15 th March 2007.

MICE Target Report Chris Booth (for target team) Sheffield 23 rd April 2009.

Andrew Moss ASTeC MICE Project Board 28 th June 2011 MICE RF System.

The MICE Target Lara Howlett University of Sheffield.

Progress on Target Design Chris Booth Sheffield 2 nd August 2004.

MICE Target Status Chris Booth 30 th March Chris BoothUniversity of Sheffield 2 The challenge ISIS beam shrinks from 73 mm to 55 mm radius during.

Target Status Report Lara Howlett University of Sheffield.

MICE TARGET HARDWARE C. Booth, P. Hodgson, R. Nicholson, P. J. Smith, Dept. of Physics & Astronomy University of Sheffield, England. 1 - The MICE Experiment.

MICE Target Development Chris Booth Sheffield 8 th June 2006.

MICE Target Report Chris Booth (for target team) Sheffield 7 th May 2009.

AFC engineering group meeting on the 26 th of Jan 2004 MICE Absorber Focus Coil work schedule for the next 6 months By Wing Lau, Oxford.

MICE Target Schedule Chris Booth Sheffield 12 th June 2006.

1 MICE PM Report General Update –Phase I civil engineering –R5.2 in June –Phase II design work –Phase II hardware –A few questions –Schedule, milestones.

Progress on Target Design Chris Booth Sheffield 14 th July 2004.

K. Long, 14 June, 2015  Target K. Long, Friday, 24 th April 2009.

P J SmithUniversity of Sheffield1 MICE Target Electronics Paul J Smith University of Sheffield Fermilab 10 th June 2006.

MICE Target Status Chris Booth Sheffield 10 th May 2006.

TARGET WORKSHOP – SHEFFIELD HALLAM UNIVERSITY Monday 2 March 2009 The ISIS – MICE interface Eddie McCarron Contents 1.Target alignment with ISIS beam centre.

Target Update – Mico Meeting Monday 21 st April 2008 General Expect to obtain new coils for stators anytime New Shafts at RAL for metrology. Will be back.

Stator Plan & Schedule Chris Booth 2 nd March stators to construct for mid-April. One complete coil assembly recovered from ISIS drive. Coils recoverable.

Andrei Nomerotski 1 External Electronics : WP4 Andrei Nomerotski, LCFI Collaboration Meeting 28 March 2006 Outline  Test Boards for Sensors : MotherBoards.

MICE Target Review Chris Booth Sheffield 12 th June 2006.

A Tale of Two Targets … 7 th September 2009 Chris Booth The University of Sheffield.

Target Controller Electronics Upgrade Status P. Smith J. Leaver.

MICE Target Report Video Conference 05/07/07 Chris Booth Sheffield 5 th July 2007.

Target Design – Status and Plans Chris Booth Sheffield 12 th January 2005.

MICE: overview K. Long, 18 March, Contents ► Introduction ► Beam line ► Infrastructure ► MICE steps ► Phase II (comment) ► Conclusions.

Control and Monitoring System / EPICS Pete Owens Daresbury Laboratory.

MICE Target Mechanism P J Smith University of Sheffield MICE CM 18 RAL June 2007.

S A Griffiths Target Review Jan 2009 Target Electrical / Control Schematic HexBridge Power electronics Interface PSU Capacitor Bank Local Control Interface.

MICE Target – Design Update and Test Plans Chris Booth Sheffield 22 nd October 2005.

MICE RF – TIARA and General Progress Tim Stanley RAL 5 June 2013.

MICE Controls Progress 15 th March 2007 * Controls Infrastructure * Controls network * Target * Superconducting Solenoid * Magnet Power Supplies * Hydrogen.

MICE MICE Target Mechanism Control Electronics Upgrade P J Smith – University of Sheffield James Leaver – Imperial College 2 nd March 2009.

Electrical Integration CM38 Steve Griffiths & Ian Mullacrane.

Status of installed target Preparation of “demonstrator” target Chris Booth Sheffield 25 th January 2008.

MICE Target - Risk Lara Howlett University of Sheffield.

Target Status Target installed in ISIS “Demonstrator” target in R78 Chris Booth Sheffield 7 th February 2008.

Target Installation Plan. Requirement Assemble and test two complete target systems in time for August shutdown How do we do this? What do we need to.

MICE Target Mechanical Design l Status of Target ref. Schedule »Drawings –Drawing list created (see next slide) includes inventory –Drawings being released.

MICE Target Development Lara Howlett University of Sheffield.

Status of Target Design Chris Booth Sheffield 28 th October 2004.

Jason Tarrant / November 2008 MICE Target Mechanical Design l Jason Tarrant – STFC l Introduction »Investigations into target shaft failure »Current suspicions.

MICE Target Installation Chris Booth & Paul Smith Sheffield 26 th July 2007.

Target tests 1 st – 2 nd Nov. Chris Booth Sheffield 7 th December 2006.

MICE Project Report Alan Bross (for Paul Drumm). Project Issues ● Key dates: – ISIS Synchrotron start-up scheduled for 1st August ● Shielded area around.

Target Commissioning Target installed in ISIS “Demonstrator” target in R78 Initial commissioning plans Chris Booth Sheffield 11 th February 2008.

Programme for “Target 3” – test of alternative bearing materials (from Jason Tarrant) –Drawing updates by 11 th November –Bearings: Material approval –

9/12/2003Ivan Hruska1 First box prototype –Box design in July ‘03 –Box produced during August ’03 Tested last week in few fingers Small changes necessary.

Technical Board Summary Alan Bross MICE CM17 CERN February 25, 2007.

MICE Project Progress Update Power Converters Rack housing MQ1 to MQ3 magnet power converters –Marshalling for all other quadrupole & dipole units –Houses.

Chris BoothUniversity of Sheffield 1 Target Status & Progress 1 st February 2006 Disappointingly slow progress over last 2 months. However, progress is.

MICE RF – Installation at RAL Tim Stanley RAL 7 November 2013.

MICE Target – Status & Plans Chris Booth Sheffield 28 th February 2006.

What do we want to achieve in this running period? Michael S. Zisman Deputy Spokesmouse Center for Beam Physics Lawrence Berkeley National Laboratory MICO.

Target Status 27 th August 2009 Chris Booth The University of Sheffield.

The Target Drive For The MICE Experiment Control and Infrastructure Optical Readout and Drive Electronics Target Drive A linear electromagnetic drive has.

Andrew Moss ASTeC, Daresbury Laboratory October 2010 MICE RF Amplifier Status.

Stator Plan & Schedule Chris Booth 2nd March 2009

Target Installation Plan

MICE RF System Power Supplies, Control and Monitoring Status report

MICE Target Report Video Conference 29/11/07

MICE PM Report Progress with the Infrastructure A few problems

Status of Target Design

TSF Upgrade Project Overview Resources Plans and Timetable

QXF schedule and milestones

Presentation transcript:

Chris Booth Sheffield 29th March 2006 MICE Target Status Chris Booth Sheffield 29th March 2006

University of Sheffield Major Milestones: Full assembly test at RAL – 24th – 28th April ISIS test (low power electronics) – June* ISIS test (full electronics) – October* (* exact date dependent on ISIS schedule) Chris Booth University of Sheffield

Work required for April test (1) Stator delivered by Manchester was not built to specs! Cannot use. Coil winding in progress. Body parts manufactured. Alternative potting scheme possible (improve heat flow). Glass cap & flange for readout planned. Chris Booth University of Sheffield

Work required for April test (2) Final dimensions of shaft clarified with Oxford. Major work on stator  lack of technical effort in Sheffield. Oxford agreed to assemble shuttle. Meeting in Oxford next week to finalise details (shaft, target, stop, magnets, alignment & readout vanes; cleaning). Steel tube – replace with Ti later. Chris Booth University of Sheffield

Work required for April test (3) Control hardware & software developed with no Hall magnet commutator – being debugged. Pseudo-current-controller built. Boards being crate-mounted for transport and reliability! Tests & monitoring. Chris Booth University of Sheffield

University of Sheffield Immediate milestones Electronics test (with existing prototype) 11th April Target assembly (stator, shaft, cap) 13th April To RAL 24th April Chris Booth University of Sheffield

University of Sheffield April test objectives Test compatibility of Sheffield & RAL components. Demonstrate vacuum cleanliness. Demonstrate reliability. Measure performance, vibration etc at 8A. Chris Booth University of Sheffield

University of Sheffield Work required for June Shuttle with Ti shaft. Interface to ISIS control & timing. Improved analogue electronics. Optimised control. DAQ & monitoring software. Tests with 50 m cables. Decision on location of drive circuit. Chris Booth University of Sheffield

Future Plans (for October) Hardware changes based on experience. High current drive circuitry: Two days of meetings with Daresbury electronic engineers (DL, Sheffield). Basic design is sound. No commercial alternative. They will enhance drive to ?80 A? Power supply – capacitor bank and charger. June results will feed into design requirements. Chris Booth University of Sheffield