Numericals.

Slides:



Advertisements
Similar presentations
College of Engineering Capacity Allocation in Multi-cell UMTS Networks for Different Spreading Factors with Perfect and Imperfect Power Control Robert.
Advertisements

Florida Institute of technologies ECE 5221 Personal Communication Systems Prepared by: Dr. Ivica Kostanic Lecture 7: Example of link budgets and coverage.
Quiz Determine the minimum number of shift register stages required to create a maximal length PN sequence which has a repetition time greater than 10.
Multiple Access Techniques for wireless communication
EE359 – Lecture 3 Outline Log Normal Shadowing
Copyright © 2003, Dr. Dharma P. Agrawal and Dr. Qing-An Zeng. All rights reserved. 1 Chapter 3 Mobile Radio Propagation.
Propagation Characteristics
EELE 5490, Fall, 2009 Wireless Communications Ali S. Afana Department of Electrical Engineering Class 6 Dec. 4 th, 2009.
Copyright © 2011, Dr. Dharma P. Agrawal and Dr. Qing-An Zeng. All rights reserved. 1 Chapter 3 Mobile Radio Propagation.
Propagation loss models Lab 4 Engr. Mehran Mamonai.
Florida Institute of technologies ECE 5221 Personal Communication Systems Prepared by: Dr. Ivica Kostanic Lecture 5: Example of a macroscopic propagation.
Lab 2 COMMUNICATION TECHNOLOGY II. Capacity of a System The bit rate of a system increases with an increase in the number of signal levels we use to denote.
08/16/01. Link Budgets for Cellular Networks Presented by Eric Johnson.
Summary of Path Loss in Propagation
In this Lecture More on handoff Co-channel interference Trunking
Improving Capacity in Cellular Systems
08/16/01.
EELE 5490, Fall, 2009 Wireless Communications
Polytechnic University© 2002 by H. L. Bertoni1 III. Spherical Waves and Radiation Antennas radiate spherical waves into free space Receiving antennas,
Wireless Communication Channels: Small-Scale Fading
Wireless Communication Channels: Large-Scale Pathloss
ECE 4730: Lecture #5 1 Cellular Interference  Two major types of system-generated interference : 1) Co-Channel Interference (CCI) 2) Adjacent Channel.
Wireless Communication Channels: Small-Scale Fading
Cellular System Capacity Maximum number of users a cellular system can support in any cell. Can be defined for any system. Typically assumes symmetric.
WIRELESS COMMUNICATIONS Assist.Prof.Dr. Nuray At.
ECE 5221 Personal Communication Systems
Ron Milione Ph.D. W2TAP W2TAP InformationModulatorAmplifier Ant Feedline Transmitter InformationDemodulatorPre-Amplifier Ant Feedline Receiver Filter.
Submission doc.: IEEE 11-11/1455r0 Nov 2011 Fei Tong,Les Smith, CSRSlide ah network outdoor deployment issues Date: 2011-Nov-03 Authors:
Adapted from Rappaport’s Chapter 4 Mobile Radio Propagation: Large-Scale Path Loss The transmission path between the transmitter and the receiver can vary.
Sensitivity System sensitivity is defined as the available input signal level Si for a given (SNR)O Si is called the minimum detectable signal An expression.
Lecture 2 The Cellular Concept Prof. Shamik Sengupta Office 4210 N Fall 2010.
Cell Coverage for Signal and Traffic
134GHz – The new frontier Sam Jewell, G4DDK RAL 2007.
College of Engineering WiFi and WCDMA Network Design Robert Akl, D.Sc. Department of Computer Science and Engineering Robert Akl, D.Sc. Department of Computer.
EPL 476 Fundamental Concepts in Wireless Networks
24/03/2003Jacques MdM / REF France1 HF Receivers desensitisation from wideband noise spurious in HF bands (1.8 to 30 MHZ) Impact of spurious radiations.
ECE 4710: Lecture #36 1 Chapter 8  Chapter 8 : Wired and Wireless Communication Systems  Telephone  Fiber Optic  DSL  Satellite  Digital & Analog.
Question 1 Find the following using dB and dBm transformations: a) Power in dB for 22 W b) Power in dBm for 4.8 W c) Power in W for 25 dB.
Propagation Models Large scale models predict behavior averaged over distances >>  Function of distance & significant environmental features, roughly.
A Distributed Relay-Assignment Algorithm for Cooperative Communications in Wireless Networks ICC 2006 Ahmed K. Sadek, Zhu Han, and K. J. Ray Liu Department.
1 Validation of an improved location-based handover algorithm using GSM measurement data Hsin-Piao Lin; Rong-Terng Juang; Ding-Bing Lin IEEE Transactions.
Chapter 3 Mobile Radio Propagation
Tutorial 8 Mobile Communications Netrowks. Prob.1 Construct 4 Walsh (Orthogonal) codes for 4 different users by two methods. Assume that 4 users transmit.
RF Propagation No. 1  Seattle Pacific University Basic RF Transmission Concepts.
1 Introduction to Fading Channels, part 1 Dr. Essam Sourour Alexandria University, Faculty of Engineering, Dept. Of Electrical Engineering.
Chapter 1 : Part 3 Noise. Noise, interference and distortion  Noise  unwanted signals that coincide with the desired signals.  Two type of noise: internal.
EENG473 Mobile Communications Module 3 : Week # (10) Mobile Radio Propagation: Large-Scale Path Loss.
Doc.: IEEE Submission Nov 2014 Link Budget Analysis for 40-50GHz Indoor Usage Date: Authors: Slide 1Jianhan Liu, Mediatek Inc.
1) A binary transmission system uses a 8-bit word encoding system. Find the Bandwidth and the SNR dB of the system if the channel capacity is bps.
1 A TECHNICAL BRIEFING FOR AMATEUR RADIO OPERATORS “HOW FAR CAN YOU TALK ON A 2 METER HANDHELD RADIO” PRESENTED TO: ARASWF Naples, FL MARCH 2015.
COMP1706: MOBILE AND NETWORK TECHNOLOGIES Cellular technologies Dr. George Loukas University of Greenwich.
8.5 SATELLITE COMMUNICATIONS
Measurements An comparison between the RTL-SDR and SDRplay.
EEE 441 Wireless And Mobile Communications
ALLAH ALLAH. Compiled by :Engr.Muhammad Waseem( MS Telecommunication,England,BS.(ssuet)). Assistant Professor, Telecom Eng.Deptt. Sir Syed University.
Shadowing.
Mobile Radio Propagation: Large-Scale Path Loss
PROPAGATION OF RADIO WAVES
A Problem in LTE Communication
CMA46 Questions & Answers.
Tropo-Scatter Link Budget
LRTC 3.4 – 3.8 GHz Ericsson input PT1 XO 29 – 31/
Cellular and Wireless Networks System Design Fundamentals
Evaluation Model for LTE-Advanced
Concept of Power Control in Cellular Communication Channels
Practical Radio Propagation Models
Wireless Communications Chapter 4
MITP 413: Wireless Technologies Week 3
Presentation transcript:

Numericals

A cellular mobile communication system is operating at the carrier frequency of 900 MHz. The cell radius is R = 2.5 km. A mobile unit is located at the edge of a cell. For what percentage of time the received signal power by this mobile unit is greater than –70 dBm? Assume the following: The close-in reference distance d0 = 1 km (the propagation loss until the close in reference distance is open space propagation loss). Transmitter power Pt = 10W, the receiver and the transmitter antenna gains are Gt=3 dB and Gr=0 dB, respectively. The propagation beyond the close-in distance occurs with a path loss exponent n=4 and follows a log-normal distribution with standard deviation =6.5dB.

A transmitter provides 10 W to the transmitter antenna having 12 dB gain. The receiver antenna has a gain of 3 dB and the receiver bandwidth is 200 kHz. The receiver noise figure is 8 dB and the carrier frequency is 900 MHz. Determine the minimum number of cells that can ensure an SNR of 20 dB provided for 95% of the time in Islamabad City. The area of Islamabad City is 906 km2 and the average temperature in Islamabad is 27 o C. Assume the path loss exponent n=4, the close-in reference distance d0=1 km and the log-normal shadowing standard deviation =8 dB.  

Determine the number of omni-directional cells required to cover a 1000 sq. km area cellular mobile system at 900 MHz. Assume the sensitivity of cellular mobile receivers is equal to -100 dBm, the close-in reference distance d0=1 km, transmitter power Pt=1W, the receiver and the transmitter antenna gains are Gt=Gr=2 and the path loss exponent n=4. Assume that the propagation loss until the close in reference distance is in fact open space propagation loss.

A transmitter provides 1 W to the transmitter antenna having 12 dB gain. The receiver antenna has a gain of 3 dB and the receiver bandwidth is 200 kHz. The receiver noise figure is 8 dB and the carrier frequency is 900 MHz. Determine the radius of the cell that can ensure an SNR of 20 dB provided for 90% of the time. Assume the path loss exponent n=4, the close-in reference distance d0=1 m and the log-normal shadowing standard deviation =8 dB. The average temperature in the region remains at 27 o C.