DOMESTIC DRAINAGE SYSTEM 2012BC25444

Slides:

Advertisements

Similar presentations

Advertisements

4. What is the boundary between two drainage basins called?

Typical Plumbing System

Waste Pipe from Bath The waste pipe from the bath should be a minimum of 40mm in diameter, it can be 50mm in diameter if there is a longer run of pipe.

Domestic Hot and Cold Water Services

Plumbing System Albert Einstein was named an honorary member of the Plumbers and Steamfitters Union after publicly stating that he would become a plumber.

Chapter 20 Plumbing Plans.

Mains Sewage Systems. Name: Padraig McMahon Module: Building services.

Chapter 3.1 Storm Drainage Sizing. Building Drain & Sewer  Building Drain —That part of the lowest piping of a drainage system that receives the discharge.

As presented by: Rodger Schuldt TCEQ Installer II License # OS19898 TCEQ Maintenance Provider License # MP00545 TCEQ Site Evaluator License # OS20270.

B.ARCH. SEMESTER-II AR 126 BUILDING TECHNOLOGY – P/H UNIVERSITY INSTITUTE OF ARCHITECTURE Scheme of Teaching L T P Total Scheme of Examination.

Trade of Plumbing – Phase 2 Module 2 – Unit 11 Module 2: Domestic Hot and Cold Water Services Unit 11 – Sanitary Appliances Duration – 11 Hours.

Trade of Plumbing – Phase 2 Module 2 – Unit 12 Module 2: Domestic Hot and Cold Water Services Unit 12 – Above Ground Sanitation Pipework Duration – 18.

The Objectives of storm water drainage To prevent erosion in hillside areas (paved roads and terracing are needed) To prevent land-slides To improve the.

Chapter 3.1 Storm Drainage Sizing. Building Drain & Sewer  Building Drain —That part of the lowest piping of a drainage system that receives the discharge.

Sanitary System. Function the SANITARY system handles waste water from wash basins, sinks, showers baths, galley equipment as well as waste water from.

Australasian Scientific Review of Reduction of Flows On Plumbing and Drainage Systems – ASFlow Mr Jeff Clark.

Presentation on Trap Loss

© Goodheart-Willcox Co., Inc. Permission granted to reproduce for educational use only Warm-up 4/6/15 What type of water do you have at your house? Objective:

Building drainage.

Sanitary Engineering.

SEWER PIPING DESIGN Sewer piping differs from water piping, in that sewer pipes are not under pressure. The function that takes place inside sewer pipes.

Andrew Franks. A large bowl for urinating or defecating into, typically plumbed into a sewage system and with a flushing mechanism Vent distance- 10’

Developing Green Stormwater Design Solutions For UIC Compliance Presented by: Adam Zucker PE, CWRE 819 SE Morrison Street ● Suite 310 ● Portland, Oregon.

Residential Construction Unit 5 Energy Efficiencies and Mechanicals Mr. Todzia.

BUILDING MATERIAL BUILDING MATERIAL PALESTINE UNIVERSITY chapter No.#7 Mechanical Works Dr. Ali Ibrahim Tayeh.

NGfL CYMRU GCaD PLUMBING APPLIANCES & COMPONENTS.

SANITARY ENGINEERING 1 COURSE OUTLINE

Wastewater Treatment. Waste water is collected in a sewer system (a series of underground pipes that carry water to facility) Waste water is collected.

Bathrooms & Kitchens Water, Grey Water & Waste-Water.

Flood Prevention Measures The first six months of 2013 have seen a significant increase in flooding of both tertiary and machine installation. The following.

SANITARY ENGINEERING Planning, designing and installation of system for the collection, conveyance, treatment and disposal of the waste.

TREATMENT PROCESS (Chicago)

Water Recycling. Why? Do you think water should be recycled? Why? How do you think water is recycled?

What is an Illicit Discharge?  "Federal regulations define an illicit discharge as: ‘…any discharge to a Municipal Separate Storm Sewer System (MS4) that.

House Drainage System By- Prajyoti P. Upganlawar

HOUSE DRAINAGE MEHTA ANJANI PRAFULBHAI =

DR. S & S. S. GHANDHY GOVERNMENT ENGINEERING COLLEGE , SURAT

Unit 209: Drainage systems

Unit 209: Drainage systems

N ATIONAL D IPLOMA M ECHANICAL AND E LECTRICAL S ERVICES C ONSTRUCTION Drainage Design.

Unit 209: Drainage systems

Water Supply System And Other Plumbing Fittings

Resources Required : AS/NZ 3500 : Part 0 : 2003 Plumbing and drainage

Designing property drainage systems

High Density Polyethylene Pipe and Fittings

Mahatma Gandhi Institute Of Technical Education & Research centre ,Navsari. A presentation on House Drainage Subject :- Environmental engineering.

Partially separate system

Plumbing System Albert Einstein was named an honorary member of the Plumbers and Steamfitters Union after publicly stating that he would become a plumber.

UNIT I & II - MCQ.

Approximate activity space required

Manitoba Building Officials Conference

General Road Construction Information

Heating Ventilation and Air Conditioning

RESIDENTIAL PLUMBING SYSTEMS (WASTEWATER)

PLUMBING APPLIANCES & COMPONENTS

Heating Ventilation and Air Conditioning

Typical Plumbing System

ME444 ENGINEERING PIPING SYSTEM DESIGN

Plumbing System Albert Einstein was named an honorary member of the Plumbers and Steamfitters Union after publicly stating that he would become a plumber.

Domestic Hot and Cold Water Service

البزل Drainage ا.م.د. حياوي ويوه الجوذري.

Heating Ventilation and Air Conditioning

Rivers and Streams.

Water Types of water Sewer systems TCU/VIA 6th semester workshop

Plumbing System Albert Einstein was named an honorary member of the Plumbers and Steamfitters Union after publicly stating that he would become a plumber.

Educational Technology

Inspection chamber - IC Inspection chamber - IC

Full Service Plumbing Columbus, Ohio. plumbing The art and science of creating and maintaining sanitary conditions in a building used by humans. It is.

Presentation transcript:

DOMESTIC DRAINAGE SYSTEM 2012BC25444

INTRODUCTION Drainage is a system of pipe work underground to convey the discharge from sanitary fitting and drain pipe to a suitable disposal installation.

TYPE OF DRAINAGE There are two types of drainage These are [a] Surface water drainage [b] Foul water drainage

SURFACE WATER DRAINAGE Surface water within the building are open paved yard may be discharged with gullies dug in permeable ground and may also convey to sewer through surface water drain.

FOUL WATER DRAINAGE Foul water is classified into:- [i] Waste water- this the discharge from the kitchen, sink, bath and wash hand basin [ii] Soil waste-discharge from waste water from closet and urinals. Foul water can be conveyed out of the building by use of :- [i] one pipe system [ii] two pipe system [iii] single stack system.

REQUIREMENT FOR SINGLE STACK SYSTEM Sanitary fittings must be grouped closely to the main pipe so that the branch is short as possible. Bath, basin and sink must be connected separately to the main stack. Waste pipe must have a fall gradient of between 1/48 and 1/12. This reduce the possibility of self siphonage of the seal trap.