Presentation is loading. Please wait.

Presentation is loading. Please wait.

Penn State University Environmental Health and Safety Hazard Assessment and Personal Protective Equipment (PPE) Training.

Similar presentations


Presentation on theme: "Penn State University Environmental Health and Safety Hazard Assessment and Personal Protective Equipment (PPE) Training."— Presentation transcript:

1 Penn State University Environmental Health and Safety Hazard Assessment and Personal Protective Equipment (PPE) Training

2 Objectives Review general concept of personal protective equipment. Show steps on how to conduct a hazard assessment. Cover the process for training employees.

3 What is Personal Protective Equipment (PPE)? Commonly referred to as “PPE” Includes a wide variety of devices PPE acts as a “barrier” against hazards

4 Hierarchy of Controls PPE should be the last line of defense against a hazard, not the primary one. Engineering Controls Administrative Controls If Engineering and Administrative Controls both fail to neutralize a hazard, PPE must be used. In many cases PPE should be worn as an additional line of defense in case these controls fail.

5 What is a “Hazard Assessment”? Helps to determine: If Personal Protective Equipment (PPE) is needed What type of PPE is needed Where and when PPE is needed Who needs it

6 Why is a Hazard Assessment important? To keep workers safe. To establish the minimum PPE requirements for job tasks and/or work areas with potential injury exposure. To comply with OSHA regulations.

7 What PPE is being used here?

8 Is this PPE Adequate?

9 What is good and what is bad with these worker’s PPE?

10 Is this PPE Adequate?

11

12 Requirements for Hazard Assessments One must be completed for EACH work area and/or job where a potential hazard exists. If similar jobs are to be completed in different work areas, only one Hazard Assessment needs to be completed. However, a form should still be filled out and make reference to the form from the other area.

13 Employee Involvement It is recommended that employees be given the hazard assessments to see if there was anything that may have been overlooked. This will help to identify any tasks that may have been missed. Getting employees involved in the process will also help them to understand where the assessments came from and how they were performed, which should encourage them to implement any new procedures.

14 Where Can I Find the Tools Needed to Perform a Hazard Assessment? Penn State has developed a PPE program. Included in the program are the following tools: –PPE Hazard Assessment Certification for Common Tasks and Work Areas. –PPE Hazard Assessment Worksheet. –Summary of PPE Requirements. The program can be found on the PSU EHS website under the Workplace Safety link.

15 The Hazard Assessment Process List all job tasks in first column of Appendix C - “Summary of PPE Requirements” Does the job task match any of those listed on Appendix A - “Common Task List?” YES Fill in remaining two columns of Appendix C using the information provided in the Common Task List NO Use Appendix B –”PPE Hazard Assessment Worksheet” to determine proper PPE for that job task Fill in the remaining columns of Appendix C using this information

16 Step 1 – Appendix C

17 Sheet Metal Work Cuts, Falling Objects, Flying Particles Safety Glasses, Cut Resistant Gloves, Safety Shoes Step 2 – Look at Appendix A

18 Sheet Metal Work Cuts, Falling Objects, Flying Particles Safety Glasses, Cut Resistant Gloves, Safety Shoes Step 3 – copy information from Appendix A onto Appendix C

19 Step 4 – continue onto the next task

20 What if task isn’t on Appendix A? Go to Appendix B and complete the checklist for each category (eyes, face, head, etc.) List any findings in Appendix C Appendix B

21 What if I do not find hazards? You still must complete the form in Appendix C – “Summary of PPE Requirements” as proof that you performed the assessment. If no PPE is needed based on the Hazard Assessment, no training is necessary.

22 Keeping your assessments accurate If the scope of any job changes, the hazard assessment must be edited. – Ex) If a non-acid based cleaner was replaced with an acid based cleaner. Additionally, periodic checks are recommended to ensure the forms are up to date and accurate as possible. This form should be maintained by the Supervisor and readily available to the employees.

23 Training your employees about proper PPE use

24 Why is Training Needed? Because employees need to know: – When PPE is necessary. – What PPE is necessary. – How to properly don, doff, adjust, and wear PPE. – The limitations of PPE. – What the proper care, maintenance, useful life, and disposal of PPE is. – Who needs PPE. Training is required under OSHA 29CFR132-140.

25 PSU Approach to PPE Training Each Supervisor is responsible for ensuring their employees are trained in PPE. Training should be given upon completion of the hazard assessments. When any new employees are hired, PPE training should be completed before they begin working.

26 How do I train my employees? A PowerPoint presentation is available to use as a training tool. The PowerPoint presentation can be edited to meet your needs. Some of these topics in the powerpoint can be deleted if that particular type of PPE is not utilized. – For example, if respiratory use was not needed according to your Hazard Assessment you can eliminate these slides.

27 Training Certification Upon completion of the training, Appendix D – “PPE Training Certification Form” must be filled in with: – Name of each employee trained – The date – The scope of the training given

28 PPE Retraining Retraining is required for, but not limited to, the following: Changes in the workplace or changes in the types of PPE to be used which would render previous training obsolete or; Inadequacies in an employee's knowledge in the use of the assigned PPE. Written certification that contains the name of each employee trained, the date, and the scope of the training is required for proof of retraining.

29 Questions, Comments, Concerns? If you need additional information, you can: – Contact your Safety Officer – Refer to the PSU PPE Program http://www.ehs.psu.edu – Contact Environmental Health and Safety 6 Eisenhower Parking Deck, University Park (814)865-6391

30 Summary PPE is the last line of defense against hazards. PPE hazard assessments are needed to determine the correct PPE required. Employees need to be trained on the PPE they are required to wear.


Download ppt "Penn State University Environmental Health and Safety Hazard Assessment and Personal Protective Equipment (PPE) Training."

Similar presentations


Ads by Google