1. Materials needed: a tree in a pot, shovel, watering can, poles, garden scissors, hammer

2. Tree planting steps Before you plant, you must remove the tree from the pot carefully. To succeed in a safe and secure at the root of the tree well watered. This watering will help him adapt to the new ground in the garden.

3. With a spade, dig a hole three times larger than the pot diameter and 30 cm deep (root activity is concentrated mostly in the upper soil).

4. Check the depth and diameter hole is required with a roulette. When needed, add more soil or dig.

5. Remove shrubs in forest ocoliul You should come out pretty easily.

6. Put the tree in the hole. Close to the trunk, dig a sloping poles to 45 degrees, and take care not to disturb the tree roots. Take care: the tree should be well positioned against the dominant winds

7. Fill the hole with soil. Do not put fertilizer in order to force the roots to seek their own nutrition materials. Fertilizers are needed only if the soil is poor or sandy. Tamped down easy.

8. Set tree stakes with a belt or a wire, about 45 cm from the ground to allow you to lean in the wind. To avoid damage to tree bark, carried a bit of strap (wire) as the tree grows.

9. Wet thoroughly after planting and during the first two years, when the weather is dry. At the bottom, you can put a pile of dry leaves 8 inches tall in the garden.

10. Over the next two or three years, cut the branches that have grown well (that touch each other or rub). Cut close to your body, not to leave unsightly stumps and dangerous.