1. FPGA-Based System Design: Chapter 3 Copyright  2004 Prentice Hall PTR Topics n Latches and flip-flops. n RAMs and ROMs.

2. FPGA-Based System Design: Chapter 3 Copyright  2004 Prentice Hall PTR Register n Stores a value as controlled by clock. n May have load signal, etc. n In CMOS, memory is created by: –capacitance (dynamic); –feedback (static).

3. FPGA-Based System Design: Chapter 3 Copyright  2004 Prentice Hall PTR Variations in registers n Form of required clock signal. n How behavior of data input around clock affects the stored value. n When the stored value is presented to the output. n Whether there is ever a combinational path from input to output.

4. FPGA-Based System Design: Chapter 3 Copyright  2004 Prentice Hall PTR Register terminology n Latch: transparent when internal memory is being set from input. n Flip-flop: not transparent—reading input and changing output are separate events.

5. FPGA-Based System Design: Chapter 3 Copyright  2004 Prentice Hall PTR Clock terminology n Clock edge: rising or falling transition. n Duty cycle: fraction of clock period for which clock is active (e.g., for active-low clock, fraction of time clock is 0).

6. FPGA-Based System Design: Chapter 3 Copyright  2004 Prentice Hall PTR Registerd parameters n Setup time: time before clock during which data input must be stable. n Hold time: time after clock event for which data input must remain stable. clock data

7. FPGA-Based System Design: Chapter 3 Copyright  2004 Prentice Hall PTR Dynamic latch Stores charge on inverter gate capacitance:

8. FPGA-Based System Design: Chapter 3 Copyright  2004 Prentice Hall PTR Latch characteristics n Uses complementary transmission gate to ensure that storage node is always strongly driven. n Latch is transparent when transmission gate is closed. n Storage capacitance comes primarily from inverter gate capacitance.

9. FPGA-Based System Design: Chapter 3 Copyright  2004 Prentice Hall PTR Latch operation  = 0: transmission gate is off, inverter output is determined by storage node.  = 1: transmission gate is on, inverter output follows D input. n Setup and hold times determined by transmission gate—must ensure that value stored on transmission gate is solid.

10. FPGA-Based System Design: Chapter 3 Copyright  2004 Prentice Hall PTR Stored charge leakage n Stored charge leaks away due to reverse- bias leakage current. n Stored value is good for about 1 ms. n Value must be rewritten to be valid. n If not loaded every cycle, must ensure that latch is loaded often enough to keep data valid.

11. FPGA-Based System Design: Chapter 3 Copyright  2004 Prentice Hall PTR Multiplexer dynamic latch

12. FPGA-Based System Design: Chapter 3 Copyright  2004 Prentice Hall PTR Non-dynamic latches n Must use feedback to restore value. n Some latches are static on one phase (pseudo-static)—load on one phase, activate feedback on other phase.

13. FPGA-Based System Design: Chapter 3 Copyright  2004 Prentice Hall PTR Recirculating latch Static on one phase:

14. FPGA-Based System Design: Chapter 3 Copyright  2004 Prentice Hall PTR Edge-triggered flip-flop  DQ

15. FPGA-Based System Design: Chapter 3 Copyright  2004 Prentice Hall PTR Master-slave operation  = 0: master latch is disabled; slave latch is enabled, but master latch output is stable, so output does not change.  = 1: master latch is enabled, loading value from input; slave latch is disabled, maintaining old output value.

16. FPGA-Based System Design: Chapter 3 Copyright  2004 Prentice Hall PTR High-density memory architecture

17. FPGA-Based System Design: Chapter 3 Copyright  2004 Prentice Hall PTR Memory operation n Address is divided into row, column. –Row may contain full word or more than one word. n Selected row drives/senses bit lines in columns. n Amplifiers/drivers read/write bit lines.

18. FPGA-Based System Design: Chapter 3 Copyright  2004 Prentice Hall PTR Read-only memory (ROM) n ROM core is organized as NOR gates— pulldown transistors of NOR determine programming. n Mask-programmable ROM uses pulldowns to determine ROM contents.

19. FPGA-Based System Design: Chapter 3 Copyright  2004 Prentice Hall PTR Flash memory n Flash: electrically erasable PROM that can be programmed with standard voltages. n Uses dual capacitor structure. n Available in some digital processes for integrated memory, but raises the price of the manufacturing process.

20. FPGA-Based System Design: Chapter 3 Copyright  2004 Prentice Hall PTR ROM core circuit

21. FPGA-Based System Design: Chapter 3 Copyright  2004 Prentice Hall PTR SRAM critical path core Sense amp

22. FPGA-Based System Design: Chapter 3 Copyright  2004 Prentice Hall PTR Row decoders n Decode row using NORs:

23. FPGA-Based System Design: Chapter 3 Copyright  2004 Prentice Hall PTR Static RAM (SRAM) n Core cell uses six-transistor circuit to store value. n Value is stored symmetrically—both true and complement are stored on cross- coupled transistors. n SRAM retains value as long as power is applied to circuit.

24. FPGA-Based System Design: Chapter 3 Copyright  2004 Prentice Hall PTR SRAM core cell

25. FPGA-Based System Design: Chapter 3 Copyright  2004 Prentice Hall PTR SRAM core operation n Read: –precharge bit and bit’ high; –set select line high from row decoder; –one bit line will be pulled down. n Write: –set bit/bit’ to desired (complementary) values; –set select line high; –drive on bit lines will flip state if necessary.

26. FPGA-Based System Design: Chapter 3 Copyright  2004 Prentice Hall PTR SRAM sense amp

27. FPGA-Based System Design: Chapter 3 Copyright  2004 Prentice Hall PTR Sense amp operation n Differential pair—takes advantage of complementarity of bit lines. n When one bit line goes low, that arm of diff pair reduces its current, causing compensating increase in current in other arm. n Sense amp can be cross-coupled to increase speed.

28. FPGA-Based System Design: Chapter 3 Copyright  2004 Prentice Hall PTR 3-transistor dynamic RAM (DRAM) n First form of DRAM—modern commercial DRAMs use one-transistor cell. n 3-transistor cell can easily be made with a digital process. n Dynamic RAM loses value due to charge leakage—must be refreshed.

29. FPGA-Based System Design: Chapter 3 Copyright  2004 Prentice Hall PTR 3-T DRAM core cell

30. FPGA-Based System Design: Chapter 3 Copyright  2004 Prentice Hall PTR 1-T RAM n 1 transistor + 1 capacitor: bit word

31. FPGA-Based System Design: Chapter 3 Copyright  2004 Prentice Hall PTR 1-T DRAM with trench capacitor

32. FPGA-Based System Design: Chapter 3 Copyright  2004 Prentice Hall PTR 1-T DRAM with stacked capacitor

33. FPGA-Based System Design: Chapter 3 Copyright  2004 Prentice Hall PTR Embedded DRAM n Embedded DRAM is integrated with logic. n DRAM and logic processes are hard to make compatible. –Capacitor requires high temperatures that destroy fine-line transistors. n Embedded DRAM is less dense than commodity DRAM.

34. FPGA-Based System Design: Chapter 3 Copyright  2004 Prentice Hall PTR 3-T DRAM operation n Value is stored on gate capacitance of t 1. n Read: –read = 1, write = 0, read_data’ is precharged; –t 1 will pull down read_data’ if 1 is stored. n Write: –read = 0, write = 1, write_data = value; –guard transistor writes value onto gate capacitance. n Cannot support full connectivity between all data path elements—must choose number of transfers per cycle allowed. n A bus circuit is a specialized multiplexer circuit. n Two major choices: pseudo-nMOS, precharged.