1. BCT 480 Hazard Recognition Site Report Date Submitted: 11-15-04
Student XXX
BCT 480
Hazard Recognition Site Report
Date Submitted:

2. Subpart M – Fall Protection
Non-compliance of fall protection
Unprotected sides or edges higher than 6 ft or more above a floor level shall be protected from falling by the use of guardrail systems or personal fall arrest systems
Source: National Institute for Occupational Safety and Health

3. Subpart X – Stairways and Ladders
Non-compliance of the ladder
The top or the top step of a stepladder shall not be used as a step
Cross bracing on the rear section of stepladder shall not be used for climbing on both front and rear sections
Source: OSHA

4. Subpart L - Scaffolds 1926 . 451 (g) (4) (ii)
Non-compliance of bridging scaffolds
When two or more scaffolds are used they shall not be bridged to one or another unless designed to be
Source: OSHA

5. Subpart G - Signs, Signals, and Barricades
Non-compliance of signaling and barricades
Signaling by a flagman and the use of flaggers including warning garments worn by flaggers shall conform to part VI of the manual on uniform traffic devices
Barricades for protection devices shall conform to part VI of the manual on uniform control devices
Source: National Institute for Occupational Safety and Health

6. Subpart T - Demolition 1926.852 (b) (c) Compliance of disposal chute
All material chutes need to be set at an angle of more than 45 degrees from the horizontal opening
The opening shall not exceed 48 inches in height measured along the chute
Source: GAP