1. Introduction to Microwave Remote sensing

2. Questions asked Module - III
Explain air borne and space borne sensors
Describe advantages and disadvantages of air borne sensors
Describe imaging with microwave radar
Explain Synthetic Aperture Radar(SAR)
Define swath, explain the concept of orbital calendar
Give advantages and disadvantages of air borne sensors

3. Electromagnetic Spectrum

4. Microwave Remote Sensing
Microwave remote sensing employing microwave radiation using wavelengths that range from about 1mm to 1m, in frequency interval from 40,000 Hz to 300MHz enables observation in all weather condition without any restriction by cloud or rain

5. Recap: passive and active RS
Passive: uses natural energy, either reflected sunlight (solar energy) or emitted thermal or microwave radiation.
Active: sensor creates its own energy
Transmitted toward Earth or other targets
Interacts with atmosphere and/or surface
Reflects back toward sensor (backscatter)
Advantages: all weathers and all times
Compare to flash vs. ambient light photography

6. RADAR
RADAR is the most commonly used space-based active sensing system. It is an acronym for RAdio Detection And Ranging.
Passive Active

7. Widely used active RS systems
RADAR: RAdio Detection And Ranging
Long-wavelength microwaves (1 – 100 cm)
LIDAR: LIght Detection And Ranging
Short-wavelength laser light (UV, visible, near IR)
SONAR: SOund Navigation And Ranging: (very long wave, low Hz)
Sound can not travel through vacuum
Earth and water absorb acoustic energy far less than EMR energy
Seismic survey use small explosions, record the reflected sound
Medical imaging using ultrasound
Sound waves through a water column.
Sound waves are extremely slow (300 m/s in air, 1,530 m/s in sea-water)
Bathymetric sonar (measure water depths and changes in bottom topography )
Imaging sonar or sidescan imaging sonar (imaging the bottom topography and bottom roughness)

8. Sending and receiving a pulse of microwave radiation

9. Radar Principles
Radar measures distance by measuring time delay between the transmit and received pulse.
1 us = 150 m
1 ns = 15 cm
Radar
11/18/02
University of Kansas

10. Principle of operation of a Radar

11. Principle of operation of a Radar

12. Principle of operation of a Radar
Reflection of electromagnetic waves The electromagnetic waves are reflected if they meet an electrically leading surface. If these reflected waves are received again at the place of their origin, then that means an obstacle is in the propagation direction.
Electromagnetic energy travels through air at a constant speed, at approximately the speed of light,
This constant speed allows the determination of the distance between the reflecting objects (airplanes, ships or cars) and the radar site by measuring the running time of the transmitted pulses.
This energy normally travels through space in a straight line, and will vary only slightly because of atmospheric and weather conditions. By using of special radar antennas this energy can be focused into a desired direction. Thus the direction (in azimuth and elevation of the reflecting objects can be measured  

13. Types of radar Non imaging radar Imaging radar
Traffic police use handheld Doppler radar system determine the speed by measuring frequency shift between transmitted and return microwave signal
Plan position indicator (PPI) radars use a rotating antenna to detect targets over a circular area
Satellite-based radar altimeters (low spatial resolution but high vertical resolution)
Imaging radar
Usually high spatial resolution,
Consists of a transmitter, a receiver, one or more antennas, GPS, computers

14. Two imaging radar systems
In World War II, ground based radar was used to detect incoming planes and ships (non-imaging radar).
Non-imaging radar microwave sensors include altimeters and scatterometers
They take measurements in in one linear dimension
Radar Altimeters transmits short microwave pulses and measure the time delay to determine the distance from the sensor
Altimeters look down at nadir below the platform and measure height
Altimeters are used in aircraft to measure altitude
SLAR geometry: staying out of harms way

15. Active Sensors – Radar Altimeter
Radar altimeter is a short pulse radar used for accurate height measurements.
Ocean topography.
Glacial ice topography
Sea ice characteristics
Classification and ice edge
Vegetation
11/18/02
University of Kansas

16. Two imaging radar systems
Scatterometers are non-imagery sensors and are used to measure amount of energy backscattered from the targets
Backscattered energy depends upon surface properties (roughness) and direction at which microwave energy strikes the target
Application as tool to characterize different materials and surface types and measurements over ocean surfaces
SLAR geometry: staying out of harms way

17. Two imaging radar systems
Imaging RADAR was not developed until the 1950s (after World War II). Since then, side-looking airborne radar (SLAR) has been used to get detailed images of enemy sites along the edge of the flight field.
SLAR is usually a real aperture radar. The longer the antenna (but there is limitation), the better the spatial resolution
Advantage – all weather see through capability and day and night imaging
SLAR geometry: staying out of harms way

18. Two imaging radar systems
Real aperture radar (RAR)
Aperture means antenna
A fixed length (for example: m)
Synthetic aperture radar (SAR)
1m (11m) antenna can be synthesized electronically into a 600m (15 km) synthetic length.
Most (air-, space-borne) radar systems now use SAR.
SLAR geometry: staying out of harms way

19. 1. RAR: Principle of SLAR
waveform

20. Early airborne RADAR was Side Looking Airborne Radar SLAR)
Geometry of a side-looking airborne RADAR system.
Resolution depended on the size of the antenna
Adapted from Lillesand and Kiefer (1987)

21. Q: Describe imaging with microwave radar
Radar is a ranging and distance measuring device. It has following components
Pulse Generators: Which discharges timed pulses of microwave /radio energy
The pulse of electromagnetic radiation sent out by transmitter through the antenna is of specific wavelength and duration
Transmitter: Which generates successive short bursts
(or pulses of microwave) at regular intervals

22. Block Diagram of Radar

23. Q: Describe imaging with microwave radar Refer page 166, Bhatta
Radar is a ranging and distance measuring device. It has following components
Pulse Generators: Which discharges timed pulses of microwave /radio energy
The pulse of electromagnetic radiation sent out by transmitter through the antenna is of specific wavelength and duration

24. Pulse Generators

25. Q: Describe imaging with microwave radar Refer page 166, Bhatta
Duplexer: Which carefully coordinates when microwave energy is transmitted or received
Directional antenna: Which shapes and focuses each pulse into a stream
Receiver antenna: Picks up returned pulses and sends to a converter for conversion in to video signals
Recording device: Which stores the information digitally for later processing
CRT monitor: Which produces a real time display on it.

26. System Parameters of RADAR
Frequency/wavelength
Polarization
Viewing geometry
Spatial resolution
Speckle (disfigure)

27. Terrain parameters of RADAR
Surface geometry
Surface roughness
Dielectric properties

28. Frequency/wavelength
The wavelengths used in Radar is much longer
Microwave energy is measured in centimeters
The usual name are K, Ka, Ku, X, C,S, L and P
They are described by names for the purpose of secrecy
In world war –II, radar was used for tracking aircrafts and ships
Nowadays used for marine navigation and air traffic control
Wave lengths of 3cm will be reflected from tree tops where as wavelength of 24 cm penetrate up to ground
Prime use in displaying topography

29. Microwaves Band Designations
(common wavelengths Wavelength () Frequency ()
shown in parentheses) in cm in GHz
_______________________________________________
Ka (0.86 cm) to 26.5
K to 18.0
Ku to 12.5
X (3.0 and 3.2 cm)
C (7.5, 6.0 cm)
S (8.0, 9.6, 12.6 cm)
L (23.5, 24.0, 25.0 cm)
P (68.0 cm)
Band names are relic of original military “top secret” codenames

30. Polarization in Radar Imaging

31. Polarization
Unpolarized energy vibrates in all possible directions perpendicular to the direction of travel.
The pulse of electromagnetic energy is filtered and sent out by the antenna may be vertically or horizontally polarized.
The pulse of energy received by the antenna may be vertically or horizontally polarized
VV, HH – like-polarized imagery
VH, HV- cross-polarized imagery
Use polarizing filter as a demo

32. Horizontal Polarization in Radar Imaging

33. Vertical Polarization in Radar Imaging

34. Polarization in Radar Imaging
Polarization means orientation of electric field
Polarization has an effect on nature and magnitude of backscatter
4 combinations of both transmit and receive polarizations are;
HH- for horizontal transmit and horizontal receive
VV- for vertical transmit and vertical receive
HV- for horizontal transmit and vertical receive
VH- for vertical transmit and horizontal receive

35. Viewing Geometry
In radar system the platform travels forward in flight direction
Nadir is directly beneath the platform
The microwave beam is transmitted obliquely at right angle to the direction of flight with a swath
Swath width : then linear ground distance in the across-track direction which is covered by a sensor on a single overpass

36. Radar Geometry Radar Nomenclature
• nadir: point on the ground vertically beneath the center of camera lens
• azimuth (or flight) direction
• look (or range) direction: direction in which pulses of microwave energy are transmitted
• range (near, middle, and far)
• depression angle ()
• incidence angle ()
• altitude above-ground-level, H
• polarization
Azimuth flight direction
Look/Range direction
Ask students to identify relevant angles
Flightline groundtrack 
Near range
Far range

37. Spatial resolution of Radar System

38. Speckle
Speckle are a form of noise which degrades the quality of image and makes interpretation more difficult
Using SAR, we can get high spatial resolution in the azimuth dimension (direction). But the coherently recording returned echoes (SAR) also causes speckle noise.
By modeling the noise, we can remove them

39. Speckle Grainy salt-and-pepper pattern in radar imagery
Caused by coherent nature of the radar wave, which causes random constructive and destructive interference, and hence random bright and dark areas in a radar image
Reduced by multiple looks
processing separate portions of an aperture and recombining these portions so that interference does not occur

40. Surface Roughness
The surface roughness of a feature controls surface scattering
The way in which the energy interacts with the particular surface and this is dominant factor on tones seen on a radar image

41. wrong

42. Scattering Mechanisms
Synthetic Aperture Radar – Systems and Signal Processing
Scattering Mechanisms

43. Add description from Bhatta on Scattering and surface roughness

44. Dielectric Properties
Dielectric substance is highly resistant to the flow of electric energy
Presence or absence of moisture affects the electrical properties of an object. These change in properties influence the change in absorption, transmission and reflection of microwave energy

45. Slant-range vs. Ground-range geometry
Radar imagery has a different geometry than that produced by most conventional remote sensor systems, such as cameras, multispectral scanners or area-array detectors. Therefore, one must be very careful when attempting to make radargrammetric measurements.
• Uncorrected radar imagery is displayed in what is called slant-range geometry, i.e., it is based on the actual distance from the radar to each of the respective features in the scene.
• It is possible to convert the slant-range display into the true ground-range display on the x-axis so that features in the scene are in their proper planimetric (x,y) position relative to one another in the final radar image.

46. Synthetic Aperture Radar.
C.C.Tscherning, Nov. 2007

47. Synthetic Aperture Radar (SAR) removes the need for a long antenna

48. 2. SAR
A major advance in radar remote sensing has been the improvement in azimuth resolution through the development of synthetic aperture radar (SAR) systems. Great improvement in azimuth resolution could be realized if a longer antenna were used. Engineers have developed procedures to synthesize a very long antenna electronically. Like a brute force or real aperture radar, a synthetic aperture radar also uses a relatively small antenna (e.g., 1 m) that sends out a relatively broad beam perpendicular to the aircraft. The major difference is that a greater number of additional beams are sent toward the object. Doppler principles are then used to monitor the returns from all these additional microwave pulses to synthesize the azimuth resolution to become one very narrow beam.

49. Azimuth resolution is constant = D/2, it is independent of the slant range distance,  , and the platform altitude. So the same SAR system in a aircraft and in a spacecraft should have the same resolution. There is no other remote sensing system with this capability.

50. Synthetic Aperture Radars were developed as a means of overcoming the limitations of real aperture radars.
These systems achieve good azimuth resolution that is independent of the slant range to the target, yet use small antennae and relatively long wavelengths to do it

51. SAR Principle A synthetic aperture is produced by using the forward motion of the radar. As it passes a given scatterer, many pulses are reflected in sequence. By recording and then combining these individuals signals, a "synthetic aperture" is created in the computer providing a much improved azimuth resolution

53. Real Aperture Radar
A narrow beam of energy is directed perpendicularly to the flight path of the carrier platform (aircraft or spacecraft).
A pulse of energy is transmitted from the radar antenna, and the relative intensity of the reflections is used to produce an image of a narrow strip of terrain.
Reflections from larger ranges arrive back at the radar after proportionately larger time, which becomes the range direction in the image.
When the next pulse is transmitted, the radar will have moved forward a small distance and a slightly different strip of terrain will be imaged.

54. Real Aperture Radar

55. RAR
These sequential strips of terrain will then be recorded side by side to build up the azimuth direction. The image consists of the two dimensional data array.
In this figure, the strip of terrain to be imaged is from point A to point B. Point A being nearest to the nadir point is said to lie at near range and point B, being furthest, is said to lie at far range.

56. RAR The distance between A and B defines the swath width.
The distance between any point within the swath and the radar is called its slant range.
Ground range for any point within the swath is its distance from the nadir point (point on the ground directly underneath the radar).