1. Sustainable Energy

2. Outline
Conservation
Cogeneration
Tapping Solar Energy
Passive vs. Active
High Temperature Solar Energy
Photovoltaic Cells
Fuel Cells
Energy From Biomass
Energy From Earth’s Forces

3. CONSERVATION
Utilization Efficiencies
Today’s average new home uses half the fuel required in a house built in 1974.
Reducing air infiltration is usually the cheapest, quickest, and most effective way of saving household energy.
According to new national standards:
New washing machines will have to use 35% less water in 2007.
Will cut U.S. water use by 40 trillion liters annually.

4. Utilization Efficiencies
For even greater savings, new houses can be built with extra thick superinsulated walls, air-to-air heat exchangers, and double-walled sections.
Straw-bale construction
Home orientation

5. Energy Conversion Efficiencies
Energy Efficiency is a measure of energy produced compared to energy consumed.
Thermal conversion machines can turn no more than 40% of energy in primary fuel into electricity or mechanical power due to waste heat.
Fuel cells can theoretically approach 80% efficiency using hydrogen or methane.

6. Energy Conversion Efficiencies
Transportation
Most potential energy in fuel is lost as waste heat.
In response to 1970’s oil prices, average U.S. automobile gas-mileage increased from 13.3 mpg in 1973 to 25.9 mpg in 1988.
Falling fuel prices of the 1990’s discouraged further conservation.

7. Energy Conversion Efficiencies
Transportation
By 2002, the average fuel economy of America’s passenger fleet had dropped to 20.4 mpg, the lowest since 1980.
Most decrease due to SUVs and light trucks.
Hybrid gasoline-electric vehicles have the highest efficiency rating and lowest emissions available in the United States.

8. Energy Conversion Efficiencies
Net Energy Yield - Based on total useful energy produced during the lifetime of an entire energy system minus the energy required to make useful energy available.
Expressed as ratio between output of useful energy and energy costs.

9. Negawatt Programs
It is much less expensive to finance conservation projects than to build new power plants.
Power companies investing in negawatts of demand avoidance.
Conservation costs on average $350/kw
Nuclear Power Plant: $3,000 - $8,000/kw
Coal Power Plant: $1,000/kw

10. Cogeneration
Cogeneration - Simultaneous production of both electricity and steam, or hot water, in the same plant.
Increases net energy yield from 30-35% to 80-90%.
In 1900, half of electricity generated in U.S. came from plants also providing industrial steam or district heating.
By 1970’s cogeneration had fallen to less than 5% of our power supplies.

11. TAPPING SOLAR ENERGY
A Vast Resource
Average amount of solar energy arriving on top of the atmosphere is 1,330 watts per square meter.
Amount reaching the earth’s surface is 10,000 times more than all commercial energy used annually.
Until recently, this energy source has been too diffuse and low intensity to capitalize for electricity.

12. Solar Energy
Passive Solar Heat - Using absorptive structures with no moving parts to gather and hold heat.
Greenhouse Design
Active Solar Heat - Generally pump heat- absorbing medium through a collector, rather than passively collecting heat in a stationary object.
Water heating consumes 15% of U.S. domestic energy budget.

13. HIGH TEMPERATURE SOLAR ENERGY
Parabolic mirrors are curved reflective surfaces that collect light and focus it onto a concentrated point. Two techniques:
Long curved mirrors focused on a central tube containing a heat-absorbing fluid.
Small mirrors arranged in concentric rings around a tall central tower track the sun and focus light on a heat absorber on top of the tower where molten salt is heated to drive a steam-turbine electric generator.

14. Parabolic Mirrors

15. Promoting Renewable Energy
Proposed Energy Conservation Policies:
Distributional Surcharges
Small fee levied on all utility customers.
Renewable Portfolio
Suppliers must get minimum percentage of power from renewable sources.
Green Pricing
Allows utilities to profit from conservation programs and charge premium prices for renewable energy.

16. Photovoltaic Solar Energy
Photovoltaic cells capture solar energy and convert it directly to electrical current by separating electrons from parent atoms and accelerating them across a one-way electrostatic barrier.
Bell Laboratories
$2,000 / watt
$100 / watt
$5 / watt

17. Photovoltaic Cells
During the past 25 years, efficiency of energy capture by photovoltaic cells has increased from less than 1% of incident light to more than 10% in field conditions, and over 75% in the laboratory.
Invention of amorphous silicon collectors has allowed production of lightweight, cheaper cells.
Currently $700 million annual market.

18. Storing Electrical Energy
Electrical energy storage is difficult and expensive.
Lead-acid batteries are heavy and have low energy density.
Metal-gas batteries are inexpensive and have high energy densities, but short lives.
Alkali-metal batteries have high storage capacity, but are more expensive.
Lithium batteries have very long lives, and store large amounts of energy, but are very expensive.

19. FUEL CELLS
Fuel Cells - Use on-going electrochemical reactions to produce electric current.
Positive electrode (cathode) and negative electrode (anode) separated by electrolyte which allows charged atoms to pass, but is impermeable to electrons.
Electrons pass through external circuit, and generate electrical current.

20. Fuel Cells
Fuel cells provide direct-current electricity as long as supplied with hydrogen and oxygen.
Hydrogen can be supplied as pure gas, or a reformer can be used to strip hydrogen from other fuels.
Fuel cells run on pure oxygen and hydrogen produce no waste products except drinkable water and radiant heat.
Reformer releases some pollutants, but far below conventional fuel levels.

22. Fuel Cells
Typical fuel cell efficiency is 40-45%.
Current is proportional to the size of the electrodes, while voltage is limited to about 1.23 volts/cell.
Fuel cells can be stacked together until the desired power level is achieved.

23. Fuel Cell Types
Proton Exchange Membrane - Design being developed for use in automobiles.
Lightweight and operate at low temps.
Efficiency typically less than 40%.
Phosphoric Acid - Most common fuel design for stationary electrical generation.

24. Fuel Cell Types
Carbonite - Uses inexpensive nickel catalyst, and operates at 650o C.
Good heat cogeneration, but difficult to operate due to the extreme heat.
Solid Oxide - Uses coated zirconium ceramic as electrolyte.
High operating temperatures, but highest efficiency of any design.
Still in experimental stage.

25. ENERGY FROM BIOMASS
Plants capture about 0.1% of all solar energy that reaches the earth’s surface.
About half the energy used in metabolism.
Useful biomass production estimated at times the amount currently obtained from all commercial energy sources.
Renewable energy resources account for 18% of total world energy use, and biomass makes up three-quarters of that supply.

26. Burning Biomass
Wood provides less than 1% of US energy, but provides up to 95% in poorer countries.
1,500 million cubic meters of fuelwood collected in the world annually.
Inefficient burning of wood produces smoke laden with fine ash and soot and hazardous amounts of carbon monoxide (CO) and hydrocarbons.
Produces few sulfur gases, and burns at lower temperature than coal.

27. Fuelwood Crisis
About 40% of world population depends on firewood and charcoal as their primary energy source.
Of these, three-quarters do not have an adequate supply.
Problem intensifies as less developed countries continue to grow.
For urban dwellers, the opportunity to scavenge wood is generally nonexistent.

28. Fuelwood Crisis
By 2025, worldwide demand for fuelwood is expected to be twice current harvest rates while supplies will have remained relatively static.

29. Dung
Where other fuel is in short supply, people often dry and burn animal dung.
Not returning animal dung to land as fertilizer reduces crop production and food supplies.
When burned in open fires, 90% of potential heat and most of the nutrients are lost.

30. Methane
Methane is main component of natural gas.
Produced by anaerobic decomposition.
Burning methane produced from manure provides more heat than burning dung itself, and left-over sludge from bacterial digestion is a nutrient-rich fertilizer.
Methane is clean, efficient fuel.
Municipal landfills contribute as much as 20% of annual output of methane to the atmosphere.

32. Alcohol from Biomass
Ethanol and methanol are produced by anaerobic digestion of plant materials with high sugar content.
Gasohol - mixture of gasoline and ethanol.
Ethanol in gasohol raises octane ratings and acts as a substitute for lead antiknock agents.
Ethanol production could be a solution to grain surpluses and bring a higher price for grain crops.

33. ENERGY FROM EARTH’S FORCES
Hydropower
By 1925, falling water generated 40% of world’s electric power.
Hydroelectric production capacity has grown 15-fold.
Fossil fuel use has risen so rapidly that currently, hydroelectric only supplies one-quarter of electrical generation.

34. Hydropower
Total world hydropower potential estimated about 3,000 terrawatt hours.
Only 20% of total electrical generation.
Much of recent hydropower development has been in very large dams.

35. Dam Drawbacks
Human Displacement
Ecosystem Destruction
Wildlife Losses
Large-Scale Flooding Due to Dam Failures
Sedimentation
Herbicide Contamination
Evaporative Losses
Nutrient Flow Retardation

36. Dam Alternatives
Low-Head Hydropower - Extract energy from small headwater dams.
Run-of-River Flow - Submerged directly in stream and usually do not require dam or diversion structure.
Micro-Hyrdo Generators - Small versions designed to supply power to single homes.

37. Wind Energy
Estimated 20 million MW of wind power could be commercially tapped worldwide.
Ten times total current global electrical generating capacity.
Typically operate at 35% efficiency under field conditions.
When conditions are favorable electric prices typically run as low as 3 cents / KWH.

38. Wind Energy
Wind Farms - Large concentrations of wind generators producing commercial electricity.
Negative Impacts:
Interrupt view in remote places.
Destroy sense of isolation.
Potential bird kills.

39. Geothermal Energy
High-pressure, high-temperature steam fields exist below the earth’s surface.
Recently, geothermal energy has been used in electric power production, industrial processing, space heating, agriculture, and aquaculture.
Have long life span, no mining needs, and little waste disposal.
Potential danger of noxious gases and noise problems from steam valves.

40. Tidal and Wave Energy
Ocean tides and waves contain enormous amounts of energy that can be harnessed.
Tidal Station - Tide flows through turbines, creating electricity.
Requires a high tide / low-tide differential of several meters.
Main worries are saltwater flooding behind the dam and heavy siltation.
Stormy coasts with strongest waves are often far from major population centers.

42. Ocean Thermal Electric Conversion
Heat from sun-warmed upper ocean layers is used to evaporate a working fluid, such as ammonia, which has a low boiling point.
Gas pressure spins electrical turbines.
Need temperature differential of about 20o C between warm upper layers and cooling water.

43. WHATS OUR ENERGY FUTURE ?

44. Summary
Conservation
Cogeneration
Tapping Solar Energy
Passive vs. Active
High Temperature Solar Energy
Photovoltaic Cells
Fuel Cells
Energy From Biomass
Energy From Earth’s Forces