1. ALTTC BSNL

2.  Until IPv6 completely supplants IPv4, which is not likely to happen in the foreseeable future, a number of so-called transition mechanisms are needed  To enable IPv6-only hosts to reach IPv4 services  To allow isolated IPv6 hosts and networks to reach the IPv6 Internet over the IPv4 infrastructure

3.  IPv4-only node  Implements only IPv4 & is assigned IPv4 addresses  Doesn’t support IPv6  IPv6-only node  Implements only IPv6 & is assigned only IPv6 addresses.  Able to communicate with IPv6 only node & IPv6 enabled applications.  IPv6/IPv4 node  Implements both IPv4 & IPv6 & is assigned both IPv4 & IPv6 addresses.

4. IPv6 A wide range of technique have been identified & implemented, basically falling into three categories. (1) Dual- Stack techniques allows IPv4 & IPv6 to coexist in the same device & network (2) Tunneling techniques allows IPv6 host to communicate over IPv4 infrastructure. (3) Translation techniqes to allow IPv6 only devices to communicate with IPv4 only devices

5. IPv6  No fixed day to convert; no need to convert all at once.  Transition Options:  Dual Stack  IPv6-IPv4 Tunnel  Translation (IPv4- only to IPv4- only) IPv4 IPv6 DRIVER APPLICATION TCP/UDP IPv4 IPv6 IPv6 Network IPv4 IPv6 Network Tunnel IPv4 Network IPv6 Network Translator

6. IPv6 This allows all the end hosts and intermediate network devices (like routers, switches, modems etc.) to have both IPv4 and IPv6 addresses and protocol stack. If both the end stations support IPv6, they can communicate using IPv6; otherwise they will communicate using IPv4. This will allow both IPv4 and IPv6 to coexist and slow transition from IPv4 to IPv6 can happen.

7. Dual stack is an integration method in which a node has implementation and connectivity to both an IPv4 and IPv6 network. IPv6 IPv4

8. When both IPv4 and IPv6 are configured on an interface, the interface is considered dual-stacked. IPv4: 192.168.99.1 IPv6: 3ffe:b00:c18:1::3

9. ALTTC Dual Stack Router Connectivity 2001:4490:d930::500 IPv6 camera LAN Pool 2001:4490:d930::/64 Alttc6.bsnl.co.in Web Server 2001:4490:d930::501 210.212.90.6

10. In order to reach the IPv6 Internet, an isolated host or network must be able to use the existing IPv4 infrastructure to carry IPv6 packets. This is done using a technique known as tunnellingtunnelling This allows encapsulating IPv6 packets in IPv4 packets so that IPv6 packet can be sent over an IPv4 only network. This will allow IPv6 only end stations to communicate over IPv4 only networks.

11. IPv6 Header Extension Headers Upper Layer Protocol Data Unit IPv6 Header Extension Headers Upper Layer Protocol Data Unit IPv4 Header IPv6 Packet IPv4 Packet

12. Tunnel

13.  IPv6 node A sends packet to IPv6 node B – Routed internally to router A  Router A sees destination network B is reachable over tunnel interface – Encapsulates IPv6 packet in IPv4 packet(s) –Sends resulting IPv4 packet(s) to router B –Delivered over existing IPv4 Internet infrastructure  Router B decapsulates IPv6 packet from payload of received IPv4 packet –Packet routed internally in network B to node B –Node B receives the IPv6 packet

14. Tunneling is an integration method in which an IPv6 packet is encapsulated within another protocol, such as IPv4. This method of encapsulation is IPv4.  Includes a 20-byte IPv4 header with no options and an IPv6 header and payload  Requires dual-stack routers IPv6 IPv4 IPv6

15.  Router-to-Router  Host-to-Router and Router-to-Host  Host-to-Host

16. IPv4 or IPv6 Infrastructure IPv4 Infrastructure IPv6 over IPv4 Tunnel IPv6/IPv4 Router IPv6 Node IPv6 Node IPv4 or IPv6 Infrastructure In the router-to-router tunneling configuration, two IPv6/IPv4 routers connect two IPv6-enabled infrastructures over an IPv4-only infrastructure

17. IPv4 Infrastructure IPv6/IPv4IPv6 IPv6/IPv4 Router IPv6 over IPv4 Tunnel Node A Node B IPv4 or IPv6 Infrastructure In the host-to-router tunneling configuration, an IPv6/IPv4 host that resides within an IPv4-only infrastructure uses an IPv6-over- IPv4 tunnel to reach an IPv6/IPv4 router.

18. IPv4 Infrastructure IPv6/IPv4 Node IPv6/IPv4 Node IPv6 over IPv4 Tunnel In the host-to-host tunneling configuration, an IPv6/IPv4 node that resides within an IPv4 only infrastructure uses an IPv6-over-IPv4 tunnel to reach another IPv6/IPv4 node that resides within the same IPv4-only infrastructure.

19. Two Types of Tunneling  Configured:  Automatic  6to4 (RFC 3056)  ISATAP  Teredo

20.  Configured  Require manual configuration at both ends  Very easy to setup & configure  Good from a management prospective  ISP configure all tunnels so is in control of its deployment  Manual tunnel do not scale well as it requires separate tunnel configuration for each isolated Ipv6 network destination

21. Configured A configured tunnels require manual configuration of the local & remote tunnel end points Dual stack end points Both IPv4 & IPv6 addresses configured at each end

22.  Automatic Tunnel ◦ An automatic tunnel is a tunnel is a tunnel that does not require manual configuration.Tunnel end points for automatic tunnel are determined by routing infrastructure (e.g. use of routes, tunnel interfaces, next hop address destination IPv6 addresses).Ex. ◦ Tunnels created on demand without manual intervention

23.  6to4:  Used for unicast communication between IPv6/IPv4 host & IPv6 capable sites across the IPv4 internet when 6 to 4 routers have public addresses.

24.  Fully Automatic, No administrator effort per tunnel  Tunnelled packet automatically  Route efficiently to the destination network (following best IPv4 path)  Unlike manual tunnel, 6to 4 tunnels are not point to point, they are multipoint tunnels  IPv4 is embedded in the IPv6 adress to find the other end of the tunnel.  Address format is 2002:IPv4 address::

27.  ISATAP (Intra Site Automatic Tunnel Addressing Protocol)  Designed to provide IPv6 connectivity between IPv6 nodes within IPv4 based intra-network that does not have IPv6 router.  ISATAP connects dual-stack nodes, isolated within an IPv4- only network  To exchange IPv6 traffic with each other (host ISATAP)  To exchange traffic with the global IPv6 Internet  ISATAP is ideal when dual stack node are sparsely deployed in the site

28.  Teredo  Teredo is a tunneling mechanism that allows nodes located behind NAT devices to obtain global IPv6 connectivity

29.  Teredo is needed for home users with PCs with non-routable addresses  Protocol 41 tunneling not supported by many DSL modems  Protocol 41 tunneling requires routable address on PC

30.  6 to 4 Address The 6to4 address is base on the prefix ■ 2002: WWXX:YYZZ /48 ■ Where WWXX:YYZZ is the colon hexadecimal representation of a public IPv4 address (w.x.y.z) assigned to a site or host on the IPv4 Internet. An example of a 6to4 address 2002:836b:1:25:2aa:ff:fe53:ba63. In 836b:1 is the colon hexadecimal version of 131.107.0.1.

31. ISATAP  Address assignment and host-to-host, host-to-router, and router-to-host automatic tunneling technology  ISATAP addresses:  [64-bit prefix]:0:5EFE:w.x.y.z  Example of a link-local ISATAP address is fe80::5efe:192.168.4.92 ISATAP  ISATAP treats an IPv4 infrastructure as a single link  Used for unicast traffic across an IPv4 intranet

32. Teredo addresses  Teredo addresses, defined in RFC 4380, are based on the prefix 2001::/32.  Teredo address prefixes are used to create global IPv6 addresses for IPv6/IPv4 nodes that are connected to the IPv4 Internet, even when they are located behind network address translators (NATs). example of a Teredo address is 2001::ce49:7601:2cad:dfff:7c94:fffe.

33. This allows communication between IPv4 only and IPv6 only end stations. The job of the translator is to translate IPv6 packets into IPv4 packets by doing address and port translation and vice versa.

34. This allows communication between IPv4 only and IPv6 only end stations. The job of the translator is to translate IPv6 packets into IPv4 packets by doing address and port translation and vice versa. Ford ABCD:BEEF::2228:7001 Assigned pool 120.10.40/24 Marvin 120.140.160.101 1.Packet 1 Source: ABCD:BEEF::2228:7001 Port 3056 Dest: Prefix :: 120.140.160.101 Port 23 2. Packet 2 Source: 120.10.40.10 Port 1025 Dest: Prefix :: 120.140.160.101 Port 23 4.Packet 4 Source Prefix :: 120.140.160.101 Port 23 Dest: ABCD:BEEF::2228:7001 Port 3056 3. Packet 3 Source: 120.10.40.10 Port 23 Dest: Prefix :: 120.140.160.101 Port 1025 Translation

35. IPv6

36. Pace University 36  DNS must be included in transition strategy  Resolving Names: ◦ IPv4 specifies “A” records ◦ IPv6 specifies “AAAA” records  Applications should be aware of both records  Will require development update and thorough testing  Tools like “Scrubber” by Sun make it easy

37. Pace University 37 Querying DNS server

38.  Cost estimates are primarily based on likely development and deployment Scenarios.  H/w, software, services and other miscellaneous expanses.  Each organization/or user throughout the internet will incur some cost in transition  Primarily in the form of labor and capital expenditures.  Expenditure will vary greatly across and within stake holder groups depending on their existing infrastructure and IPv6 related needs.  ISPs has to incur largest transition cost.  Individual users will incur the minimum cost

39.  The type of internet use or type of service being offered by each organization  The transition mechanism that the organization intends to implement( e.g tunneling. Dual-stack, translation, or a combination).  The organization-specific infrastructure comprised of servers, routers, firewalls, billing stems and standard and customize network etc.  The level of security required during the transition.  Timing of transition.

40. Description of stakeholder groups  Infrastructure vendors,  Application vendors,  ISPs and  Internet users. ◦ Infrastructure vendors :  manufacturers of computer networking hardware (e.g., routers, firewalls, and servers) and systems software (e.g., operating system) that supply the components of computer networks. Major companies in this category include Microsoft, IBM, Juniper, Cisco, and Hewlett Packard.

41. ◦ Application vendors: include suppliers of e- mail, file transfer protocol (FTP) and Web server software, and database software, such as enterprise resource planning (ERP) and product data management (PDM) software. SAP, Oracle, and Peoplesoft are some of the largest companies in this group. ◦ ISPs are companies that provide Internet connectivity to customers, larger companies, some institutional users, and national and regional. e.g., BSNL, Tata telecommunication, AirTel, Vodafone, Idea etc. ◦ Internet users Corporate, institutional, and government organizations, independent users including small businesses and residential households.

42. StockholderRelative cost HardwaresoftwareLabor HW vendorLow10% 80% Software vendor Low /medium 10% 80% Internet user (Large) Medium10%20%70% Internet user (small) Low30%40%30% ISPsHigh15% 70% Internet users incur approximately 90 percent of IPv6 transition costs. Vendors and ISPs account for the remaining costs.

43. itemH/W, S/W & service providers ISPsEnterprise users H/W cost of replacing interfaceHigh (H)Medium (M) Router/chasis/ firewall MM Software upgradation Cost NMSHH OSMH Applications DNS, FTP etc. ERP & other applications LHLH

44. itemH/W, S/W & service providers ISPsEnterprise users labors R&DML Train Networking /IT employees HHH Designing IPv6 transition strategy MHM/H Implementation transition MM/H Others Ipv6 address blockLLL Lost employee productivity MM Security intrusionsHH Inter operability issues MM/H

45. Primary business activities of each stakeholder group that will be affected It is emphasized that all stakeholders will bear costs associated with the transition of their own internal networks from IPv4 to IPv6

46.  Cost Categories ◦ Labor resources will account for the bulk of the transition costs ◦ Memory and hardware : Some additional physical resources, such as increased memory capacity for routers and other message-forwarding hardware. ◦ These expenses are treated as negligible in the cost analysis because it is quite small compared to the labor resources required. ◦ Labor resources needed for the transition are linked to three general business activities within the Internet supply chain—product development, Internet provisioning services, and internal network operations. ◦ other cost: Additionally, several other cost categories, such as network testing and standards and protocol development, span multiple business activities and thus several take holder groups.

47.  The penetration curves represent the estimated share of infrastructure products and applications that are IPv6 capable and the share of networks that are IPv6 enabled at a given time.  This implies that costs will be distributed over time as stakeholders gradually engage in transition activities.  As networking staff are trained and the system is reconfigured.  Lower costs associated with testing and monitoring are then experienced after the enabling date.

48. The penetration curves likely deployment/adoption rates for the four major stakeholder groups. The infrastructure (Inf) and applications (App) vendors’ curves represent the path over which vendor groups will offer IPv6-capable products to customers.

49.  The penetration of IPv6 is likely to be a gradual process and will probably never reach 100 percent of applications or users.  These four curves are the key penetration metrics for the cost analysis because they capture the timing of expenditures.  For vendors, R&D expenditures to integrate IPv6 into their products are the primary expenditure category associated with the transition from IPv4 to IPv6.

51. IPv6  There is a large set of IPv6 transition tools available –No single ‘best’solution –Transition plan is likely to be site-specific  Current ‘best practice’is dual-stack deployment –Natural path via procurement cycles –Allows experience in IPv6 operation to be gained early  IPv6-only networks can be deployed