1. Visit us at www.mcscontrols.com MCS-Connect

2. l Windows® based (95 thru 7) l Software written in Java l Grid size dynamic and updated in place l Updated typically every 2 to 3 seconds l Status, Trending/Graphs, Schedules l Transmit / Receive Configurator about 60 seconds uMCS-CONNECT General Information

3. l RS232 connection @ 19,200 baud l Local Ethernet @ 100 Mbps l Built in Gateway on each MAGNUM l Transmit Software (Both.hex &.cfg) l Expanded Graphing l Edit Date / Time Information uMCS-CONNECT General Information

4. Setup Windows & Modem Timers Remote/Dialup & IP uMCS-CONNECT OPENING SCREEN Local Serial/Ethernet

5. u SETUP COMMUNICATIONS Local & Remote Com Ports Modem Commands S8=4 Timing Functions Buffer Sizes Communications Speeds

6. u Phone Number Selection Use Scroll Bar to Find Site Drop down list of site names will appear. Use scroll bar to locate correct name or type name. When name is found click on it.

7. u Phone Directory After Selecting Dialup & Site Select ‘Remote/Connect’ to Dial System

8. u Local or Remote Site By MCS Address Hardware Serial # Configurator Name Manufacturer Model Name Unit Serial # Install Date Software Version # Get Authorized Config Version Config Date

9. u Authorization Select ‘Authorization’ Type 4 digit Auth # (0 thru 9) and Press ENTER on PC

10. u Overall Status Analog Outputs Relay Outputs Notification Control Status Sensor Inputs Select Info

11. u Relay Output Status Value / Manual Status Relay Output Name Last on / off Updated top of min Run Today /Yesterday Cycles Today /Yesterday Scroll to Right & Get Total Run Hrs & Total Cycles

12. u Relay Output Status Click on Name to highlight line Every Other Line Color Alternates Drop Down Relay Output Auto, Manual, Lockout

13. u Sensor Input Status Last on/off or Min/Max Sensor Type Offset Value Manual/Auto Status Current Value Sensor input Name

14. u Sensor Input Status Drop Down to Put Sensor in ‘AUTO or MANUAL’ Set CHIL OUT Manual

15. u Put Sensor in Manual Select Sensor Name Put in Sensor Manual Value

16. u Sensor Input Status Sensor input Name Run/Cycles or Min/Max Today Sensor input Value Sensor Manual Status Sensor Offset & Type

17. u Control Status Unit status Circuit Status Temp, Superht Status LLS/EXV status Select ‘Status, Alarms, SetPoints, Reset/Clear, Schedule & Service

18. u Alarms Select from tabs Last 100 Alarms

19. u Setpoints Target ± Ctl Zone  EXV Set Points  Liquid Inj. On  Time ROC EXV

20. u Setpoints Capacity Ctl  Load Pulse Ctrl  Condenser Ctrl  Slide Capacity Ctl 

21. u Setpoints Condenser Ctrl  Amp Ctrl  Low Suct PSI Ctrl  Compressor Ctrl 

22. u Setpoints High Disc Psi Ctrl  Comp Safety Ctrl  Freeze & EXV Ctrl  High Disc Tmp Ctrl 

23. u Setpoints Target Target Adjusted with Reset Value Set Point Range Enter New Value

24. u Graph

25. u Graph Setup Relay Outputs Selected Sensor Inputs Selected Sample Interval Analog Outputs Selected Grid Control

26. l Access MCS-Connect Program l Check Communications Settings l Review Remote Phone List  Hands On Time l Local Connection to a Demo Unit