1. 2G BBULBE PASS Instructions-4 Replacement of bubble generator

2. Bubble generator

3. Instructions 1. Take off water inlet and outlet fittings 2. Deflate spa 3. Remove cord grip with screwdriver 4. Remove the air pipe

4. 5. Take out control box from spa pool 6. Remove the foam 7. Loosen the screws on the top lid 8. Remove the top lid Instructions

5. Bubble Power input Transformer input Heater Filter Transformer output 3 PIN- water switch 2 PIN - Sensor Instructions

6. 9. Disconnect the wires 10. SPA power panel 11. Remove the middle part of control box hull 12. Remove the top lid of bubble generator Instructions

7. 13. Replace the bubble generator 14. L/N wires should be separated 15. Screw back the top lid of bubble generator 16. 2 seal rings should be in good shape Instructions

8. 17. Assembly the middle part of control box hull 18. Connect the wires 19. Put on the top lid back20. Put on the foam Instructions

9. 21. Assembly the control box 22. Pull out the air pipe through spa tub 23. Connect the check valve with spa tub 24. Screw back water inlet and outlet tightly Instructions

10. Please give your valuable opinion!