1. Co2 Car Preparation.

2. Use scissors to cut out your Co2 car.

3. Co2 Car tracing. Make use to put the cutout correctly on the block. Place cutout on the Co2 car block Use a marker to trace around the cutout.

4. Wheel Location Use this tool to mark the location of the holes to be drilled. Press just hard enough to leave a mark.

5. Marked Hole This is how it should look.

6. Ready to Drill Have you passed the safety Test? Use the drill press to drill the holes for the axels.

7. Write your first and last name on the back of your Co2 car

8. Recycle Paper If you are making cuts to the top view of your car, cut out the top view and save it in your backpack or binder. After cutting out your designs, recycle your scrap paper in the blue recycle box.

9. Scissors Put the scissors you uses back where they belong.

10. Storing Your Co2 Car Make sure your name is on your Co2 car and place it in the blue cabinet at the end of class

11. Clean Up Your Area No one will be excused from class until your area is clean and tools put away.